Searched refs:RECONNECT (Results 1 – 3 of 3) sorted by relevance
| /Linux-v5.10/Documentation/scsi/ |
| D | aha152x.rst | 29 RECONNECT allow targets to disconnect from the bus (0/1; default 1 [on])
48 - DSETUP0="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }"
51 - DSETUP1="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }"
66 …aha152x=<IOPORT>[,<IRQ>[,<SCSI-ID>[,<RECONNECT>[,<PARITY>[,<SYNCHRONOUS>[,<DELAY> [,<EXT_TRANS]]]]…
82 aha152x=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS
88 aha152x1=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS
|
| /Linux-v5.10/drivers/scsi/ |
| D | aha152x.c | 546 #define RECONNECT (HOSTDATA(shpnt)->reconnect) macro
743 RECONNECT = setup->reconnect; in aha152x_probe_one()
780 RECONNECT ? "enabled" : "disabled", in aha152x_probe_one()
1524 ADDMSGO(IDENTIFY(RECONNECT, CURRENT_SC->device->lun)); in seldo_run()
1689 if (!RECONNECT) in msgi_run()
1829 ADDMSGO(IDENTIFY(RECONNECT, CURRENT_SC->device->lun)); in msgo_init()
2818 RECONNECT ? "enabled" : "disabled"); in aha152x_show_info()
|
| /Linux-v5.10/fs/ceph/ |
| D | mds_client.c | 1731 RECONNECT, enumerator
1748 if (ev == RECONNECT) { in wake_up_session_cb()
4162 wake_up_session_caps(s, RECONNECT); in check_new_map()
|
