Searched refs:jumpers (Results 1 – 9 of 9) sorted by relevance
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-platform-ts5500 | 24 What: /sys/devices/platform/ts5500/jumpers 29 Bitfield showing the jumpers' state. If a jumper is present, 30 the corresponding bit is set. For instance, 0x0e means jumpers
|
/Linux-v4.19/arch/x86/platform/ts5500/ |
D | ts5500.c | 87 u8 jumpers; member 149 sbc->jumpers = tmp & ~TS5500_LED; in ts5500_detect_config() 179 return sprintf(buf, "0x%.2x\n", sbc->jumpers >> 1); in jumpers_show() 181 static DEVICE_ATTR_RO(jumpers);
|
/Linux-v4.19/Documentation/networking/ |
D | arcnet-hardware.txt | 337 jumpers have them in the same position. Chris Hindy <chrish@io.org> 376 Even if your ARCnet model isn't listed, but has the same jumpers as another 425 About the jumpers: On my PC130 there is one more jumper, located near the 447 to find jumpers/switches with the same number of settings - it's 696 The jumpers labeled EXT1 and EXT2 are used to determine the timeout 697 parameters. These two jumpers are normally left open. 699 To select a hardware interrupt level set one (only one!) of the jumpers 925 The two jumpers JP2 (1-4) are used to determine the timeout parameters. 926 These two jumpers are normally left open. 986 The row of jumpers at JP1 actually consists of 8 jumpers, (sometimes [all …]
|
/Linux-v4.19/drivers/net/can/sja1000/ |
D | Kconfig | 99 PLD IO base addresses are read from jumpers JP1 and JP2, 100 IRQ numbers are read from jumpers JP4 and JP5,
|
/Linux-v4.19/drivers/pnp/ |
D | Kconfig | 12 parameters. No jumpers on the cards are needed, instead the values
|
/Linux-v4.19/arch/arm/boot/dts/ |
D | logicpd-torpedo-37xx-devkit.dts | 32 * MMC3 can be routed with jumpers to the second MMC slot on the devkit and
|
/Linux-v4.19/arch/powerpc/boot/dts/ |
D | sbc8548-altflash.dts | 5 * Requires switching JP12 jumpers and changing SW2.8 setting.
|
D | katmai.dts | 305 * have to be enabled via jumpers (only INTA is
|
/Linux-v4.19/arch/m68k/q40/ |
D | README | 69 Make sure to configure the parallel port as SPP and remove IRQ/DMA jumpers
|