| /Linux-v4.19/tools/perf/util/ |
| D | cloexec.c | 95 static bool probed; in perf_event_open_cloexec_flag() local
97 if (!probed) { in perf_event_open_cloexec_flag()
100 probed = true; in perf_event_open_cloexec_flag()
|
| /Linux-v4.19/arch/x86/boot/ |
| D | video-mode.c | 36 static u8 probed[2]; in probe_cards() local
38 if (probed[unsafe]) in probe_cards()
41 probed[unsafe] = 1; in probe_cards()
|
| /Linux-v4.19/drivers/clk/ti/ |
| D | clk-dra7-atl.c | 52 bool probed; /* the driver for the IP has been loaded */ member
84 if (!cdesc->probed) in atl_clk_enable()
106 if (!cdesc->probed) in atl_clk_disable()
293 cdesc->probed = true; in of_dra7_atl_clk_probe()
|
| /Linux-v4.19/fs/afs/ |
| D | volume.c | 86 if (!test_bit(ac.index, &ac.alist->probed)) { in afs_vl_lookup_vldb()
91 set_bit(ac.index, &ac.alist->probed); in afs_vl_lookup_vldb()
96 set_bit(ac.index, &ac.alist->probed); in afs_vl_lookup_vldb()
|
| /Linux-v4.19/Documentation/ABI/testing/ |
| D | sysfs-class-mux | 16 probed MUX chip where N is a simple enumeration.
|
| D | sysfs-class-mei | 15 each probed mei device
|
| D | sysfs-class-pwm | 16 probed PWM controller/chip where N is the base of the
|
| /Linux-v4.19/Documentation/ |
| D | kprobes.txt | 63 When a kprobe is registered, Kprobes makes a copy of the probed
64 instruction and replaces the first byte(s) of the probed instruction
73 Next, Kprobes single-steps its copy of the probed instruction.
110 the entry to the function. When the probed function is called and this
116 When the probed function executes its return instruction, control
122 While the probed function is executing, its return address is
126 function can be probed simultaneously. register_kretprobe()
139 time the probed function is entered but there is no kretprobe_instance
163 In case probed function is entered but there is no kretprobe_instance
228 - Other instructions in the optimized region are probed.
[all …]
|
| /Linux-v4.19/arch/sparc/mm/ |
| D | srmmu.c | 771 unsigned long probed; in srmmu_inherit_prom_mappings() local
783 probed = srmmu_probe(start); in srmmu_inherit_prom_mappings()
784 if (!probed) { in srmmu_inherit_prom_mappings()
795 if (srmmu_probe(addr + SRMMU_REAL_PMD_SIZE) == probed) in srmmu_inherit_prom_mappings()
800 if (srmmu_probe(addr + SRMMU_PGDIR_SIZE) == probed) in srmmu_inherit_prom_mappings()
806 *(pgd_t *)__nocache_fix(pgdp) = __pgd(probed); in srmmu_inherit_prom_mappings()
835 *(unsigned long *)__nocache_fix(val) = probed; in srmmu_inherit_prom_mappings()
840 *(pte_t *)__nocache_fix(ptep) = __pte(probed); in srmmu_inherit_prom_mappings()
|
| /Linux-v4.19/Documentation/driver-api/ |
| D | device_link.rst | 31 presence on the supplier. The consumer devices are not probed before the
62 ``->probe`` callback while the supplier hasn't probed yet: Had the driver
63 core known about the device link earlier, it wouldn't have probed the
101 never be probed.
215 add a device flag causing the parent driver to be probed before the
236 and consumer. If the link is created before any devices are probed, it
244 * Before a consumer device is probed, presence of supplier drivers is
|
| /Linux-v4.19/Documentation/devicetree/bindings/mips/img/ |
| D | pistachio.txt | 14 be probed via CPS, it is not necessary to specify secondary CPUs. Required
|
| /Linux-v4.19/Documentation/devicetree/bindings/openrisc/opencores/ |
| D | or1ksim.txt | 19 be probed via CPS, it is not necessary to specify secondary CPUs. Required
|
| /Linux-v4.19/Documentation/devicetree/bindings/reserved-memory/ |
| D | qcom,cmd-db.txt | 10 resource properties may change. These properties are dynamically probed by the
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | brcm,mdio-mux-iproc.txt | 13 Every non-ethernet PHY requires a compatible so that it could be probed based
|
| /Linux-v4.19/Documentation/devicetree/bindings/gpio/ |
| D | sodaville.txt | 10 There is no compatible property for now because the driver is probed via
|
| /Linux-v4.19/arch/mips/boot/dts/mti/ |
| D | malta.dts | 34 * controller & should be probed first.
|
| /Linux-v4.19/Documentation/watchdog/ |
| D | wdt.txt | 23 The ICS ISA-bus wdt card cannot be safely probed for. Instead you need to
|
| /Linux-v4.19/tools/power/pm-graph/config/ |
| D | custom-timeline-functions.cfg | 88 # function: The symbol name for the function you want probed, this is the
153 # function: The symbol name for the function you want probed, this is the
|
| /Linux-v4.19/tools/perf/Documentation/ |
| D | perf-probe.txt | 81 Show source code lines which can be probed. This needs an argument
173 'EVENT' specifies the name of new event, if omitted, it will be set the name of the probed function…
176 'FUNC' specifies a probed function name, and it may have one of the following options; '+OFFS' is t…
246 Display which lines in schedule() can be probed:
|
| /Linux-v4.19/Documentation/i2c/ |
| D | instantiating-devices | 178 probed, will be probed. For example this avoids probing for hardware
198 probed by default back then. The default is an empty class which means
|
| /Linux-v4.19/drivers/tty/serial/ |
| D | sb1250-duart.c | 776 static int probed; in sbd_probe_duarts() local
780 if (probed) in sbd_probe_duarts()
795 probed = 1; in sbd_probe_duarts()
|
| /Linux-v4.19/Documentation/devicetree/bindings/memory-controllers/ |
| D | ingenic,jz4780-nemc.txt | 41 configured to when the NEMC device is probed (which may be the reset value as
|
| /Linux-v4.19/Documentation/devicetree/bindings/i2c/ |
| D | i2c-pxa-pci-ce4100.txt | 8 The driver is probed via the PCI-ID and is gathering the information of
|
| /Linux-v4.19/drivers/staging/fsl-dpaa2/ethsw/ |
| D | README | 86 A device is created for the switch objects probed on the MC bus. Each DPSW
|
| /Linux-v4.19/Documentation/PCI/endpoint/ |
| D | pci-endpoint-cfs.txt | 40 In order to create a <EPF device> of the type probed by <EPF Driver>, the
|
