Searched refs:ohm (Results 1 – 15 of 15) sorted by relevance
| /Linux-v4.19/drivers/hwmon/ |
| D | ntc_thermistor.c | 45 unsigned int ohm; member
68 { .temp_c = -40, .ohm = 1747920 },
69 { .temp_c = -35, .ohm = 1245428 },
70 { .temp_c = -30, .ohm = 898485 },
71 { .temp_c = -25, .ohm = 655802 },
72 { .temp_c = -20, .ohm = 483954 },
73 { .temp_c = -15, .ohm = 360850 },
74 { .temp_c = -10, .ohm = 271697 },
75 { .temp_c = -5, .ohm = 206463 },
76 { .temp_c = 0, .ohm = 158214 },
[all …]
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | cros-adc-thermistors.dtsi | 19 pullup-ohm = <47000>;
20 pulldown-ohm = <0>;
26 pullup-ohm = <47000>;
27 pulldown-ohm = <0>;
33 pullup-ohm = <47000>;
34 pulldown-ohm = <0>;
40 pullup-ohm = <47000>;
41 pulldown-ohm = <0>;
|
| D | exynos3250-monk.dts | 144 pullup-ohm = <100000>;
145 pulldown-ohm = <100000>;
152 pullup-ohm = <100000>;
153 pulldown-ohm = <100000>;
|
| D | exynos3250-rinato.dts | 139 pullup-ohm = <100000>;
140 pulldown-ohm = <100000>;
147 pullup-ohm = <100000>;
148 pulldown-ohm = <100000>;
|
| D | exynos4412-midas.dtsi | 252 pullup-ohm = <100000>; /* 100K */
253 pulldown-ohm = <100000>; /* 100K */
260 pullup-ohm = <100000>; /* 100K */
261 pulldown-ohm = <100000>; /* 100K */
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/potentiostat/ |
| D | lmp91000.txt | 14 - ti,external-tia-resistor: if the property ti,tia-gain-ohm is not defined this
19 - ti,tia-gain-ohm: ohm value of the internal resistor for the transimpedance
22 - ti,rload-ohm: ohm value of the internal resistor load applied to the gas
30 ti,tia-gain-ohm = <7500>;
|
| /Linux-v4.19/Documentation/devicetree/bindings/hwmon/ |
| D | ntc_thermistor.txt | 23 - "pullup-ohm" Pull up resistor value in ohms
24 - "pulldown-ohm" Pull down resistor value in ohms
40 pullup-ohm = <47000>;
41 pulldown-ohm = <0>;
|
| /Linux-v4.19/Documentation/devicetree/bindings/phy/ |
| D | mxs-usb-phy.txt | 17 high-speed trimming resistor connected in parallel with the 45 ohm resistor
20 high-speed trimming resistor connected in parallel with the 45 ohm resistor
|
| /Linux-v4.19/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-gru-kevin.dts | 56 pullup-ohm = <25500>;
57 pulldown-ohm = <0>;
65 pullup-ohm = <25500>;
66 pulldown-ohm = <0>;
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/adc/ |
| D | samsung,exynos-adc.txt | 96 pullup-ohm = <47000>;
97 pulldown-ohm = <0>;
|
| /Linux-v4.19/Documentation/devicetree/bindings/rtc/ |
| D | abracon,abx80x.txt | 30 resistor, the other values are in ohm.
|
| /Linux-v4.19/Documentation/devicetree/bindings/input/touchscreen/ |
| D | tsc2005.txt | 14 in ohm (defaults to 280)
|
| /Linux-v4.19/arch/arm64/boot/dts/exynos/ |
| D | exynos5433-tm2-common.dtsi | 145 pullup-ohm = <100000>;
146 pulldown-ohm = <0>;
153 pullup-ohm = <100000>;
154 pulldown-ohm = <0>;
162 pullup-ohm = <100000>;
163 pulldown-ohm = <0>;
|
| /Linux-v4.19/Documentation/auxdisplay/ |
| D | cfag12864b | 81 Ground (21)---[GND] [GND]---[P1]---(18) Vee - R = Resistor = 22 ohm
|
| /Linux-v4.19/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 1572 into an ohm value.
|
