Searched refs:reduced (Results 1 – 25 of 122) sorted by relevance
12345
| /Linux-v4.19/Documentation/fb/ |
| D | modedb.txt | 32 If 'R' is specified, do a 'reduced blanking' calculation for digital displays.
82 displays, the "reduced blanking" calculation can be used.
87 new CRT displays and probably with most flatpanels, if 'reduced blanking'
100 -R = reduced blanking
102 example: .48M3-R - 800x600 with reduced blanking
108 - if reduced blanking, the refresh rate must be at 60Hz
|
| /Linux-v4.19/Documentation/devicetree/bindings/input/rmi4/ |
| D | rmi_2d_sensor.txt | 30 to generate an interrupt in reduced reporting
33 to generate an interrupt in reduced reporting
|
| /Linux-v4.19/Documentation/hwmon/ |
| D | nsa320 | 42 the first clock pulse is reduced from 100 ms to just under 10ms then the chip
44 is reduced from 100 us to less than 15 us then data pulses are likely to be
|
| D | max1668 | 19 The three devices are very similar, but the MAX1805 has a reduced feature
|
| D | acpi_power_meter | 42 result in reduced performance.
|
| D | max6650 | 24 The 2 devices are very similar, but the MAX6550 has a reduced feature
|
| /Linux-v4.19/Documentation/i2c/busses/ |
| D | i2c-parport-light | 8 parport handling is not an option. The drawback is a reduced portability
|
| /Linux-v4.19/Documentation/devicetree/bindings/nds32/ |
| D | atl2c.txt | 6 signigicantly and the system power consumption might be reduced as well by
|
| /Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
| D | max77693.txt | 62 the charging current will be reduced by 105 mA/Celsius.
73 below this value, the input current will be reduced to reach the
91 on both outputs. The maximum current on each output is reduced
|
| /Linux-v4.19/Documentation/media/uapi/rc/ |
| D | lirc-set-wideband-receiver.rst | 41 reduced range of reception.
|
| /Linux-v4.19/Documentation/devicetree/bindings/media/i2c/ |
| D | adv7343.txt | 13 - adi,power-mode-sleep-mode: on enable the current consumption is reduced to
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/imx/ |
| D | hdmi.txt | 28 or the functionally-reduced I2C master contained in the DWC HDMI. When
|
| /Linux-v4.19/Documentation/devicetree/bindings/arm/msm/ |
| D | qcom,idle-state.txt | 28 voltage may be reduced to the minimum value needed to keep the processor
51 voltages reduced, provided all cpus enter this state. Since the span of low
|
| /Linux-v4.19/kernel/ |
| D | Kconfig.hz | 23 with lots of processors that may show reduced performance if
|
| /Linux-v4.19/Documentation/networking/ |
| D | x25-iface.txt | 97 reduced by the following measures or a combination thereof:
118 of packet loss in netif_rx() path will be significantly reduced.
|
| D | netdev-features.txt | 74 set can be reduced further by networking core imposed limitations (as coded
158 [FIXME: Those cases could be fixed in VLAN code by allowing only reduced-MTU
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/rockchip/ |
| D | dw_hdmi-rockchip.txt | 30 or the functionally-reduced I2C master contained in the DWC HDMI. When
|
| /Linux-v4.19/Documentation/admin-guide/pm/ |
| D | sleep-states.rst | 11 reduced.
40 deeper system suspend variants to provide reduced resume latency. It is always
61 reduced relative to :ref:`suspend-to-idle <s2idle>` and it may be necessary to
93 The set of devices that can wake up the system from S2RAM usually is reduced
|
| /Linux-v4.19/Documentation/isdn/ |
| D | README.hfc-pci | 7 for a HFC-PCI card is reduced to 1. Of course this is only relevant to
|
| /Linux-v4.19/Documentation/sound/soc/ |
| D | pops-clicks.rst | 21 suppression. Pops can be reduced within playback by powering the audio
|
| /Linux-v4.19/drivers/isdn/ |
| D | Kconfig | 31 a daemon running. A reduced T.70 protocol is supported with tty's
|
| /Linux-v4.19/include/drm/ |
| D | drm_modes.h | 480 bool reduced, bool interlaced,
|
| /Linux-v4.19/Documentation/driver-api/firmware/ |
| D | firmware_cache.rst | 43 * The timeout for the fallback mechanism is temporarily reduced to 10 seconds
|
| /Linux-v4.19/net/smc/ |
| D | smc_core.c | 130 int reduced = 0; in smc_lgr_unregister_conn() local
134 reduced = 1; in smc_lgr_unregister_conn()
138 if (!reduced || lgr->conns_num) in smc_lgr_unregister_conn()
|
| /Linux-v4.19/Documentation/md/ |
| D | raid5-ppl.txt | 28 reduced by up to 30%-40% but it scales with the number of drives in the array
|
12345
