Searched refs:driven (Results 1 – 25 of 159) sorted by relevance
1234567
| /Linux-v5.10/Documentation/devicetree/bindings/power/reset/ |
| D | gpio-restart.txt | 7 will be driven in the inactive state. Otherwise its not driven until
11 priority order. The gpio is configured as an output, and driven active,
17 is driven active again. After a delay specified by wait-delay, the
|
| /Linux-v5.10/Documentation/devicetree/bindings/display/ |
| D | truly,nt35597.txt | 20 - ports: This device has two video ports driven by two DSIs. Their connections
23 - port@0: DSI input port driven by master DSI
24 - port@1: DSI input port driven by secondary DSI
|
| D | ssd1307fb.txt | 11 - solomon,height: Height in pixel of the screen driven by the controller
12 - solomon,width: Width in pixel of the screen driven by the controller
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | tc654.rst | 32 Setting pwm1_mode to 1 will cause the pwm output to be driven based on
34 driven based on the Vin input.
|
| /Linux-v5.10/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| D | pincfg.txt | 18 0 = The pin is actively driven as an output
20 driven active-low, otherwise it is three-stated.
|
| /Linux-v5.10/Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 75 Your fan can be driven in different modes:
78 * 1: The fan can be driven in manual (use pwm1 to change the speed);
79 * 2; The fan is driven automatically depending on the temperature.
|
| /Linux-v5.10/Documentation/devicetree/bindings/input/ |
| D | gpio-matrix-keypad.txt | 1 * GPIO driven matrix keypad device tree bindings
3 GPIO driven matrix keypad is used to interface a SoC with a matrix keypad.
|
| /Linux-v5.10/Documentation/networking/ |
| D | team.rst | 7 Team devices are driven from userspace via libteam library which is here:
|
| /Linux-v5.10/Documentation/sound/soc/ |
| D | clocking.rst | 12 Every audio subsystem is driven by a master clock (sometimes referred to as MCLK
24 The Digital Audio Interface is usually driven by a Bit Clock (often referred to
|
| D | dai.rst | 15 The bit clock (BCLK) is always driven by the CODEC (usually 12.288MHz) and the
16 frame (FRAME) (usually 48kHz) is always driven by the controller. Each AC97
|
| /Linux-v5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,dove-pinctrl.txt | 64 pmu-nc Pin not driven by any PM function
65 pmu-low Pin driven low (0)
66 pmu-high Pin driven high (1)
|
| /Linux-v5.10/drivers/parport/ |
| D | BUGS-parport | 7 software-driven mode in ieee1284_ops.c
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-driver-fsi-master-gpio | 9 where the FSI bus is driven externally (for example, by
|
| /Linux-v5.10/Documentation/features/debug/stackprotector/ |
| D | arch-support.txt | 4 # description: arch supports compiler driven stack overflow protection
|
| /Linux-v5.10/fs/configfs/ |
| D | Kconfig | 3 tristate "Userspace-driven configuration filesystem"
|
| /Linux-v5.10/Documentation/driver-api/gpio/ |
| D | intro.rst | 49 options about how that value is driven, so that for example only one
50 value might be driven, supporting "wire-OR" and similar schemes for the
95 level is actually driven), or "open source" (where only the high signal level is
96 driven) signaling. That term applies to CMOS transistors; "open collector" is
|
| /Linux-v5.10/Documentation/devicetree/bindings/misc/ |
| D | xlnx,sd-fec.txt | 28 driven with a fixed value and is not present on the device, a value of 1
35 driven with a fixed value and is not present on the device, a value of 1
|
| /Linux-v5.10/arch/sh/drivers/ |
| D | Kconfig | 18 framework that allows for sysfs driven switch status reporting.
|
| /Linux-v5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | ektf2127.txt | 8 ektf2127's wake input. This needs to be driven high
|
| /Linux-v5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio-pcf857x.txt | 4 driven high by a pull-up current source or driven low to ground. This combines
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/light/ |
| D | opt3001.txt | 3 The driver supports interrupt-driven and interrupt-less operation, depending
|
| /Linux-v5.10/Documentation/devicetree/bindings/clock/ |
| D | pwm-clock.txt | 1 Binding for an external clock signal driven by a PWM pin.
|
| /Linux-v5.10/Documentation/spi/ |
| D | spi-lm70llp.rst | 22 into a SPI bus with a single device, which will be driven by the generic
71 connector. When SI/O is Low (driven by the LM70 or the host) on the other
|
| /Linux-v5.10/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxm-s912-libretech-pc.dts | 31 * Make sure the irq pin of the TYPE C controller is not driven
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | wm8994.txt | 63 - wlf,ldoena-always-driven : If present LDOENA is always driven.
|
1234567
