Searched refs:authentication (Results 1 – 25 of 61) sorted by relevance
123
| /Linux-v5.10/Documentation/arm64/ |
| D | pointer-authentication.rst | 2 Pointer authentication in AArch64 Linux
9 This document briefly describes the provision of pointer authentication
38 (APDAKey, APDBKey), and one for generic authentication (APGAKey).
49 Presence of address authentication functionality is advertised via
50 HWCAP_PACA, and generic authentication functionality via HWCAP_PACG.
60 authentication extension.
73 authentication is present, the kernel will expose the position of TTBR0
92 Pointer authentication is enabled in KVM guest when each virtual cpu is
96 these userspace flags are checked before enabling pointer authentication.
|
| D | index.rst | 21 pointer-authentication
|
| D | elf_hwcaps.rst | 164 Documentation/arm64/pointer-authentication.rst.
169 Documentation/arm64/pointer-authentication.rst.
|
| /Linux-v5.10/drivers/target/iscsi/ |
| D | iscsi_target_tpg.c | 90 tpg->tpg_attrib.authentication = 0; in iscsit_load_discovery_tpg()
212 a->authentication = TA_AUTHENTICATION; in iscsit_set_default_tpg_attribs()
324 if (tpg->tpg_attrib.authentication) { in iscsit_tpg_enable_portal_group()
584 int iscsit_ta_authentication(struct iscsi_portal_group *tpg, u32 authentication) in iscsit_ta_authentication() argument
591 if ((authentication != 1) && (authentication != 0)) { in iscsit_ta_authentication()
593 " %u, ignoring request.\n", authentication); in iscsit_ta_authentication()
604 if (authentication) { in iscsit_ta_authentication()
637 a->authentication = authentication; in iscsit_ta_authentication()
639 a->authentication ? "Enforcing" : "Disabling", tpg->tpgt); in iscsit_ta_authentication()
|
| D | iscsi_target_nego.c | 887 if (conn->tpg->tpg_attrib.authentication && in iscsi_target_handle_csg_zero()
897 if (conn->tpg->tpg_attrib.authentication && in iscsi_target_handle_csg_zero()
961 conn->tpg->tpg_attrib.authentication) { in iscsi_target_handle_csg_one()
|
| /Linux-v5.10/Documentation/filesystems/ |
| D | ubifs-authentication.rst | 33 can be used to get full data authentication at the block layer.
37 authentication for UBIFS. Since UBIFS uses fscrypt for file contents and file
38 name encryption, the authentication system could be tied into fscrypt such that
40 be possible to use UBIFS authentication without using encryption.
209 This chapter introduces UBIFS authentication which enables UBIFS to verify
216 UBIFS authentication enables detection of offline data modification. While it
221 UBIFS authentication will not protect against rollback of full flash contents.
235 UBIFS authentication does not cover attacks where an attacker is able to
236 execute code on the device after the authentication key was provided.
327 it is necessary to also add authentication information frequently to the
[all …]
|
| D | index.rst | 116 ubifs-authentication.rst
|
| D | 9p.rst | 75 names may require authentication.
134 afid security channel - used by Plan 9 authentication protocols
|
| D | ubifs.rst | 102 Passing this option makes authentication mandatory.
105 auth_hash_name= The hash algorithm used for authentication. Used for
|
| /Linux-v5.10/Documentation/security/keys/ |
| D | ecryptfs.rst | 17 FEK decryption is called authentication token and, currently, can be stored in a
25 authentication token in its payload with a FEKEK randomly generated by the
30 authentication token, which content is well known, but only the FEKEK in
|
| /Linux-v5.10/Documentation/crypto/ |
| D | userspace-if.rst | 213 system call family, the consumer must set the authentication tag size.
214 To set the authentication tag size, the caller must use the setsockopt
235 - specification of the associated authentication data (AAD) with the
265 - associated authentication data (AAD)
267 - authentication tag
269 The sizes of the AAD and the authentication tag are provided with the
279 - AEAD decryption input: AAD \|\| ciphertext \|\| authentication tag
284 - AEAD encryption output: ciphertext \|\| authentication tag
385 - ALG_SET_AEAD_AUTHSIZE -- Setting the authentication tag size for
386 AEAD ciphers. For a encryption operation, the authentication tag of
[all …]
|
| /Linux-v5.10/Documentation/networking/ |
| D | mac80211-auth-assoc-deauth.txt | 2 # This outlines the Linux authentication/association and
13 alt authentication needed (not FT)
|
| D | tls-offload.rst | 54 On the receive side if the device handled decryption and authentication
133 * crypto processing state (partial blocks, partial authentication tag, etc.)
140 crypto operations and authentication regardless of segmentation. For this
146 * partial authentication tag (all data had been seen but part of the
147 authentication tag has to be written or read from the subsequent segment)
156 The kernel stack performs record framing reserving space for the authentication
167 The device performs encryption and authentication of the record data.
168 It replaces the authentication tag and TCP checksum with correct values.
180 decryption, authentication for each record in the packet). The device leaves
221 data (to be able to insert the authentication tag) and move onto handling
[all …]
|
| D | operstates.rst | 18 a site's networking policy and configuration, an 802.1X authentication
169 - send RTM_SETLINK to set operstate to IF_OPER_UP if authentication
|
| /Linux-v5.10/net/xfrm/ |
| D | Kconfig | 81 # This option selects XFRM_ALGO along with the AH authentication algorithms that
90 # This option selects XFRM_ALGO along with the ESP encryption and authentication
|
| /Linux-v5.10/fs/ubifs/ |
| D | Kconfig | 90 bool "UBIFS authentication support"
95 Enable authentication support for UBIFS. This feature offers protection
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-thunderbolt | 189 authentication procedure is started by writing to
202 When read holds status of the last authentication
270 authentication procedure is started by writing 1 to
275 When read holds status of the last authentication
301 area and prepare the device for authentication on disconnect.
|
| /Linux-v5.10/Documentation/target/ |
| D | target-export-device | 74 echo 0 > $ISCSI_DIR/$IQN/tpgt_1/attrib/authentication
|
| /Linux-v5.10/Documentation/filesystems/nfs/ |
| D | rpc-server-gss.rst | 6 implement RPCGSS authentication in kernel RPC servers such as the NFS
9 purposes of authentication.)
|
| /Linux-v5.10/Documentation/driver-api/mmc/ |
| D | mmc-tools.rst | 29 - Program authentication key for the device.
|
| /Linux-v5.10/fs/coda/ |
| D | Kconfig | 11 replication, security model for authentication and encryption,
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/ |
| D | Kconfig | 32 Choose this option if you want to support HDCP authentication.
|
| /Linux-v5.10/security/keys/ |
| D | Kconfig | 10 This option provides support for retaining authentication tokens and
38 filesystem in which each method needs to request an authentication
|
| /Linux-v5.10/drivers/staging/greybus/ |
| D | Makefile | 8 gb-firmware-y := fw-core.o fw-download.o fw-management.o authentication.o
|
| /Linux-v5.10/fs/cifs/ |
| D | Kconfig | 93 SMB protocol but LANMAN based authentication is needed to
102 is enabled in the kernel build, LANMAN authentication will not be
120 secure Kerberos authentication is required). If unsure, say Y.
|
123
