| /Linux-v4.19/drivers/ata/ |
| D | pata_artop.c | 129 u8 ultra; in artop6210_set_piomode() local
134 pci_read_config_byte(pdev, 0x54, &ultra); in artop6210_set_piomode()
135 ultra &= ~(3 << (2 * dn)); in artop6210_set_piomode()
136 pci_write_config_byte(pdev, 0x54, ultra); in artop6210_set_piomode()
182 u8 ultra; in artop6260_set_piomode() local
187 pci_read_config_byte(pdev, 0x44 + ap->port_no, &ultra); in artop6260_set_piomode()
188 ultra &= ~(7 << (4 * adev->devno)); /* One nibble per drive */ in artop6260_set_piomode()
189 pci_write_config_byte(pdev, 0x44 + ap->port_no, ultra); in artop6260_set_piomode()
208 u8 ultra; in artop6210_set_dmamode() local
218 pci_read_config_byte(pdev, 0x54, &ultra); in artop6210_set_dmamode()
[all …]
|
| D | pata_serverworks.c | 231 u8 ultra; in serverworks_set_dmamode() local
236 pci_read_config_byte(pdev, 0x56 + ap->port_no, &ultra); in serverworks_set_dmamode()
237 ultra &= ~(0x0F << (adev->devno * 4)); in serverworks_set_dmamode()
242 ultra |= (adev->dma_mode - XFER_UDMA_0) in serverworks_set_dmamode()
250 pci_write_config_byte(pdev, 0x56 + ap->port_no, ultra); in serverworks_set_dmamode()
|
| D | pata_sil680.c | 172 u16 multi, ultra; in sil680_set_dmamode() local
177 pci_read_config_word(pdev, ua, &ultra); in sil680_set_dmamode()
180 ultra &= ~0x3F; in sil680_set_dmamode()
188 ultra |= ultra_table[scsc][adev->dma_mode - XFER_UDMA_0]; in sil680_set_dmamode()
196 pci_write_config_word(pdev, ua, ultra); in sil680_set_dmamode()
|
| D | pata_ali.c | 170 …oid ali_program_modes(struct ata_port *ap, struct ata_device *adev, struct ata_timing *t, u8 ultra) in ali_program_modes() argument
195 udma |= ultra << shift; in ali_program_modes()
|
| /Linux-v4.19/drivers/ide/ |
| D | aec62xx.c | 90 u8 ultra = 0, ultra_conf = 0; in aec6210_set_mode() local
104 pci_read_config_byte(dev, 0x54, &ultra); in aec6210_set_mode()
105 tmp1 = ((0x00 << (2*drive->dn)) | (ultra & ~(3 << (2*drive->dn)))); in aec6210_set_mode()
119 u8 ultra = 0, drive_conf = 0, ultra_conf = 0; in aec6260_set_mode() local
129 pci_read_config_byte(dev, (0x44|hwif->channel), &ultra); in aec6260_set_mode()
130 tmp1 = ((0x00 << (4*unit)) | (ultra & ~(7 << (4*unit)))); in aec6260_set_mode()
|
| D | siimage.c | 306 u16 ultra = 0, multi = 0; in sil_set_dma_mode() local
318 ultra = sil_ioread16(dev, ua); in sil_set_dma_mode()
321 ultra &= ~0x3F; in sil_set_dma_mode()
328 ultra |= scsc ? ultra6[speed - XFER_UDMA_0] : in sil_set_dma_mode()
338 sil_iowrite16(dev, ultra, ua); in sil_set_dma_mode()
|
| D | alim15x3.c | 65 struct ide_timing *t, u8 ultra) in ali_program_timings() argument
76 udma |= ultra << shift; in ali_program_timings()
|
| /Linux-v4.19/lib/zstd/ |
| D | zstd_opt.h | 142 …_t *seqStorePtr, U32 litLength, const BYTE *literals, U32 offset, U32 matchLength, const int ultra) in ZSTD_getPrice() argument
152 if (!ultra && offCode >= 20) in ZSTD_getPrice()
407 …id ZSTD_compressBlock_opt_generic(ZSTD_CCtx *ctx, const void *src, size_t srcSize, const int ultra) in ZSTD_compressBlock_opt_generic() argument
463 price = ZSTD_getPrice(seqStorePtr, litlen, anchor, best_off, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
493 price = ZSTD_getPrice(seqStorePtr, litlen, anchor, matches[u].off - 1, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
575 best_off, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
577 price = ZSTD_getPrice(seqStorePtr, litlen, anchor, best_off, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
580 … price = opt[cur].price + ZSTD_getPrice(seqStorePtr, 0, NULL, best_off, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
610 matches[u].off - 1, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
612 … price = ZSTD_getPrice(seqStorePtr, litlen, anchor, matches[u].off - 1, mlen - MINMATCH, ultra); in ZSTD_compressBlock_opt_generic()
[all …]
|
| /Linux-v4.19/arch/sparc/mm/ |
| D | Makefile | 8 obj-$(CONFIG_SPARC64) += ultra.o tlb.o tsb.o gup.o
|
| /Linux-v4.19/drivers/net/ethernet/8390/ |
| D | Makefile | 17 obj-$(CONFIG_ULTRA) += smc-ultra.o 8390.o
|
| D | Kconfig | 178 operating systems. The Linux smc-ultra driver has a work-around for
183 will be called smc-ultra.
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/bridge/ |
| D | anx7814.txt | 4 The ANX7814 is an ultra-low power Full-HD (1080p60) SlimPort transmitter
|
| /Linux-v4.19/Documentation/devicetree/bindings/rtc/ |
| D | abracon,abx80x.txt | 1 Abracon ABX80X I2C ultra low power RTC/Alarm chip
|
| /Linux-v4.19/Documentation/devicetree/bindings/leds/ |
| D | leds-lm3601x.txt | 3 The LM3601X are ultra-small LED flash drivers that
|
| D | leds-lm3692x.txt | 3 The LM3692x is an ultra-compact, highly efficient,
|
| /Linux-v4.19/drivers/scsi/ |
| D | qlogicpti.c | 304 if (qpti->ultra) { in qlogicpti_set_hostdev_defaults()
352 qpti->ultra = 1; in qlogicpti_reset_hardware()
356 qpti->ultra = 0; in qlogicpti_reset_hardware()
526 qpti->ultra = 1; in qlogicpti_load_firmware()
530 qpti->ultra = 0; in qlogicpti_load_firmware()
1361 (qpti->ultra ? "Ultra" : "Fast"), in qpti_sbus_probe()
|
| D | BusLogic.h | 523 bool ultra:1; /* Byte 13 Bit 3 */ member
1018 bool ultra:1; member
|
| D | qlogicpti.h | 369 char differential, ultra, clock; member
|
| /Linux-v4.19/Documentation/driver-api/ |
| D | scsi.rst | 19 Although the old parallel (fast/wide/ultra) SCSI bus has largely fallen
291 attributes for traditional (fast/wide/ultra) SCSI busses.
336 Parallel (fast/wide/ultra) SCSI, USB, SATA, SAS, Fibre Channel,
|
| /Linux-v4.19/drivers/scsi/aic7xxx/ |
| D | aic7xxx_osm.c | 588 int ultra = 0; in ahc_linux_target_alloc() local
593 ultra = 1; in ahc_linux_target_alloc()
595 ultra = 1; in ahc_linux_target_alloc()
598 if(ultra && (flags & CFXFER) == 0x04) { in ahc_linux_target_alloc()
599 ultra = 0; in ahc_linux_target_alloc()
604 scsirate = (flags & CFXFER) | (ultra ? 0x8 : 0); in ahc_linux_target_alloc()
607 maxsync = ultra ? AHC_SYNCRATE_ULTRA : in ahc_linux_target_alloc()
|
| /Linux-v4.19/drivers/gpu/drm/bridge/ |
| D | Kconfig | 23 ANX78XX is an ultra-low Full-HD SlimPort transmitter
|
| /Linux-v4.19/drivers/atm/ |
| D | horizon.h | 388 ultra enumerator
|
| D | horizon.c | 591 const unsigned long br = test_bit(ultra, &dev->flags) ? BR_ULT : BR_HRZ; in make_rate()
1127 if (!test_bit (ultra, &dev->flags) || tx_bytes <= MAX_PIO_COUNT) { in tx_schedule()
1155 if (!test_bit (ultra, &dev->flags) || tx_bytes <= MAX_PIO_COUNT) { in tx_schedule()
2779 set_bit(ultra, &dev->flags); // NOT "|= ultra" ! in hrz_probe()
|
| /Linux-v4.19/Documentation/scsi/ |
| D | ncr53c8xx.txt | 692 ultra:n All ultra speeds enabled
693 ultra:2 Ultra2 enabled
694 ultra:1 Ultra enabled
695 ultra:0 Ultra speeds disabled
773 Some scsi boards use a 875 (ultra wide) and only supply narrow connectors.
862 ultra scsi disabled ultra:n
885 ncr53c8xx=mpar:y,spar:y,disc:y,specf:3,fsn:n,ultra:2,fsn:n,revprob:n,verb:1\
898 ncr53c8xx=mpar:y,spar:y,disc:y,specf:1,fsn:n,ultra:2,fsn:n,revprob:n,verb:1\
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | sun8i-r40-bananapi-m2-ultra.dts | 51 compatible = "sinovoip,bpi-m2-ultra", "allwinner,sun8i-r40";
|
