Searched refs:reception (Results 1 – 25 of 66) sorted by relevance
123
/Linux-v4.19/Documentation/ABI/stable/ |
D | firewire-cdev | 24 - Isochronous stream transmission and reception 25 - Asynchronous stream transmission and reception 27 - PHY packet transmission and reception 33 - Bus reset initiation, bus reset event reception 36 link layers, reception of inbound requests to such 48 - PHY packet transmission and reception 73 request reception, or PHY packet reception. Always use a read 76 of all event types and for which ioctls affect reception of 80 Allocate a DMA buffer for isochronous reception or transmission 84 prot = at least PROT_READ for reception and at least PROT_WRITE [all …]
|
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-class-led-trigger-netdev | 42 Signal reception of data on the named network device. 43 If set to 0 (default), the LED will not blink on reception. 45 in interval to signal reception.
|
/Linux-v4.19/drivers/staging/pi433/Documentation/ |
D | pi433.txt | 9 (www.pi433.de). It supports transmission and reception. It can be opened 10 by multiple applications for transmission and reception. While transmit 12 application asking for reception will block out all other applications 40 b) reception 43 reception there is only one configuration set. 44 As soon as an application sets a request for receiving a telegram, the reception 47 receiver) is reached. Until this hasn't happened, the reception can be 52 read. So also for reception it is possible to receive more data than the hardware 181 If this value is exceeded, a reception cycle starts
|
/Linux-v4.19/Documentation/devicetree/bindings/media/ |
D | gpio-ir-receiver.txt | 5 - gpios: specifies GPIO used for IR signal reception.
|
/Linux-v4.19/Documentation/devicetree/bindings/sound/ |
D | sirf-audio-port.txt | 11 named "tx") and one for reception (should be named "rx").
|
D | brcm,bcm2835-i2s.txt | 12 named "tx") and one for reception (should be named "rx").
|
D | sirf-usp.txt | 11 named "tx") and one for reception (should be named "rx").
|
/Linux-v4.19/Documentation/media/uapi/rc/ |
D | lirc-set-wideband-receiver.rst | 41 reduced range of reception.
|
/Linux-v4.19/Documentation/media/uapi/v4l/ |
D | pixfmt-meta-uvc.rst | 40 reception of the payload
|
D | vidioc-g-tuner.rst | 249 - Stereo audio reception is supported. 366 stereo reception the driver shall fall back to ``MODE_MONO``. 374 bilingual audio or SAP, or their reception is not supported the 380 bilingual audio or SAP, or their reception is not supported the
|
D | dev-rds.rst | 136 reception of this block.
|
/Linux-v4.19/Documentation/media/ |
D | intro.rst | 29 Internet reception via one of the several digital tv standards. While it is
|
/Linux-v4.19/Documentation/devicetree/bindings/i2c/ |
D | i2c-sh_mobile.txt | 42 reception.
|
D | i2c-rcar.txt | 42 transmission, and one for reception.
|
/Linux-v4.19/Documentation/devicetree/bindings/spi/ |
D | spi-rspi.txt | 38 one for transmission, and one for reception.
|
D | sh-msiof.txt | 55 reception.
|
/Linux-v4.19/drivers/usb/atm/ |
D | Kconfig | 62 and reception as module parameters. You may need to initialize
|
/Linux-v4.19/Documentation/devicetree/bindings/serial/ |
D | qcom,msm-uartdm.txt | 33 used with RX DMA channel. Required when using DMA for reception
|
/Linux-v4.19/arch/sh/include/mach-kfr2r09/mach/ |
D | partner-jet-setup.txt | 31 LIST "RF frequency and improved reception sensitivity."
|
/Linux-v4.19/Documentation/media/v4l-drivers/ |
D | v4l-with-ir.rst | 24 switch the protocol and to test the reception of scan codes;
|
/Linux-v4.19/Documentation/networking/ |
D | can.rst | 164 transmission and reception of media dependent frames. Due to the 166 may be delayed by the reception of a high prio CAN frame. To 201 errors may be selected. The reception of error messages is disabled 362 at the reception of a CAN frame. 439 The reception of CAN frames using CAN_RAW sockets can be controlled 474 To disable the reception of CAN frames on the selected CAN_RAW socket: 489 reception time. To reduce the number of checks that need to be performed 566 needs. The reception of the CAN frames on the same socket that was 892 is activated directly - even without a former CAN frame reception. 1125 The virtual CAN interfaces allow the transmission and reception of CAN
|
D | x25-iface.txt | 101 driver's LAPB protocol must not confirm reception of the frame
|
/Linux-v4.19/Documentation/media/uapi/dvb/ |
D | fe_property_parameters.rst | 279 whether the channel is in partial reception mode or not. 402 Hierarchical reception in ISDB-T is achieved by enabling or disabling 407 If the channel is in the partial reception mode
|
/Linux-v4.19/drivers/net/wireless/ |
D | wl3501.h | 484 u8 reception; member
|
/Linux-v4.19/Documentation/devicetree/bindings/usb/ |
D | dwc3.txt | 52 - snps,lfps_filter_quirk: when set core will filter LFPS reception.
|
123