Searched refs:rails (Results 1 – 21 of 21) sorted by relevance
117 list_for_each_entry(rail, &iccsense->rails, head) { in nvkm_iccsense_read_all()141 list_for_each_entry_safe(rail, tmpr, &iccsense->rails, head) { in nvkm_iccsense_dtor()291 list_add_tail(&rail->head, &iccsense->rails); in nvkm_iccsense_oneinit()328 INIT_LIST_HEAD(&(*iccsense)->rails); in nvkm_iccsense_new_()
11 struct list_head rails; member
20 * In general an attempt is made to include all rails called out by21 * the schematic as long as those rails interact in some way with25 * - Rails _are_ included if the rails go to the AP even if the AP30 * If two rails are substantially the same from the AP's point of32 * put the child rail as an alias of the parent rail. Sometimes rails36 * - The rails are actually connected to each other by a jumper and
97 rails. See chip datasheets for details.103 created for enabled rails. See chip datasheets for
24 sequences up to 12 independent voltage rails. The device integrates a 12-bit
6 if DDR power rails will be kept powered during system suspend.
6 egulators and 7 LDOs to provide all the power rails required by the SoC and
30 rails need to be kept powered when backup mode is
115 GPIO1/nRST_IO pins are HIGH only if all rails117 If any of the rails goes down(which are enabled for POK
127 AS3722 supports the system power off by turning off all its rails.
55 /* Common 1.8V and 3.3V rails, used by several devices on APE6EVM */
21 /* Name the GPIO muxed rails on the HREF boards */
98 /* Name the GPIO muxed rails on the Snowball board */
22 entry then driver will just configure this rails as external control
570 This driver supports the control of different power rails of device579 This driver supports the control of different power rails of device588 This driver supports the control of different power rails of device597 This driver supports the control of different power rails of device723 This driver supports the control of different power rails of device733 This driver supports the control of different power rails of device
132 0x10 afcrl Flag indicating if AFC rails
88 or because all its power rails can be driven by the same supply. In that case
108 that corresponding clocks and/or power-rails can be turned off to save power.
305 if (!iccsense || !iccsense->data_valid || list_empty(&iccsense->rails)) in nouveau_power_is_visible()
141 clock/voltage rails with it).
506 to control power rails and sensor reading/writing on the
