| /Linux-v5.10/Documentation/sound/designs/ |
| D | powersave.rst | 5 AC97 and HD-audio drivers have the automatic power-saving mode.
9 With the automatic power-saving, the driver turns off the codec power
15 The time-out for automatic power-off can be specified via ``power_save``
17 the time-out value in seconds. 0 means to disable the automatic
27 automatic power-save mode with 10 seconds, write to
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | dell-smm-hwmon.rst | 38 pwm1_enable WO Enable or disable automatic BIOS fan
46 Disabling automatic BIOS fan control
53 There is experimental support for disabling automatic BIOS fan
56 (writing ``2`` enables automatic BIOS control again). Even if you have
58 automatic fan control at the same time and, notwithstanding the name,
59 ``pwm1_enable`` sets automatic control for all fans.
62 enabling and disabling automatic BIOS fan control are not whitelisted
|
| D | adt7470.rst | 40 automatic fan pwm control to set the fan speed. The driver will not read the
51 determining an optimal configuration for the automatic PWM control.
93 order for the automatic pwm algorithm to run. This was the case for earlier
|
| D | asc7621.rst | 91 Using temperature information from these four zones, an automatic fan speed
204 to the point where the automatic thermal control circuit starts
211 2 Fan on automatic control and will run at the minimum pwm
213 3 Fan on automatic control but will be off if the
|
| D | vt1211.rst | 55 This chip also provides manual and automatic control of fan speeds (according
56 to the datasheet). The driver only supports automatic control since the manual
58 get manual mode to work at all! Be aware that automatic mode hasn't been
177 PWM controller in automatic mode. There is only a single controller that
|
| D | lm63.rst | 81 PWM modes: manual and automatic. Automatic mode is not fully implemented yet
87 but will return 'old' values. Values in the automatic fan control lookup table
|
| D | dme1737.rst | 175 1-3 can be configured to operate either in manual or automatic mode by setting
179 appropriate PWM attribute. In automatic mode, the PWM attribute returns the
183 In automatic mode, the chip supports the setting of the PWM ramp rate which
312 - 2: automatic mode
321 when the PWM is in automatic mode.
|
| D | emc6w201.rst | 22 "The EMC6W201 is an environmental monitoring device with automatic fan
|
| /Linux-v5.10/drivers/net/wireless/intersil/orinoco/ |
| D | hw.h | 30 int orinoco_get_bitratemode(int bitrate, int automatic);
31 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic);
|
| D | hw.c | 30 int automatic; member
430 int orinoco_get_bitratemode(int bitrate, int automatic) in orinoco_get_bitratemode() argument
441 (bitrate_table[i].automatic == automatic)) { in orinoco_get_bitratemode()
449 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic) in orinoco_get_ratemode_cfg() argument
454 *automatic = bitrate_table[ratemode].automatic; in orinoco_get_ratemode_cfg()
|
| /Linux-v5.10/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-rf-tuner.rst | 40 automatic mode bandwidth configuration is performed by the driver.
50 Enables/disables LNA automatic gain control (AGC)
53 Enables/disables mixer automatic gain control (AGC)
56 Enables/disables IF automatic gain control (AGC)
|
| D | ext-ctrls-camera.rst | 29 Enables automatic adjustments of the exposure time and/or iris
41 - Automatic exposure time, automatic iris aperture.
64 Determines the automatic exposure compensation, it is effective only
152 Enables continuous automatic focus adjustments. The effect of manual
162 Aborts automatic focusing started with ``V4L2_CID_AUTO_FOCUS_START``
170 The automatic focus status. This is a read-only control.
211 - Normal distance range, limited for best automatic focus
271 Sets white balance to automatic, manual or a preset. The presets
351 Enables or disables automatic ISO sensitivity adjustments.
372 This control allows to select scene programs as the camera automatic
[all …]
|
| /Linux-v5.10/net/8021q/ |
| D | Kconfig | 28 automatic propagation of registered VLANs to switches.
38 automatic propagation of registered VLANs to switches; it
|
| /Linux-v5.10/drivers/staging/unisys/Documentation/ABI/ |
| D | sysfs-platform-visorchipset | 8 s-Par's automatic installation progress screen when an error
17 Description: used to set the value of the progress bar on the s-Par automatic
27 s-Par's automatic installation progress screen. Setting this
|
| /Linux-v5.10/drivers/net/ethernet/qualcomm/emac/ |
| D | emac-ethtool.c | 174 pause->autoneg = adpt->automatic ? AUTONEG_ENABLE : AUTONEG_DISABLE; in emac_get_pauseparam()
184 adpt->automatic = pause->autoneg == AUTONEG_ENABLE; in emac_set_pauseparam()
|
| /Linux-v5.10/sound/ac97/ |
| D | Kconfig | 11 drivers which benefit from the AC97 automatic probing should "select"
|
| /Linux-v5.10/Documentation/devicetree/bindings/power/supply/ab8500/ |
| D | charger.txt | 18 Boolean value depicting the presence of 'automatic poweron after powerloss'
|
| /Linux-v5.10/Documentation/devicetree/bindings/watchdog/ |
| D | da9062-wdt.txt | 11 Only use this option if you can't use the watchdog automatic suspend
|
| /Linux-v5.10/drivers/staging/pi433/ |
| D | rf69_enum.h | 60 automatic, enumerator
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 76 automatic updating is enabled.
84 allowed to increase to a higher voltage when using VPhg automatic
89 - cirrus,vp-hg-va : VA calculation reference for automatic VPhg tracking
|
| /Linux-v5.10/drivers/net/wireless/ti/ |
| D | Kconfig | 18 # keep last for automatic dependencies
|
| /Linux-v5.10/Documentation/userspace-api/media/dvb/ |
| D | fe-set-frontend-tune-mode.rst | 35 there will be no automatic monitoring of the lock status, and
|
| /Linux-v5.10/drivers/w1/ |
| D | Kconfig | 25 either due to automatic or requested search.
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-scd30 | 9 One can compensate for sensor drift by using automatic self
|
| /Linux-v5.10/Documentation/driver-api/ |
| D | ptp.rst | 106 …- LPF settings (bandwidth, phase limiting, automatic holdover, physical layer assist (per ITU-T G.…
108 … - Lock to GNSS input, automatic switching between GNSS and user-space PHC control (optional)
|
