Searched refs:numbered (Results 1 – 25 of 115) sorted by relevance
12345
| /Linux-v4.19/Documentation/devicetree/bindings/display/bridge/ |
| D | renesas,dw-hdmi.txt | 28 - ports: See dw_hdmi.txt. The DWC HDMI shall have one port numbered 0
29 corresponding to the video input of the controller and one port numbered 1
30 corresponding to its HDMI output, and one port numbered 2 corresponding to
|
| /Linux-v4.19/Documentation/hid/ |
| D | hidraw.txt | 48 On a device which uses numbered reports, the first byte of the returned data
50 byte. For devices which do not use numbered reports, the report data
61 number. If the device does not use numbered reports, the first byte should
100 which do not use numbered reports, set the first byte to 0. The report data
107 number of the requested report. For devices which do not use numbered
|
| /Linux-v4.19/Documentation/input/ |
| D | input_kapi.rst | 13 :numbered:
|
| D | input_uapi.rst | 13 :numbered:
|
| /Linux-v4.19/Documentation/devicetree/bindings/pinctrl/ |
| D | st,stm32-pinctrl.txt | 22 - pins-are-numbered: Specify the subnodes are using numbered pinmux to
69 pins-are-numbered;
91 pins-are-numbered;
|
| D | pinctrl-mt65xx.txt | 14 - pins-are-numbered: Specify the subnodes are using numbered pinmux to
93 pins-are-numbered;
|
| /Linux-v4.19/Documentation/devicetree/bindings/media/ |
| D | cdns,csi2rx.txt | 26 port nodes are numbered as follows:
39 the endpoints are not numbered.
|
| D | cdns,csi2tx.txt | 25 port nodes are numbered as follows.
38 the endpoints are not numbered.
|
| D | st,stih4xx.txt | 25 Each BDISP should have a numbered alias in the aliases node, in the form of
|
| /Linux-v4.19/Documentation/input/devices/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v4.19/Documentation/devicetree/bindings/display/rockchip/ |
| D | dw_hdmi-rockchip.txt | 22 - ports: See dw_hdmi.txt. The DWC HDMI shall have a single port numbered 0
24 endpoints, numbered 0 and 1, connected respectively to the vopb and vopl.
|
| /Linux-v4.19/Documentation/filesystems/ext4/ |
| D | index.rst | 14 :numbered:
|
| /Linux-v4.19/Documentation/media/uapi/cec/ |
| D | cec-api.rst | 22 :numbered:
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | mdio-gpio.txt | 11 Note: Each gpio-mdio bus should have an alias correctly numbered in "aliases"
|
| /Linux-v4.19/Documentation/media/uapi/rc/ |
| D | remote_controllers.rst | 19 :numbered:
|
| /Linux-v4.19/Documentation/media/uapi/mediactl/ |
| D | media-controller.rst | 19 :numbered:
|
| /Linux-v4.19/Documentation/devicetree/bindings/timer/ |
| D | cirrus,clps711x-timer.txt | 9 Note: Each timer should have an alias correctly numbered in "aliases" node.
|
| /Linux-v4.19/Documentation/devicetree/bindings/serial/ |
| D | arc-uart.txt | 20 Note: Each port should have an alias correctly numbered in "aliases" node.
|
| D | qca,ar9330-uart.txt | 16 Each UART port must have an alias correctly numbered in "aliases"
|
| D | digicolor-usart.txt | 14 Note: Each UART port should have an alias correctly numbered
|
| D | cirrus,clps711x-uart.txt | 14 Note: Each UART port should have an alias correctly numbered
|
| /Linux-v4.19/Documentation/iio/ |
| D | ep93xx_adc.txt | 13 not defined. So the last three are numbered randomly, let's say.
|
| /Linux-v4.19/Documentation/process/ |
| D | development-process.rst | 9 :numbered:
|
| /Linux-v4.19/Documentation/devicetree/bindings/gpio/ |
| D | gpio-clps711x.txt | 14 Note: Each GPIO port should have an alias correctly numbered in "aliases"
|
| /Linux-v4.19/Documentation/media/cec-drivers/ |
| D | index.rst | 32 :numbered:
|
12345
