| /Linux-v5.10/drivers/power/supply/ |
| D | power_supply_leds.c | 34 led_trigger_event(psy->charging_full_trig, LED_FULL); in power_supply_update_bat_leds()
36 led_trigger_event(psy->full_trig, LED_FULL); in power_supply_update_bat_leds()
38 LED_FULL); in power_supply_update_bat_leds()
41 led_trigger_event(psy->charging_full_trig, LED_FULL); in power_supply_update_bat_leds()
42 led_trigger_event(psy->charging_trig, LED_FULL); in power_supply_update_bat_leds()
123 led_trigger_event(psy->online_trig, LED_FULL); in power_supply_update_gen_leds()
|
| /Linux-v5.10/net/bluetooth/ |
| D | leds.c | 25 enabled ? LED_FULL : LED_OFF); in hci_leds_update_powered()
40 led_trigger_event(bt_power_led_trigger, enabled ? LED_FULL : LED_OFF); in hci_leds_update_powered()
51 led_trigger_event(led_cdev->trigger, powered ? LED_FULL : LED_OFF); in power_activate()
|
| /Linux-v5.10/drivers/leds/trigger/ |
| D | ledtrig-transient.c | 82 (transient_data->state == LED_FULL) ? LED_OFF : LED_FULL; in transient_activate_store()
126 state = (transient_data->state == LED_FULL) ? 1 : 0; in transient_state_show()
145 transient_data->state = (state == 1) ? LED_FULL : LED_OFF; in transient_state_store()
|
| D | ledtrig-camera.c | 22 enum led_brightness brt = on ? LED_FULL : LED_OFF; in ledtrig_flash_ctrl()
30 enum led_brightness brt = on ? LED_FULL : LED_OFF; in ledtrig_torch_ctrl()
|
| D | ledtrig-cpu.c | 87 is_active ? LED_FULL : LED_OFF); in ledtrig_cpu()
91 DIV_ROUND_UP(LED_FULL * active_cpus, total_cpus)); in ledtrig_cpu()
|
| D | ledtrig-panic.c | 60 led_trigger_event(trigger, state ? LED_FULL : LED_OFF); in led_panic_blink()
|
| /Linux-v5.10/drivers/net/can/ |
| D | led.c | 28 led_trigger_event(priv->tx_led_trig, LED_FULL); in can_led_event()
29 led_trigger_event(priv->rx_led_trig, LED_FULL); in can_led_event()
30 led_trigger_event(priv->rxtx_led_trig, LED_FULL); in can_led_event()
|
| /Linux-v5.10/drivers/pwm/ |
| D | pwm-pca9685.c | 60 #define LED_FULL BIT(4) macro
146 return value & LED_FULL; in pca9685_pwm_gpio_get()
154 unsigned int on = value ? LED_FULL : 0; in pca9685_pwm_gpio_set()
292 regmap_write(pca->regmap, reg, LED_FULL); in pca9685_pwm_config()
319 regmap_write(pca->regmap, reg, LED_FULL); in pca9685_pwm_config()
384 regmap_update_bits(pca->regmap, reg, LED_FULL, 0x0); in pca9685_pwm_enable()
399 regmap_write(pca->regmap, reg, LED_FULL); in pca9685_pwm_disable()
|
| /Linux-v5.10/drivers/gpu/drm/nouveau/ |
| D | nouveau_led.c | 48 return duty * LED_FULL / div; in nouveau_led_get_brightness()
65 duty = value * div / LED_FULL; in nouveau_led_set_brightness()
|
| /Linux-v5.10/drivers/platform/x86/ |
| D | fujitsu-laptop.c | 590 if (brightness < LED_FULL) in logolamp_set()
607 return LED_FULL; in logolamp_get()
621 if (brightness >= LED_FULL) in kblamps_set()
636 brightness = LED_FULL; in kblamps_get()
646 if (brightness >= LED_FULL) in radio_led_set()
660 brightness = LED_FULL; in radio_led_get()
672 if (brightness >= LED_FULL) in eco_led_set()
686 brightness = LED_FULL; in eco_led_get()
|
| /Linux-v5.10/drivers/net/phy/ |
| D | phy_led_triggers.c | 50 LED_FULL); in phy_led_trigger_change_speed()
54 led_trigger_event(&plt->trigger, LED_FULL); in phy_led_trigger_change_speed()
|
| /Linux-v5.10/arch/mips/cobalt/ |
| D | reset.c | 37 led_trigger_event(power_off_led_trigger, LED_FULL); in cobalt_machine_halt()
|
| /Linux-v5.10/drivers/leds/ |
| D | leds-bcm6358.c | 115 led->cdev.brightness = LED_FULL; in bcm6358_led()
122 led->cdev.brightness = LED_FULL; in bcm6358_led()
|
| D | leds-rb532.c | 30 return (get_latch_u5() & LO_ULED) ? LED_FULL : LED_OFF; in rb532_led_get()
|
| D | leds-cobalt-qube.c | 32 .brightness = LED_FULL,
|
| D | leds-powernv.c | 164 return LED_FULL; in powernv_led_get()
229 powernv_led->cdev.max_brightness = LED_FULL; in powernv_led_create()
|
| D | leds-lt3593.c | 95 led_data->cdev.brightness = state ? LED_FULL : LED_OFF; in lt3593_led_probe()
|
| /Linux-v5.10/arch/arm/mach-ebsa110/ |
| D | leds.c | 36 return (reg & 0x80) ? LED_FULL : LED_OFF; in ebsa110_led_get()
|
| /Linux-v5.10/drivers/net/wireless/ralink/rt2x00/ |
| D | rt2x00leds.c | 55 brightness = ((LED_FULL / 6) * rssi) + 1; in rt2x00leds_led_quality()
64 unsigned int brightness = enabled ? LED_FULL : LED_OFF; in rt2x00led_led_simple()
|
| /Linux-v5.10/drivers/iio/light/ |
| D | cm3605.c | 240 led_trigger_event(cm3605->led, LED_FULL); in cm3605_probe()
300 led_trigger_event(cm3605->led, LED_FULL); in cm3605_pm_resume()
|
| /Linux-v5.10/Documentation/leds/ |
| D | ledtrig-transient.rst | 97 to LED_OFF and 1 maps to LED_FULL. The specified state is
101 If state = LED_FULL, when the timer runs out the state will
104 go back to LED_FULL.
127 echo 1 > state stores desired transient state LED_FULL to be
|
| /Linux-v5.10/drivers/macintosh/ |
| D | via-pmu-led.c | 60 case LED_FULL: in pmu_led_set()
|
| /Linux-v5.10/drivers/hid/ |
| D | hid-steelseries.c | 170 return (drv_data->led_state >> SRWS1_NUMBER_LEDS) ? LED_FULL : LED_OFF; in steelseries_srws1_led_all_get_brightness()
222 return value ? LED_FULL : LED_OFF; in steelseries_srws1_led_get_brightness()
|
| /Linux-v5.10/arch/arm/mach-footbridge/ |
| D | ebsa285.c | 66 return hw_led_state & led->mask ? LED_OFF : LED_FULL; in ebsa285_led_get()
|
| /Linux-v5.10/drivers/hwmon/pmbus/ |
| D | ibm-cffps.c | 377 brightness = LED_FULL; in ibm_cffps_led_brightness_set()
418 led_cdev->brightness = LED_FULL; in ibm_cffps_led_blink_set()
434 psu->led.max_brightness = LED_FULL; in ibm_cffps_create_led_class()
|
