Searched refs:follow (Results 1 – 25 of 274) sorted by relevance
1234567891011
/Linux-v4.19/Documentation/devicetree/bindings/power/reset/ |
D | qcom,pon.txt | 13 -pwrkey: Specifies the subnode pwrkey and should follow the 15 -resin: Specifies the subnode resin and should follow the 18 The rest of the properties should follow the generic reboot-mode description
|
D | syscon-reboot-mode.txt | 19 The rest of the properties should follow the generic reboot-mode description
|
/Linux-v4.19/Documentation/devicetree/bindings/regulator/ |
D | qcom,spmi-regulator.txt | 181 BIT(0) = follow HW0_EN signal 182 BIT(1) = follow HW1_EN signal 183 BIT(2) = follow HW2_EN signal 184 BIT(3) = follow HW3_EN signal 193 BIT(0) = follow HW0_EN signal 194 BIT(1) = follow HW1_EN signal 195 BIT(2) = follow HW2_EN signal 196 BIT(3) = follow HW3_EN signal 197 BIT(4) = follow PMIC awake state
|
/Linux-v4.19/fs/btrfs/ |
D | print-tree.h | 10 void btrfs_print_tree(struct extent_buffer *c, bool follow);
|
D | print-tree.c | 324 void btrfs_print_tree(struct extent_buffer *c, bool follow) in btrfs_print_tree() argument 353 if (!follow) in btrfs_print_tree() 376 btrfs_print_tree(next, follow); in btrfs_print_tree()
|
/Linux-v4.19/Documentation/networking/ |
D | nf_flowtable.txt | 10 Initial packets follow the classic forwarding path, once the flow enters the 28 follow the classic forwarding path unless the user explicitly instruct packets 67 neigh_xmit(). Fragmented traffic is passed up to follow the classic forwarding
|
/Linux-v4.19/Documentation/media/uapi/v4l/ |
D | vidioc-g-dv-timings.rst | 223 - The timings follow the CEA-861 Digital TV Profile standard 225 - The timings follow the VESA Discrete Monitor Timings standard 227 - The timings follow the VESA Coordinated Video Timings standard 229 - The timings follow the VESA Generalized Timings Formula standard 231 - The timings follow the SDI Timings standard.
|
/Linux-v4.19/Documentation/devicetree/bindings/arm/ti/ |
D | k3.txt | 5 shall follow the following scheme:
|
/Linux-v4.19/Documentation/devicetree/bindings/display/panel/ |
D | sgd,gktw70sdae4se.txt | 6 These DT bindings follow the LVDS panel bindings defined in panel-lvds.txt
|
D | mitsubishi,aa121td01.txt | 6 These DT bindings follow the LVDS panel bindings defined in panel-lvds.txt
|
D | mitsubishi,aa104xd12.txt | 6 These DT bindings follow the LVDS panel bindings defined in panel-lvds.txt
|
/Linux-v4.19/fs/coda/ |
D | pioctl.c | 67 if (data.follow) in coda_pioctl()
|
/Linux-v4.19/Documentation/acpi/ |
D | DSD-properties-rules.txt | 45 Valid property sets must follow the guidance given by the Device Properties UUID 52 return property sets which do not follow that rule from _DSD in data packages 78 It often is useful to make _DSD return property sets that follow Device Tree
|
/Linux-v4.19/Documentation/devicetree/bindings/mmc/ |
D | mmc-spi-slot.txt | 14 Write-Protect GPIO. Note that this does not follow the
|
/Linux-v4.19/Documentation/devicetree/bindings/sram/ |
D | rockchip-smp-sram.txt | 14 The rest of the properties should follow the generic mmio-sram discription
|
D | samsung-sram.txt | 17 The rest of the properties should follow the generic mmio-sram discription
|
/Linux-v4.19/drivers/misc/ocxl/ |
D | Kconfig | 29 dedicated OpenCAPI link, and don't follow the same protocol.
|
/Linux-v4.19/Documentation/devicetree/bindings/spi/ |
D | adi,axi-spi-engine.txt | 16 master. They follow the generic SPI bindings as outlined in spi-bus.txt.
|
/Linux-v4.19/Documentation/devicetree/bindings/arm/amlogic/ |
D | smp-sram.txt | 16 The rest of the properties should follow the generic mmio-sram discription
|
/Linux-v4.19/Documentation/devicetree/bindings/net/ |
D | mdio.txt | 11 should follow the generic phy.txt, or a device specific binding document.
|
/Linux-v4.19/drivers/staging/media/ |
D | Kconfig | 7 Most of them don't follow properly the V4L, DVB and/or RC API's,
|
/Linux-v4.19/Documentation/media/uapi/dvb/ |
D | audio-set-id.rst | 49 AC3 and in [0xA0,0xA7] for LPCM. More specifications may follow for
|
/Linux-v4.19/Documentation/devicetree/bindings/connector/ |
D | usb-connector.txt | 30 Source_Capabilities Message, the order of each entry(PDO) should follow 37 Sink Capabilities Message, the order of each entry(PDO) should follow
|
/Linux-v4.19/Documentation/devicetree/bindings/thermal/ |
D | armada-thermal.txt | 14 follow the rules described in:
|
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-platform-eeepc-laptop | 39 is defined as follow:
|
1234567891011