Searched refs:absent (Results 1 – 25 of 63) sorted by relevance
123
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | alc5623.txt | 11 Register. If absent or has the value of 0, the
15 Control Register. If absent or has value 0, the
|
| D | wm8903.txt | 20 - micdet-cfg : Default register value for R6 (Mic Bias). If absent, the
24 absent, the default is 100.
27 be 5 entries long. If absent, no configuration of these registers is
|
| D | wm8962.txt | 17 If absent, the default should be the register default.
20 be 6 entries long. If absent, no configuration of these registers is
|
| D | wm8741.txt | 16 DIFF in register R8 (MODE_CONTROL_2). If absent, the default is 0, shall be:
|
| D | fsl-sai.txt | 34 first for the fifo data. If this property is absent,
61 - If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
|
| D | wm8994.txt | 44 - wlf,gpio-cfg : A list of GPIO configuration register values. If absent,
50 WM8958. If absent the register defaults will be used.
|
| D | tdm-slot.txt | 18 to specify an explicit mapping of the channels and the slots. If it's absent
|
| D | pcm512x.txt | 20 is absent the device will be configured to clock from BCLK. If pll-in
|
| D | rt5682.txt | 33 If absent, the default is 16.
|
| /Linux-v5.10/Documentation/devicetree/bindings/net/ |
| D | ibm,emac.txt | 65 - phy-address : 1 cell, optional, MDIO address of the PHY. If absent,
68 for, used if phy-address is absent. bit 0x00000001 is
70 For Axon it can be absent, though my current driver
77 operations (if absent the value is the same as
78 rx-fifo-size). For Axon, either absent or 2048.
80 operations (if absent the value is the same as
81 tx-fifo-size). For Axon, either absent or 2048.
|
| D | lpc-eth.txt | 10 absent, "rmii" is assumed.
|
| D | davinci_emac.txt | 22 If absent, davinci_emac driver defaults to 100/FULL.
|
| D | ftgmac100.txt | 19 absent, "rgmii" is assumed. Supported values are "rgmii*" and "rmii" for
|
| D | brcm,unimac-mdio.txt | 24 hardware, if absent, the default hardware values are used
|
| /Linux-v5.10/Documentation/devicetree/bindings/powerpc/opal/ |
| D | power-mgt.txt | 69 property. If the property is absent, the target residency for
76 This property is required on POWER9 and absent on POWER8.
82 required on POWER9 and absent on POWER8.
111 is an optional property on POWER8 and is absent on
118 property on POWER8 and is absent on POWER9.
|
| /Linux-v5.10/Documentation/devicetree/bindings/spi/ |
| D | spi-bcm63xx-hsspi.txt | 14 if absent.
|
| D | spi-bcm63xx.txt | 14 if absent.
|
| /Linux-v5.10/Documentation/devicetree/bindings/display/ |
| D | multi-inno,mi0283qt.txt | 13 - absent: IM=x101 3-wire 9-bit data serial interface
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-class-mtd | 107 absent, ram, rom, nor, nand, mlc-nand, dataflash, ubi, unknown
145 or exceeds this value, -EUCLEAN is returned. Otherwise, absent
170 returned, absent a hard error.
233 This attribute is absent on flash devices, so it can be used
|
| /Linux-v5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio_atmel.txt | 17 - #gpio-lines: Number of gpio if absent 32.
|
| /Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
| D | ti,am654-hbmc.txt | 15 if property is absent.
|
| /Linux-v5.10/Documentation/firmware-guide/acpi/ |
| D | extcon-intel-int3496.rst | 21 be absent or invalid)
|
| /Linux-v5.10/Documentation/driver-api/ |
| D | slimbus.rst | 84 Similarly, SLIMbus devices 'report absent' when they go down. A 'device_down'
85 callback notifies the driver when the device reports absent and its logical
|
| /Linux-v5.10/Documentation/devicetree/bindings/memory-controllers/fsl/ |
| D | ifc.txt | 21 - little-endian : If this property is absent, the big-endian mode will
|
| /Linux-v5.10/Documentation/devicetree/bindings/pmem/ |
| D | pmem-region.txt | 40 If this property is absent then the OS must assume that the region
|
123
