Searched refs:fiber (Results 1 – 14 of 14) sorted by relevance
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | micrel.txt | 39 - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode
41 Some PHYs, such as the KSZ8041FTL variant, support fiber mode, enabled
43 registers whether the PHY is in fiber mode, so this boolean device tree
46 In fiber mode, auto-negotiation is disabled and the PHY can only work in
|
| D | keystone-netcp.txt | 101 - mac<->fiber mode: 3
|
| /Linux-v4.19/drivers/net/phy/ |
| D | marvell.c | 1092 static int marvell_update_link(struct phy_device *phydev, int fiber) in marvell_update_link() argument
1099 if (fiber) { in marvell_update_link()
1116 int fiber) in marvell_read_status_page_an() argument
1157 if (!fiber) { in marvell_read_status_page_an()
1222 int fiber; in marvell_read_status_page() local
1229 fiber = 1; in marvell_read_status_page()
1231 fiber = 0; in marvell_read_status_page()
1233 err = marvell_update_link(phydev, fiber); in marvell_read_status_page()
1238 err = marvell_read_status_page_an(phydev, fiber); in marvell_read_status_page()
|
| /Linux-v4.19/drivers/net/ethernet/alacritech/ |
| D | Kconfig | 23 both copper and fiber.
|
| /Linux-v4.19/drivers/net/hippi/ |
| D | Kconfig | 11 can run over copper (25m) or fiber (300m on multi-mode or 10km on
|
| /Linux-v4.19/drivers/net/fddi/ |
| D | Kconfig | 11 run over copper or fiber. If you are connected to such a network and
|
| /Linux-v4.19/arch/arm64/boot/dts/hisilicon/ |
| D | hip06.dtsi | 540 media-type = "fiber";
548 media-type = "fiber";
|
| D | hip07.dtsi | 1429 media-type = "fiber";
1439 media-type = "fiber";
|
| /Linux-v4.19/Documentation/networking/ |
| D | ixgb.txt | 56 82597EX Intel(R) PRO/10GbE LR/SR/CX4 10G Base-LR (1310 nm optical fiber)
57 Server Adapters 10G Base-SR (850 nm optical fiber)
|
| D | e1000.rst | 339 If the board uses a fiber interface, these keywords are ignored, and the
340 fiber interface board only links at 1000 Mbps full-duplex.
|
| D | dl2k.txt | 204 available for fiber adapter.
|
| D | ixgbe.txt | 75 "ip link set down" turns off the laser for 82599-based SFP+ fiber adapters.
|
| D | cs89x0.txt | 67 or fiber networks).
|
| /Linux-v4.19/drivers/staging/most/Documentation/ |
| D | driver_usage.txt | 11 fiber optics, unshielded twisted pair cables (UTP) and coax cables. MOST
|
