| /Linux-v5.10/drivers/gpu/drm/amd/amdkfd/ |
| D | kfd_interrupt.c | 150 dev_err_once(kfd_chardev(), "Ring entry too small\n"); in interrupt_wq()
|
| D | kfd_device.c | 951 dev_err_once(kfd_device, "Ring entry too small\n"); in kgd2kfd_interrupt()
|
| /Linux-v5.10/drivers/hwmon/ |
| D | raspberrypi-hwmon.c | 38 dev_err_once(data->hwmon_dev, "Failed to get throttled (%d)\n", in rpi_firmware_get_throttled()
|
| /Linux-v5.10/drivers/acpi/ |
| D | evged.c | 63 dev_err_once(event->dev, "IRQ method execution failed\n"); in acpi_ged_irq_handler()
|
| /Linux-v5.10/drivers/tty/serial/ |
| D | sifive.c | 671 dev_err_once(ssp->port.dev, "only 8-bit words supported\n"); in sifive_serial_set_termios()
673 dev_err_once(ssp->port.dev, "parity checking not supported\n"); in sifive_serial_set_termios()
675 dev_err_once(ssp->port.dev, "BREAK detection not supported\n"); in sifive_serial_set_termios()
|
| /Linux-v5.10/drivers/net/wireless/mediatek/mt7601u/ |
| D | dma.c | 97 dev_err_once(dev->dev, "Error: RXWI zero fields are set\n"); in mt7601u_rx_process_seg()
99 dev_err_once(dev->dev, "Error: RX path seen a non-pkt urb\n"); in mt7601u_rx_process_seg()
|
| /Linux-v5.10/drivers/media/i2c/ |
| D | dw9714.c | 206 dev_err_once(dev, "%s I2C failure: %d", __func__, ret); in dw9714_vcm_suspend()
|
| D | ak7375.c | 213 dev_err_once(dev, "%s I2C failure: %d\n", in ak7375_vcm_suspend()
|
| D | dw9807-vcm.c | 256 dev_err_once(dev, "%s I2C failure: %d", __func__, ret); in dw9807_vcm_suspend()
|
| /Linux-v5.10/include/linux/ |
| D | dev_printk.h | 159 #define dev_err_once(dev, fmt, ...) \ macro
|
| D | hid.h | 1193 dev_err_once(&(hid)->dev, fmt, ##__VA_ARGS__)
|
| /Linux-v5.10/drivers/rtc/ |
| D | rtc-mxc_v2.c | 64 dev_err_once(dev, "SRTC_LPSCLR stuck! Check your hw.\n"); in mxc_rtc_sync_lp_locked()
|
| /Linux-v5.10/drivers/gpu/drm/tiny/ |
| D | st7586.c | 150 dev_err_once(fb->dev->dev, "Failed to update display %d\n", ret); in st7586_fb_dirty()
|
| D | ili9225.c | 156 dev_err_once(fb->dev->dev, "Failed to update display %d\n", ret); in ili9225_fb_dirty()
|
| /Linux-v5.10/drivers/gpu/drm/omapdrm/ |
| D | omap_crtc.c | 372 dev_err_once(dev->dev, "missing display dssdev!"); in omap_crtc_manual_display_update()
378 dev_err_once(dev->dev, "missing or incorrect dssdrv!"); in omap_crtc_manual_display_update()
|
| /Linux-v5.10/drivers/gpu/drm/msm/adreno/ |
| D | adreno_device.c | 288 dev_err_once(dev->dev, "no GPU device was found\n"); in adreno_load_gpu()
|
| /Linux-v5.10/drivers/gpu/drm/amd/pm/swsmu/smu12/ |
| D | renoir_ppt.c | 782 dev_err_once(smu->adev->dev, "Unsupported power profile mode %d on RENOIR\n", profile_mode); in renoir_set_power_profile_mode()
790 dev_err_once(smu->adev->dev, "Fail to set workload type %d\n", workload_type); in renoir_set_power_profile_mode()
|
| /Linux-v5.10/kernel/dma/ |
| D | direct.c | 423 dev_err_once(dev, in dma_direct_map_resource()
|
| /Linux-v5.10/drivers/acpi/nfit/ |
| D | intel.c | 504 dev_err_once(dev, "invalid firmware activate state %d\n", in intel_bus_fwa_state()
|
| /Linux-v5.10/drivers/media/cec/platform/seco/ |
| D | seco-cec.c | 500 dev_err_once(dev, "IRQ: R/W SMBus operation failed (%d)", status); in secocec_irq_handler()
|
| /Linux-v5.10/drivers/platform/chrome/ |
| D | cros_ec_proto.c | 105 dev_err_once(ec_dev->dev, in send_command()
|
| /Linux-v5.10/sound/soc/atmel/ |
| D | mchp-i2s-mcc.c | 783 dev_err_once(dev->dev, "failed to enable GCLK: %d\n", in mchp_i2s_mcc_trigger()
|
| /Linux-v5.10/drivers/net/ethernet/amd/xgbe/ |
| D | xgbe-phy-v2.c | 1243 dev_err_once(pdata->dev, "%s: I2C error setting SFP MUX\n", in xgbe_phy_sfp_read_eeprom()
1254 dev_err_once(pdata->dev, "%s: I2C error reading SFP EEPROM\n", in xgbe_phy_sfp_read_eeprom()
1306 dev_err_once(pdata->dev, "%s: I2C error reading SFP GPIOs\n", in xgbe_phy_sfp_signals()
|
| /Linux-v5.10/drivers/staging/unisys/visorhba/ |
| D | visorhba_main.c | 948 dev_err_once(&devdata->dev->device, in drain_queue()
|
| /Linux-v5.10/drivers/scsi/cxlflash/ |
| D | ocxl_hw.c | 443 dev_err_once(dev, "%s: afu_reset() fop not supported\n", __func__); in ocxlflash_afu_reset()
|
