Searched refs:see (Results 1 – 25 of 1532) sorted by relevance
12345678910>>...62
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | simple-scu-card.txt | 13 - simple-audio-card,name : see simple-audio-card.txt
14 - simple-audio-card,cpu : see simple-audio-card.txt
15 - simple-audio-card,codec : see simple-audio-card.txt
19 - simple-audio-card,format : see simple-audio-card.txt
20 - simple-audio-card,frame-master : see simple-audio-card.txt
21 - simple-audio-card,bitclock-master : see simple-audio-card.txt
22 - simple-audio-card,bitclock-inversion : see simple-audio-card.txt
23 - simple-audio-card,frame-inversion : see simple-audio-card.txt
26 - simple-audio-card,prefix : see routing
36 - sound-dai : see simple-audio-card.txt
[all …]
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/panel/ |
| D | ilitek,ili9322.txt | 14 - vcc-supply: core voltage supply, see regulator/regulator.txt
16 see regulator/regulator.txt
17 - vci-supply: voltage supply for analog parts, see regulator/regulator.txt
18 - reset-gpios: a GPIO spec for the reset pin, see gpio/gpio.txt
23 - pixelclk-active: see display/panel/display-timing.txt
24 - de-active: see display/panel/display-timing.txt
25 - hsync-active: see display/panel/display-timing.txt
26 - vsync-active: see display/panel/display-timing.txt
|
| /Linux-v4.19/Documentation/devicetree/bindings/spi/ |
| D | spi-dw.txt | 5 - #address-cells: see spi-bus.txt
6 - #size-cells: see spi-bus.txt
10 - num-cs: see spi-bus.txt
13 - cs-gpios: see spi-bus.txt
|
| D | efm32-spi.txt | 4 - #address-cells: see spi-bus.txt
5 - #size-cells: see spi-bus.txt
10 - cs-gpios: see spi-bus.txt
14 bitfield to configure the pinmux for the device, see
|
| D | spi-lantiq-ssc.txt | 5 - #address-cells: see spi-bus.txt
6 - #size-cells: see spi-bus.txt
13 - num-cs: see spi-bus.txt, set to 8 if unset
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/can/ |
| D | cc770.txt | 31 - bosch,disconnect-rx0-input : see data sheet.
33 - bosch,disconnect-rx1-input : see data sheet.
35 - bosch,disconnect-tx1-output : see data sheet.
37 - bosch,polarity-dominant : see data sheet.
39 - bosch,divide-memory-clock : see data sheet.
41 - bosch,iso-low-speed-mux : see data sheet.
|
| /Linux-v4.19/Documentation/devicetree/bindings/leds/ |
| D | leds-pca9532.txt | 17 - label: see Documentation/devicetree/bindings/leds/common.txt
18 - type: Output configuration, see dt-bindings/leds/leds-pca9532.h (default NONE)
19 - linux,default-trigger: see Documentation/devicetree/bindings/leds/common.txt
20 - default-state: see Documentation/devicetree/bindings/leds/common.txt
48 For more product information please see the link below:
|
| D | leds-gpio.txt | 10 - gpios : Should specify the LED's GPIO, see "gpios property" in
14 see Documentation/devicetree/bindings/leds/common.txt
16 see Documentation/devicetree/bindings/leds/common.txt
18 see Documentation/devicetree/bindings/leds/common.txt
25 see Documentation/devicetree/bindings/leds/common.txt
|
| D | leds-aat1290.txt | 23 node - see Documentation/devicetree/bindings/leds/common.txt.
26 - led-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
27 - flash-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
30 - flash-max-timeout-us : see Documentation/devicetree/bindings/leds/common.txt
35 - label : see Documentation/devicetree/bindings/leds/common.txt
|
| D | leds-lp8860.txt | 23 - label : see Documentation/devicetree/bindings/leds/common.txt
25 see Documentation/devicetree/bindings/leds/common.txt
44 For more product information please see the link below:
|
| /Linux-v4.19/Documentation/devicetree/bindings/media/i2c/ |
| D | adp1653.txt | 15 - led-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
19 - flash-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
20 - flash-timeout-us : see Documentation/devicetree/bindings/leds/common.txt
21 - led-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
|
| /Linux-v4.19/Documentation/devicetree/bindings/mtd/ |
| D | mxc-nand.txt | 7 - nand-bus-width: see nand.txt
8 - nand-ecc-mode: see nand.txt
9 - nand-on-flash-bbt: see nand.txt
|
| D | marvell-nand.txt | 26 - label: see partition.txt. New platforms shall omit this property.
39 - nand-rb: see nand.txt (0-1).
46 - nand-on-flash-bbt: see nand.txt.
47 - nand-ecc-mode: see nand.txt. Will use hardware ECC if not specified.
48 - nand-ecc-algo: see nand.txt. This property is essentially useful when
54 - nand-ecc-strength: see nand.txt.
55 - nand-ecc-step-size: see nand.txt. Marvell's NAND flash controller does
|
| /Linux-v4.19/Documentation/devicetree/bindings/media/ |
| D | mediatek-jpeg-decoder.txt | 12 - clocks: device clocks, see
15 - power-domains: a phandle to the power domain, see
17 - mediatek,larb: must contain the local arbiters in the current Socs, see
21 argument, see Documentation/devicetree/bindings/iommu/mediatek,iommu.txt
|
| D | mediatek-mdp.txt | 7 - mediatek,vpu: the node of video processor unit, see
17 - clocks: device clocks, see
19 - power-domains: a phandle to the power domain, see
28 argument, see Documentation/devicetree/bindings/iommu/mediatek,iommu.txt
30 - mediatek,larb: must contain the local arbiters in the current Socs, see
|
| /Linux-v4.19/arch/arm/mach-ixp4xx/ |
| D | Kconfig | 14 see http://www.nslu2-linux.org
22 see <file:Documentation/arm/IXP4xx>.
38 information on this platform, see <file:Documentation/arm/IXP4xx>.
46 see http://openwrt.org
54 on this platform, see http://openwrt.org
61 For more information on this platform, see <file:Documentation/arm/IXP4xx>.
68 For more information on this platform, see <file:Documentation/arm/IXP4xx>.
75 For more information on this platform, see <file:Documentation/arm/IXP4xx>.
88 For more information on this platform, see <file:Documentation/arm/IXP4xx>.
105 this platform, see <file:Documentation/arm/IXP4xx>.
[all …]
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/pressure/ |
| D | bmp085.txt | 13 active low, it should be marked GPIO_ACTIVE_LOW (see gpio/gpio.txt)
14 - vddd-supply: digital voltage regulator (see regulator/regulator.txt)
15 - vdda-supply: analog voltage regulator (see regulator/regulator.txt)
|
| /Linux-v4.19/Documentation/devicetree/bindings/arm/ux500/ |
| D | boards.txt | 23 see binding for arm/scu.txt
26 see binding for interrupt-controller/arm,gic.txt
29 see binding for timer/arm,twd.txt
32 see binding for clocks/ux500.txt
|
| /Linux-v4.19/Documentation/devicetree/bindings/input/ |
| D | elan_i2c.txt | 6 - interrupts: interrupt to which the chip is connected (see interrupt
11 - pinctrl-names: should be "default" (see pinctrl binding [1]).
12 - pinctrl-0: a phandle pointing to the pin settings for the device (see
|
| D | cypress,cyapa.txt | 6 - interrupts: interrupt to which the chip is connected (see interrupt
11 - pinctrl-names: should be "default" (see pinctrl binding [1]).
12 - pinctrl-0: a phandle pointing to the pin settings for the device (see
|
| D | elants_i2c.txt | 6 - interrupts: interrupt to which the chip is connected (see interrupt
11 - pinctrl-names: should be "default" (see pinctrl binding [1]).
12 - pinctrl-0: a phandle pointing to the pin settings for the device (see
|
| /Linux-v4.19/Documentation/devicetree/bindings/arm/ |
| D | scu.txt | 9 - Cortex-A9: see DDI0407E Cortex-A9 MPCore Technical Reference Manual
11 - Cortex-A5: see DDI0434B Cortex-A5 MPCore Technical Reference Manual
13 - ARM11 MPCore: see DDI0360F ARM 11 MPCore Processor Technical Reference
|
| /Linux-v4.19/Documentation/devicetree/bindings/input/touchscreen/ |
| D | sis_i2c.txt | 6 - interrupts: touch controller interrupt (see interrupt
10 - pinctrl-names: should be "default" (see pinctrl binding [1]).
12 device (see pinctrl binding [1]).
|
| /Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
| D | mt6397.txt | 30 see Documentation/devicetree/bindings/regulator/mt6397-regulator.txt
32 see Documentation/devicetree/bindings/regulator/mt6323-regulator.txt
42 see Documentation/devicetree/bindings/leds/leds-mt6323.txt
47 see Documentation/devicetree/bindings/input/mtk-pmic-keys.txt
|
| /Linux-v4.19/Documentation/power/ |
| D | drivers-testing.txt | 17 testing the new driver. Please see Documentation/power/basic-pm-debugging.txt
26 (see: Documentation/power/basic-pm-debugging.txt, 1).
29 "platform" modes (see: Documentation/power/basic-pm-debugging.txt, 1).
37 e) Try the test modes of suspend (see: Documentation/power/basic-pm-debugging.txt,
42 (see: Documentation/power/basic-pm-debugging.txt, 2).
|
12345678910>>...62
