Searched refs:wifi (Results 1 – 25 of 132) sorted by relevance
123456
| /Linux-v4.19/Documentation/devicetree/bindings/net/wireless/ |
| D | qcom,ath10k.txt | 6 * "qcom,ipq4019-wifi"
7 * "qcom,wcn3990-wifi"
13 AHB based devices (i.e. ipq4019) uses compatible string "qcom,ipq4019-wifi"
22 SNOC based devices (i.e. wcn3990) uses compatible string "qcom,wcn3990-wifi".
80 Example (to supply ipq4019 SoC wifi block details):
82 wifi0: wifi@a000000 {
83 compatible = "qcom,ipq4019-wifi";
130 Example (to supply wcn3990 SoC wifi block details):
132 wifi@18000000 {
133 compatible = "qcom,wcn3990-wifi";
|
| D | marvell-8xxx.txt | 29 - marvell,wakeup-pin : a wakeup pin number of wifi chip which will be configured
34 so that the wifi chip can wakeup host platform under certain condition.
58 mwifiex: wifi@1 {
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | kirkwood-dreamplug.dts | 27 pmx_led_wifi: pmx-led-wifi {
31 pmx_led_wifi_ap: pmx-led-wifi-ap {
92 wifi {
93 label = "dreamplug:green:wifi";
96 wifi-ap {
|
| D | kirkwood-topkick.dts | 58 pmx_led_wifi_green: pmx-led-wifi-green {
83 pmx_led_wifi_yellow: pmx-led-wifi-yellow {
144 wifi {
145 label = "topkick:green:wifi";
149 label = "topkick:yellow:wifi";
|
| D | imx6ull-colibri-wifi-eval-v3.dts | 8 #include "imx6ull-colibri-wifi.dtsi"
13 compatible = "toradex,colibri-imx6ull-wifi-eval", "fsl,imx6ull";
|
| D | bcm47094-linksys-panamera.dts | 76 wifi-disabled {
77 label = "bcm53xx:amber:wifi-disabled";
81 wifi-enabled {
82 label = "bcm53xx:white:wifi-enabled";
|
| D | sun8i-q8-common.dtsi | 48 /* Make u-boot set mac-address for wifi without an eeprom */
55 * Q8 boards use various PL# pins as wifi-en. On other boards
56 * these may be connected to a wifi module output pin. To avoid
62 /* The esp8089 needs 200 ms after driving wifi-en high */
|
| D | imx6qdl-sr-som-ti.dtsi | 53 clk_ti_wifi: ti-wifi-clock {
67 pwrseq_ti_wifi: ti-wifi-pwrseq {
96 pinctrl_microsom_ti_wifi_en: microsom-ti-wifi-en {
103 pinctrl_microsom_ti_wifi_irq: microsom-ti-wifi-irq {
|
| D | at91-gatwick.dts | 40 wifi {
41 label = "gatwick:green:wifi";
|
| D | bcm2837-rpi-3-b.dts | 27 wifi_pwrseq: wifi-pwrseq {
91 brcmf: wifi@1 {
|
| D | bcm2837-rpi-3-b-plus.dts | 32 wifi_pwrseq: wifi-pwrseq {
76 brcmf: wifi@1 {
|
| D | ls1021a-moxa-uc-8410a.dts | 93 wifi-signal0 {
99 wifi-signal1 {
105 wifi-signal2 {
|
| D | qcom-ipq4019-ap.dk01.1.dtsi | 105 wifi@a000000 {
109 wifi@a800000 {
|
| D | bcm2835-rpi-zero-w.dts | 32 wifi_pwrseq: wifi-pwrseq {
126 brcmf: wifi@1 {
|
| D | rk3288-evb-act8846.dts | 182 wifi {
183 wifi_pwr: wifi-pwr {
|
| D | sun5i-gr8-chip-pro.dts | 166 wifi_reg_on_pin_chip_pro: wifi-reg-on-pin@0 {
210 regulator-name = "vcc-wifi-1";
217 regulator-name = "vcc-wifi-2";
|
| D | bcm4709-netgear-r8000.dts | 140 wifi@0,1,0 {
169 wifi@1,4,0 {
|
| /Linux-v4.19/arch/arm64/boot/dts/allwinner/ |
| D | sun50i-a64-amarula-relic.dts | 25 wifi_pwrseq: wifi-pwrseq {
42 * Schematic shows both dldo4 and eldo1 connected for vcc-io-wifi, but
44 * 0Ohm register to vcc-io-wifi so eldo1 is used.
52 brcmf: wifi@1 {
161 regulator-name = "vcc-wifi-io";
|
| D | sun50i-h6-pine-h64.dts | 134 regulator-name = "vcc-wifi-1";
140 regulator-name = "vcc-wifi-2";
|
| /Linux-v4.19/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxbb-wetek-play2.dts | 17 wifi {
18 label = "wetek-play:wifi-status";
|
| D | meson-axg-s400.dts | 33 button-wifi {
306 /* wifi module */
327 brcmf: wifi@1 {
|
| D | meson-gxl-s905d-p231.dts | 24 brcmf: wifi@1 {
|
| D | meson-gxm-q201.dts | 24 brcmf: wifi@1 {
|
| /Linux-v4.19/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-gru-chromebook.dtsi | 167 pp3300_wifi_bt: pp3300-wifi-bt {
317 mvl_wifi: wifi@0,0 {
389 &wifi {
390 wifi_perst_l: wifi-perst-l {
|
| /Linux-v4.19/drivers/staging/rtl8723bs/ |
| D | Kconfig | 9 the wifi found on the 1st gen Intel Compute Stick, the CHIP
|
123456
