Searched refs:tied (Results 1 – 25 of 31) sorted by relevance
12
| /Linux-v4.19/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smd.txt | 61 In turn, subnodes of the "edges" represent devices tied to SMD channels on that
69 Definition: a list of channels tied to this device, used for matching
75 "rpm" subsystem. For the "rpm" subsystem we have a device tied to the
|
| D | qcom,glink.txt | 36 Each subnode of the GLINK node represent function tied to a virtual
44 Definition: a list of channels tied to this function, used for matching
|
| D | qcom,apr.txt | 26 Each subnode of the APR node represents service tied to this apr. The name
|
| /Linux-v4.19/drivers/gpu/drm/nouveau/nvkm/engine/disp/ |
| D | vga.c | 166 u32 tied = nvkm_rd32(device, 0x001084) & 0x10000000; in nvkm_rdvgaowner() local
167 if (tied == 0) { in nvkm_rdvgaowner()
|
| /Linux-v4.19/Documentation/spi/ |
| D | spi-lm70llp | 62 collector is tied to VCC.
68 hand, the transistor is cut off and the voltage tied to it's collector is
|
| /Linux-v4.19/Documentation/virtual/kvm/arm/ |
| D | psci.txt | 11 a given guest is tied to a particular PSCI revision (unlikely), or if
|
| /Linux-v4.19/drivers/staging/wilc1000/ |
| D | Kconfig | 30 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
|
| /Linux-v4.19/Documentation/driver-api/ |
| D | device_connection.rst | 19 They are only descriptions which are not tied to either of the devices directly.
|
| /Linux-v4.19/arch/powerpc/boot/dts/ |
| D | xpedite5200.dts | 434 cle-line = <0x8>; /* CLE tied to A3 */
435 ale-line = <0x10>; /* ALE tied to A4 */
|
| D | xpedite5200_xmon.dts | 438 cle-line = <0x8>; /* CLE tied to A3 */
439 ale-line = <0x10>; /* ALE tied to A4 */
|
| D | walnut.dts | 225 /* Walnut has all 4 IRQ pins tied together per slot */
|
| D | bamboo.dts | 279 /* Bamboo has all 4 IRQ pins tied together per slot */
|
| D | ebony.dts | 316 /* Ebony has all 4 IRQ pins tied together per slot */
|
| /Linux-v4.19/Documentation/devicetree/bindings/spi/ |
| D | spi-davinci.txt | 23 lines can be tied to the interrupt controller. Set this
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | armada-388-clearfog.dtsi | 190 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| D | sun7i-a20-bananapi-m1-plus.dts | 300 /* VBUS on usb host ports are tied to DC5V and therefore always on */
|
| /Linux-v4.19/Documentation/fb/ |
| D | ep93xx-fb.txt | 123 the VIDSCRNPAGE (framebuffer physical offset) to be tied low. There is
|
| /Linux-v4.19/Documentation/media/v4l-drivers/ |
| D | cx88.rst | 116 GPIO 16(I believe) is tied to the IR port (if present).
|
| /Linux-v4.19/Documentation/devicetree/bindings/media/ |
| D | renesas,drif.txt | 21 The internal channels sharing the CLK & SYNC are tied together by their
|
| /Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
| D | aspeed-lpc.txt | 183 The UARTs present in the ASPEED SoC can have their resets tied to the reset
|
| /Linux-v4.19/Documentation/filesystems/ext4/ondisk/ |
| D | blockgroup.rst | 66 (flex\_bg). In a flex\_bg, several block groups are tied together as one
|
| /Linux-v4.19/Documentation/filesystems/ |
| D | sysfs.txt | 18 sysfs is tied inherently to the kobject infrastructure. Please read
|
| /Linux-v4.19/Documentation/block/ |
| D | data-integrity.txt | 150 Because the format of the protection data is tied to the physical
|
| /Linux-v4.19/Documentation/sysctl/ |
| D | net.txt | 354 are not tied to a specific remote address. The Tx and Rx queue sizes indicate
|
| /Linux-v4.19/Documentation/trace/ |
| D | events.rst | 342 differences and the implementation isn't currently tied to it in any
|
12
