Searched refs:timing1 (Results 1 – 13 of 13) sorted by relevance
| /Linux-v4.19/drivers/media/pci/cx18/ |
| D | cx18-cards.c | 87 .timing1 = 0x44220e82,
134 .timing1 = 0x44220e82,
181 .timing1 = 0x23230b73,
234 .timing1 = 0x24330e84,
287 .timing1 = 0x36320966,
347 .timing1 = 0x36320966,
403 .timing1 = 0x33220953,
451 .timing1 = 0x33320a63,
500 .timing1 = 0x24220e83,
553 .timing1 = 0x24220e83,
|
| D | cx18-cards.h | 110 u32 timing1; member
|
| D | cx18-firmware.c | 338 cx18_write_reg(cx, cx->card->ddr.timing1, CX18_DDR_TIMING1); in cx18_init_memory()
|
| /Linux-v4.19/drivers/mtd/nand/raw/gpmi-nand/ |
| D | gpmi-nand.h | 102 u32 timing1; member
|
| D | gpmi-lib.c | 415 hw->timing1 = BF_GPMI_TIMING1_BUSY_TIMEOUT(busy_timeout_cycles * 4096); in gpmi_nfc_compute_timings()
456 writel(hw->timing1, gpmi_regs + HW_GPMI_TIMING1); in gpmi_nfc_apply_timings()
|
| /Linux-v4.19/drivers/i2c/busses/ |
| D | i2c-mxs.c | 121 uint32_t timing1; member
146 writel(i2c->timing1, i2c->regs + MXS_I2C_TIMING1); in mxs_i2c_reset()
758 i2c->timing1 = (low_count << 16) | xmit_count; in mxs_i2c_derive_timing()
|
| /Linux-v4.19/drivers/mtd/nand/raw/ |
| D | tango_nand.c | 100 u32 timing1; member
168 writel_relaxed(tchip->timing1, nfc->reg_base + NFC_TIMING1); in tango_select_chip()
514 tchip->timing1 = TIMING(Trdy, Textw, Twc, Twpw); in tango_set_timings()
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/panel/ |
| D | display-timing.txt | 112 timing1: timing {
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | imx51-babbage.dts | 92 native-mode = <&timing1>;
93 timing1: claawvga { label
|
| D | am335x-sbc-t335.dts | 51 timing1: dvi { /* 1024x768p60 */ label
|
| D | imx28-tx28.dts | 394 timing1: timing1 { label
|
| /Linux-v4.19/Documentation/bus-devices/ |
| D | ti-gpmc.txt | 51 [<gpmc_timing>: <peripheral timing1>, <peripheral timing2> ...]
|
| /Linux-v4.19/drivers/video/fbdev/mmp/hw/ |
| D | mmp_ctrl.h | 1051 u32 timing1; member
|
