Searched refs:gets (Results 1 – 25 of 291) sorted by relevance
12345678910>>...12
| /Linux-v4.19/Documentation/networking/dsa/ |
| D | bcm_sf2.txt | 45 which gets inserted by the switch for every packet forwarded to the CPU
57 provided in net/dsa/dsa.c. The reason for that is because the DSA subsystem gets
82 gets loaded onto the MoCA processor(s) for packet processing. The switch
84 the MoCA interface whenever the MoCA coaxial cable gets disconnected or the
85 firmware gets reloaded. The SF2 driver relies on such events to properly set its
112 capabilities is done and the intersection result gets configured. During
|
| /Linux-v4.19/arch/mips/include/asm/ |
| D | pmon.h | 22 char* (*gets) (char*); member
40 #define pmon_gets(s) debug_vectors->gets(s)
|
| /Linux-v4.19/drivers/staging/pi433/Documentation/ |
| D | pi433.txt | 13 until something gets received terminates the read request.
29 corresponding parameter set gets written to the kfifo.
31 kfifo is empty. If not, it gets one set of config and data from the kfifo. If
33 the air, the rf module is set to standby, the parameters for transmission gets
34 set, the hardware fifo of the rf chip gets preloaded and the transmission gets
35 started. Upon hardware fifo threshold interrupt it gets reloaded, thus enabling
45 configuration set is written to the rf module and it gets set into receiving mode.
51 dynamically. Upon each hardware fifo threshold interrupt, a portion of data gets
185 time the receiver gets more and more sensitive. This value
|
| /Linux-v4.19/Documentation/leds/ |
| D | ledtrig-transient.txt | 10 gets deactivated. There is no provision for one time activation to implement
31 routine for the default trigger gets called. During registration of an led
41 that are active at the time driver gets suspended, continue to run, without
55 During trigger unregistration, LED state gets changed to LED_OFF.
61 non-transient state. When driver gets suspended, irrespective of the transient
100 state gets changed to the non-transient state which is the
|
| /Linux-v4.19/drivers/staging/iio/Documentation/ |
| D | sysfs-bus-iio-light | 42 This property gets/sets the last known external
49 This property gets/sets the sensors ADC analog integration time.
55 This property gets/sets the table of coefficients
|
| /Linux-v4.19/Documentation/media/uapi/dvb/ |
| D | frontend-stat-properties.rst | 107 This measurement is monotonically increased, as the frontend gets more
135 This measurement is monotonically increased, as the frontend gets more
164 This measurement is monotonically increased, as the frontend gets more
192 This measurement is monotonically increased, as the frontend gets more
213 This measurement is monotonically increased, as the frontend gets more
|
| /Linux-v4.19/tools/perf/tests/ |
| D | make | 236 # FIXME nothing gets installed
240 # FIXME nothing gets installed
244 # FIXME nothing gets installed
248 # FIXME nothing gets installed
252 # FIXME nothing gets installed
|
| /Linux-v4.19/Documentation/vm/ |
| D | active_mm.rst | 54 anonymous process gets scheduled away, the borrowed address space is
66 gets scheduled away in favour of a real thread, the "zombie" mm gets
|
| /Linux-v4.19/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-tsl2583 | 12 This property gets/sets the table of coefficients
|
| /Linux-v4.19/scripts/ |
| D | subarch.include | 4 # then ARCH is assigned, getting whatever value it gets normally, and
|
| /Linux-v4.19/drivers/zorro/ |
| D | Kconfig | 11 15KB, but it gets freed after the system boots up, so it doesn't
|
| /Linux-v4.19/Documentation/devicetree/bindings/sram/ |
| D | rockchip-smp-sram.txt | 5 of the cores. Once the core gets powered up it executes the code that is
|
| D | samsung-sram.txt | 5 of the secondary cores. Once the core gets powered up it executes the
|
| /Linux-v4.19/Documentation/devicetree/bindings/arm/amlogic/ |
| D | smp-sram.txt | 5 Once the core gets powered up it executes the code that is residing at a
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | wm8962.txt | 13 of R51 (Class D Control 2) gets set, indicating that the speaker is
|
| D | wm8960.txt | 13 R24 (Additional control 2) gets set, indicating that ADCLRC and DACLRC pins
|
| /Linux-v4.19/Documentation/devicetree/bindings/power/reset/ |
| D | syscon-reboot-mode.txt | 3 This driver gets reboot mode magic value form reboot-mode driver
|
| /Linux-v4.19/Documentation/ |
| D | sync_file.txt | 53 The caller pass the out-fence and gets back the sync_file. That is just the
54 first step, next it needs to install an fd on sync_file->file. So it gets an
|
| /Linux-v4.19/Documentation/driver-model/ |
| D | bus.txt | 89 Each bus gets a directory in the bus directory, along with two default
107 Each device that is discovered on a bus of that type gets a symlink in
|
| D | class.txt | 83 Each class gets a directory in the class directory, along with two
102 Each device gets a symlink in the devices/ directory that points to the
|
| /Linux-v4.19/Documentation/scsi/ |
| D | qlogicfas.txt | 66 realbig.doc realbig.doc". Then do it after the computer gets warm.
71 that it gets a false ACK causing an extra byte to be inserted into the
|
| /Linux-v4.19/Documentation/watchdog/ |
| D | hpwdt.txt | 20 gets into a bad state and hangs, the HPE ProLiant iLO timer register will
45 confused" message in the logs or if the system gets into a hung state, then
|
| /Linux-v4.19/arch/s390/kernel/ |
| D | mcount.S | 62 # The j instruction gets runtime patched to a nop instruction.
|
| /Linux-v4.19/drivers/rpmsg/ |
| D | Kconfig | 5 # RPMSG always gets selected by whoever wants it
|
| /Linux-v4.19/Documentation/devicetree/bindings/usb/ |
| D | usb-nop-xceiv.txt | 40 hsusb1_phy is a NOP USB PHY device that gets its clock from an oscillator
|
12345678910>>...12
