Searched refs:sampling (Results 1 – 25 of 112) sorted by relevance
12345
| /Linux-v4.19/net/psample/ |
| D | Kconfig | 2 # psample packet sampling configuration
7 tristate "Packet-sampling netlink channel"
10 Say Y here to add support for packet-sampling netlink channel
|
| /Linux-v4.19/drivers/media/pci/cx88/ |
| D | cx88-input.c | 45 u32 sampling; member
208 if (ir->sampling) { in __cx88_ir_start()
225 if (ir->sampling) { in __cx88_ir_stop()
300 ir->sampling = 0xeb04; /* address */ in cx88_ir_init()
314 ir->sampling = 1; in cx88_ir_init()
406 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
412 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
416 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
433 ir->sampling = 1; in cx88_ir_init()
443 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
[all …]
|
| /Linux-v4.19/Documentation/devicetree/bindings/staging/iio/adc/ |
| D | spear-adc.txt | 7 - sampling-frequency: Default sampling frequency
22 sampling-frequency = <5000000>;
|
| /Linux-v4.19/Documentation/ABI/testing/ |
| D | configfs-usb-gadget-uac2 | 8 c_srate - capture sampling rate
11 p_srate - playback sampling rate
|
| D | configfs-usb-gadget-uac1 | 8 c_srate - capture sampling rate
11 p_srate - playback sampling rate
|
| D | sysfs-bus-iio-timer-stm32 | 79 Reading returns the current sampling frequency.
80 Writing an value different of 0 set and start sampling.
81 Writing 0 stop sampling.
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/adc/ |
| D | amlogic,meson-saradc.txt | 14 - interrupts: the interrupt indicating end of sampling
20 - "adc_clk" for the ADC (sampling) clock
21 - "adc_sel" for the ADC (sampling) clock mux
|
| D | at91-sama5d2_adc.txt | 11 - atmel,min-sample-rate-hz: Minimum sampling rate, it depends on SoC.
12 - atmel,max-sample-rate-hz: Maximum sampling rate, it depends on SoC.
|
| D | renesas,gyroadc.txt | 34 12bit sampling, up to 4 channels can be sampled in
45 15bit sampling, up to 8 channels can be sampled in
54 16bit sampling, up to 8 channels can be sampled in
|
| /Linux-v4.19/tools/perf/tests/attr/ |
| D | test-record-group-sampling | 32 # inherit is disabled for group sampling
35 # sampling disabled
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | nau8824.txt | 53 - nuvoton,sar-sampling-time: SAR sampling time
85 nuvoton,sar-sampling-time = <1>;
|
| D | nau8825.txt | 57 - nuvoton,sar-sampling-time: SAR sampling time
97 nuvoton,sar-sampling-time = <0>;
|
| D | st,stm32-i2s.txt | 15 "x8k": I2S parent clock for sampling rates multiple of 8kHz.
16 "x11k": I2S parent clock for sampling rates multiple of 11.025kHz.
|
| D | simple-scu-card.txt | 4 For example, you can use this driver if you want to exchange sampling rate convert,
24 - simple-audio-card,convert-rate : platform specified sampling rate convert
|
| D | mt8173-rt5650.txt | 18 1 : internal source from mt8173, MCLK = sampling rate*256
|
| /Linux-v4.19/Documentation/sound/cards/ |
| D | maya44.rst | 29 - playback and capture at all sampling rates
95 The Maya44 card (or more exactly, the Wolfson WM8776 codecs) allow a maximum sampling rate of 192 k…
97 As the ICE1724 chip only allows one global sampling rate, this is handled as follows:
99 * setting the sampling rate on any open PCM device on the maya44 card will always set the *global* …
106 …ditional code for limiting the sampling rate when setting on a capture pcm device. However because…
|
| /Linux-v4.19/arch/mips/kernel/ |
| D | entry.S | 50 # between sampling and return
88 # sampling and return
132 # sampling and return
|
| /Linux-v4.19/Documentation/devicetree/bindings/spi/ |
| D | spi-samsung.txt | 61 - samsung,spi-feedback-delay: The sampling phase shift to be applied on the
66 - 1: 90 degree phase shift sampling.
67 - 2: 180 degree phase shift sampling.
68 - 3: 270 degree phase shift sampling.
|
| /Linux-v4.19/Documentation/devicetree/bindings/mmc/ |
| D | cavium-mmc.txt | 22 - cavium,cmd-clk-skew : number of coprocessor clocks before sampling command
23 - cavium,dat-clk-skew : number of coprocessor clocks before sampling data
|
| /Linux-v4.19/tools/power/cpupower/bench/ |
| D | README-BENCH | 74 sampling rate you get:
79 In round 2, if the ondemand sampling times exactly match the load/sleep
91 |-----|-----|-----|-----|-----|-----|-----|---- ondemand sampling (1)
93 |-----|-----|-----|-----|-----|-----|-----|-- ondemand sampling (2)
|
| /Linux-v4.19/Documentation/media/uapi/v4l/ |
| D | dev-sdr.rst | 46 ADC/DAC sampling rate (sampling frequency) and the possible radio
63 capture and output format. Both the sampling resolution and the data
|
| /Linux-v4.19/tools/perf/Documentation/ |
| D | perf-top.txt | 220 Enable taken branch stack sampling. Any type of taken branch may be sampled.
225 Enable taken branch stack sampling. Each sample captures a series of consecutive
234 levels are subject to permissions. When sampling on multiple events, branch stack sampling
235 is enabled for all the sampling events. The sampled branch type is the same for all events.
|
| D | perf-record.txt | 51 - 'period': Set event sampling period
52 - 'freq': Set event sampling frequency
240 doesn't work with branch stack sampling at the same time.
329 Enable taken branch stack sampling. Any type of taken branch may be sampled.
334 Enable taken branch stack sampling. Each sample captures a series of consecutive
352 - save_type: save branch type during sampling in case binary is not available later
358 levels are subject to permissions. When sampling on multiple events, branch stack sampling
359 is enabled for all the sampling events. The sampled branch type is the same for all events.
364 Enable weightened sampling. An additional weight is recorded per sample and can be
|
| /Linux-v4.19/Documentation/devicetree/bindings/phy/ |
| D | apm-xgene-phy.txt | 23 data earlier than the nominal sampling point. 1 means
24 sample data later than the nominal sampling point.
|
| /Linux-v4.19/Documentation/hwmon/ |
| D | adt7410 | 40 continuous temperature sampling, as well as sampling one temperature value per
|
12345
