| /Linux-v5.10/Documentation/gpu/ |
| D | kms-properties.csv | 23 ,,"""left_margin""",RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
24 ,,"""right_margin""",RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
25 ,,"""top_margin""",RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
26 ,,"""bottom_margin""",RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
27 ,,“hpos”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
28 ,,“vpos”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
29 ,,“contrast”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
30 ,,“saturation”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
31 ,,“hue”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
32 ,,“sharpness”,RANGE,"Min=0, Max= SDVO dependent",Connector,TBD
[all …]
|
| /Linux-v5.10/Documentation/driver-api/serial/ |
| D | driver.rst | 79 Interrupts: caller dependent.
178 Interrupts: caller dependent.
235 Interrupts: caller dependent.
309 Interrupts: caller dependent.
331 Interrupts: caller dependent.
340 Interrupts: caller dependent.
348 Interrupts: caller dependent.
357 Interrupts: caller dependent.
373 Interrupts: caller dependent.
381 Interrupts: caller dependent.
[all …]
|
| /Linux-v5.10/Documentation/networking/ |
| D | tcp-thin.rst | 11 effective. In time-dependent scenarios (like online games, control
19 After analysing a large number of time-dependent interactive
39 Since these mechanisms are targeted at time-dependent applications,
|
| /Linux-v5.10/Documentation/admin-guide/ |
| D | cputopology.rst | 13 dependent.
19 architecture and platform dependent.
25 architecture and platform dependent.
31 architecture and platform dependent.
37 architecture and platform dependent.
|
| /Linux-v5.10/Documentation/driver-api/memory-devices/ |
| D | ti-emif.rst | 38 DDR device details and other board dependent and SoC dependent
|
| D | ti-gpmc.rst | 172 Many of gpmc timings are dependent on other gpmc timings (a few
173 gpmc timings purely dependent on other gpmc timings, a reason that
|
| /Linux-v5.10/Documentation/infiniband/ |
| D | opa_vnic.rst | 104 OPA VNIC functionality has a HW dependent component and a HW
112 The HW dependent VNIC functionality is part of the HFI1 driver. It
127 set by HW dependent VNIC driver where required to accommodate any control
131 interface. It also passes any control information to the HW dependent driver
|
| /Linux-v5.10/drivers/usb/gadget/function/ |
| D | u_tcm.h | 30 struct module *dependent; member
|
| /Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
| D | fsl-upm-nand.txt | 17 - fsl,upm-wait-flags : add chip-dependent short delays after running the
20 - chip-delay : chip dependent delay for transferring data from array to
|
| D | orion-nand.txt | 12 - chip-delay : Chip dependent delay for transferring data from array to read
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | pstore | 5 Description: Generic interface to platform dependent persistent storage.
24 - "mce" - architecture dependent data from fatal h/w error
|
| D | sysfs-firmware-dmi-tables | 9 size of SMBIOS entry point is dependent on SMBIOS version.
|
| /Linux-v5.10/drivers/staging/most/dim2/ |
| D | Kconfig | 12 This device driver is platform dependent and needs an additional
|
| /Linux-v5.10/Documentation/staging/ |
| D | speculation.rst | 47 More complex sequences involving multiple dependent memory accesses may
63 microarchitectural state dependent on this value. This may provide an
|
| /Linux-v5.10/arch/sh/drivers/ |
| D | Kconfig | 11 behavior is platform-dependent, but normally the flash frequency is
|
| /Linux-v5.10/arch/arm/mm/ |
| D | l2c-l2x0-resume.S | 34 @ The prefetch and power control registers are revision dependent
|
| /Linux-v5.10/Documentation/admin-guide/pm/ |
| D | suspend-flows.rst | 37 *platform-dependent suspend* states in what follows.
164 Platform-dependent Suspend Code Flow
168 state to platform-dependent suspend state:
197 which must be done in a special platform-dependent way. Then, the
233 Platform-dependent Resume Code Flow
237 platform-dependent suspend state into the working state:
|
| /Linux-v5.10/drivers/thermal/st/ |
| D | Kconfig | 27 configuration is fully dependent of MACH_STM32MP157.
|
| /Linux-v5.10/Documentation/devicetree/bindings/fsi/ |
| D | fsi-master-aspeed.txt | 11 - interrupts: platform dependent interrupt description
|
| /Linux-v5.10/Documentation/devicetree/bindings/reset/ |
| D | st,sti-softreset.txt | 9 The actual action taken when softreset is asserted is hardware dependent.
|
| D | st,sti-picophyreset.txt | 8 The actual action taken when softreset is asserted is hardware dependent.
|
| D | st,sti-powerdown.txt | 10 The actual action taken when powerdown is asserted is hardware dependent.
|
| /Linux-v5.10/Documentation/devicetree/bindings/dma/ |
| D | atmel-dma.txt | 28 dependent:
|
| /Linux-v5.10/drivers/usb/gadget/legacy/ |
| D | tcm_usb_gadget.c | 152 tcm_opts->dependent = THIS_MODULE; in usb_target_gadget_init()
|
| /Linux-v5.10/Documentation/devicetree/bindings/leds/ |
| D | leds-spi-byte.txt | 9 The value for lowest and highest brightness is dependent on the device and
|
