Searched refs:reconfigure (Results 1 – 25 of 28) sorted by relevance
12
| /Linux-v4.19/fs/autofs/ |
| D | Kconfig | 29 don't have a laptop which needs to dynamically reconfigure to the
|
| /Linux-v4.19/Documentation/devicetree/bindings/pci/ |
| D | designware-pcie-ecam.txt | 8 to reconfigure ATU windows for config and/or IO space accesses at runtime.
|
| /Linux-v4.19/Documentation/devicetree/bindings/power/reset/ |
| D | gpio-poweroff.txt | 26 - input : Initially configure the GPIO line as an input. Only reconfigure
|
| /Linux-v4.19/drivers/dma/qcom/ |
| D | bam_dma.c | 377 unsigned int reconfigure; /* new slave config? */ member
599 bchan->reconfigure = 1; in bam_slave_config()
958 bchan->reconfigure = 0; in bam_apply_new_config()
996 if (bchan->reconfigure) in bam_start_dma()
|
| /Linux-v4.19/Documentation/fb/ |
| D | ep93xx-fb.txt | 134 In some cases it may be possible to reconfigure your SDRAM layout to
|
| /Linux-v4.19/drivers/net/ethernet/sfc/falcon/ |
| D | tenxpress.c | 484 .reconfigure = tenxpress_phy_reconfigure,
|
| D | qt202x_phy.c | 487 .reconfigure = qt202x_phy_reconfigure,
|
| D | txc43128_phy.c | 552 .reconfigure = txc43128_phy_reconfigure,
|
| D | efx.c | 1074 rc = efx->phy_op->reconfigure(efx); in ef4_init_port()
2399 rc = efx->phy_op->reconfigure(efx); in ef4_reset_up()
2624 .reconfigure = ef4_port_dummy_op_int,
3036 efx->phy_op->reconfigure(efx); in ef4_pm_thaw()
|
| D | net_driver.h | 576 int (*reconfigure) (struct ef4_nic *efx); member
|
| D | ethtool.c | 718 rc = efx->phy_op->reconfigure(efx); in ef4_ethtool_set_pauseparam()
|
| /Linux-v4.19/Documentation/devicetree/bindings/mmc/ |
| D | ti-omap-hsmmc.txt | 104 The workaround is to reconfigure the dat1 line as a GPIO upon suspend. To make
|
| /Linux-v4.19/Documentation/driver-api/usb/ |
| D | typec_bus.rst | 52 in need to reconfigure the pins on the connector, the alternate mode driver
|
| /Linux-v4.19/Documentation/networking/ |
| D | cs89x0.txt | 445 option to reconfigure the adapter by selecting a different value for the system
519 self-test. If so, reconfigure the adapter selecting another choice for the
524 the adapter and reconfigure it by installing it in another PC to run the
|
| /Linux-v4.19/Documentation/gpio/ |
| D | sysfs.txt | 79 allow userspace to reconfigure this GPIO's direction.
|
| /Linux-v4.19/drivers/net/ethernet/sfc/ |
| D | efx.c | 1133 rc = efx->phy_op->reconfigure(efx); in efx_init_port()
2708 rc = efx->phy_op->reconfigure(efx); in efx_reset_up()
2991 .reconfigure = efx_port_dummy_op_int,
3695 efx->phy_op->reconfigure(efx); in efx_pm_thaw()
|
| D | net_driver.h | 649 int (*reconfigure) (struct efx_nic *efx); member
|
| D | mcdi_port.c | 1122 .reconfigure = efx_mcdi_port_reconfigure,
|
| D | ethtool.c | 740 rc = efx->phy_op->reconfigure(efx); in efx_ethtool_set_pauseparam()
|
| /Linux-v4.19/Documentation/media/v4l-drivers/ |
| D | omap3isp.rst | 231 case. In order to avoid such condition, either disable/reconfigure/enable the
|
| /Linux-v4.19/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-bindings.txt | 15 need to reconfigure pins at run-time, for example to tri-state pins when the
|
| /Linux-v4.19/Documentation/timers/ |
| D | NO_HZ.txt | 278 o A reboot is required to reconfigure both adaptive idle and RCU
|
| /Linux-v4.19/drivers/net/ |
| D | Kconfig | 251 This option enables the ability to dynamically reconfigure target
|
| /Linux-v4.19/Documentation/sound/cards/ |
| D | audiophile-usb.rst | 114 the snd-usb-audio module will reconfigure the device on the fly.
|
| /Linux-v4.19/drivers/char/ |
| D | Kconfig | 340 FPGA platforms to partially reconfigure the FPGA at runtime.
|
12
