| /Linux-v4.19/Documentation/devicetree/bindings/power/supply/ |
| D | max8925_battery.txt | 5 - batt-detect: whether support battery detect
8 - no-temp-support: whether support temperature protection detect
9 - no-insert-detect: whether support insert detect
13 batt-detect = <0>;
17 no-insert-detect = <0>;
|
| D | sbs,sbs-manager.txt | 39 sbs,battery-detect-gpios = <&batman 1 1>;
51 sbs,battery-detect-gpios = <&batman 2 1>;
63 sbs,battery-detect-gpios = <&batman 3 1>;
|
| D | sbs_sbs-battery.txt | 16 - sbs,battery-detect-gpios : The gpio which signals battery detection and
26 sbs,battery-detect-gpios = <&gpio-controller 122 1>;
|
| D | ltc3651-charger.txt | 15 The driver will attempt to aquire interrupts for all GPIOs to detect changes in
18 attributes to detect changes.
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | rt5640.txt | 35 - realtek,jack-detect-source
37 0: jack-detect is not used
38 1: Use GPIO1 for jack-detect
39 2: Use JD1_IN4P for jack-detect
40 3: Use JD2_IN4N for jack-detect
41 4: Use GPIO2 for jack-detect
42 5: Use GPIO3 for jack-detect
43 6: Use GPIO4 for jack-detect
45 - realtek,jack-detect-not-inverted
46 bool. Normal jack-detect switches give an inverted signal, set this bool
[all …]
|
| D | rt5651.txt | 19 - realtek,jack-detect-source
21 1: Use JD1_1 pin for jack-detect
22 2: Use JD1_2 pin for jack-detect
23 3: Use JD2 pin for jack-detect
|
| D | rt5645.txt | 15 - hp-detect-gpios:
16 a GPIO spec for the external headphone detect pin. If jd-mode = 0,
17 we will get the JD status by getting the value of hp-detect-gpios.
66 hp-detect-gpios = <&gpio 19 0>;
|
| D | st,sta32x.txt | 45 - st,fault-detect-recovery:
71 - st,invalid-input-detect-mute:
72 If present, automatic invalid input detect mute is enabled.
90 st,invalid-input-detect-mute; // mute if no valid digital
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | smsc-lan87xx.txt | 8 - smsc,disable-energy-detect:
9 If set, do not enable energy detect mode for the SMSC phy.
10 default: enable energy detect mode
13 smsc phy with disabled energy detect mode on an am335x based board.
21 smsc,disable-energy-detect;
|
| /Linux-v4.19/arch/x86/kernel/ |
| D | pci-iommu_table.c | 21 if (p->detect == q->depend) in find_dependents_of()
61 p->detect, q->detect); in check_iommu_entries()
71 p->detect, q->detect); in check_iommu_entries()
|
| /Linux-v4.19/sound/firewire/digi00x/ |
| D | digi00x-proc.c | 43 bool detect; in proc_read_clock() local
59 if (snd_dg00x_stream_check_external_clock(dg00x, &detect) < 0) in proc_read_clock()
61 snd_iprintf(buf, "External source: %s\n", detect ? "detected" : "not"); in proc_read_clock()
62 if (!detect) in proc_read_clock()
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/frequency/ |
| D | adf4350.txt | 13 - gpios: GPIO Lock detect - If set with a valid phandle and GPIO number,
24 - adi,lock-detect-precision-6ns-enable: Enables 6ns lock detect precision.
26 - adi,lock-detect-function-integer-n-enable: Enables lock detect
37 5: Analog lock detect
38 6: Digital lock detect
|
| /Linux-v4.19/drivers/input/mouse/ |
| D | psmouse-base.c | 734 .detect = ps2bare_detect,
742 .detect = ps2pp_detect,
749 .detect = thinking_detect,
756 .detect = cypress_detect,
764 .detect = genius_detect,
772 .detect = intellimouse_detect,
781 .detect = im_explorer_detect,
789 .detect = synaptics_detect,
796 .detect = synaptics_detect,
805 .detect = synaptics_detect,
[all …]
|
| /Linux-v4.19/Documentation/media/v4l-drivers/ |
| D | radiotrack.rst | 127 Default: BASE <-- 0xc8 (current volume, no stereo detect,
130 Card Off: BASE <-- 0x00 (audio mute, no stereo detect,
136 Volume Down: BASE <-- 0x48 (volume down, no stereo detect,
141 Volume Up: BASE <-- 0x88 (volume up, no stereo detect,
146 Check Stereo: BASE <-- 0xd8 (current volume, stereo detect,
158 BASE <-- 0x01 (audio mute, no stereo detect, radio
160 BASE <-- 0x03 (audio mute, no stereo detect, radio
163 BASE <-- 0x05 (audio mute, no stereo detect, radio
165 BASE <-- 0x07 (audio mute, no stereo detect, radio
|
| /Linux-v4.19/arch/x86/include/asm/ |
| D | iommu_table.h | 35 initcall_t detect; member
69 #define IOMMU_INIT_POST_FINISH(detect) \ argument
|
| /Linux-v4.19/drivers/char/ipmi/ |
| D | ipmi_poweroff.c | 520 int (*detect)(struct ipmi_user *user); member
526 .detect = ipmi_atca_detect,
529 .detect = ipmi_cpi1_detect,
532 .detect = ipmi_dell_chassis_detect,
535 .detect = ipmi_hp_chassis_detect,
540 .detect = ipmi_chassis_detect,
620 if (poweroff_functions[i].detect(ipmi_user)) in ipmi_po_new_smi()
|
| /Linux-v4.19/Documentation/devicetree/bindings/extcon/ |
| D | extcon-arizona.txt | 12 ARIZONA_ACCDET_MODE_HPL or 1 - Headphone detect mode is set to HPDETL
13 ARIZONA_ACCDET_MODE_HPR or 2 - Headphone detect mode is set to HPDETR
25 - wlf,micd-detect-debounce : Additional software microphone detection
64 wlf,micd-detect-debounce = <0>;
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | stih410-pinctrl.dtsi | 18 usb-oc-detect = <&pio35 0 ALT1 IN>;
27 usb-oc-detect = <&pio35 2 ALT1 IN>;
|
| D | ste-nomadik-s8815.dts | 25 /* This hog will bias the MMC/SD card detect line */
30 line-name = "card detect bias";
141 /* Configure card detect for the uSD slot */
|
| /Linux-v4.19/arch/arm/mach-pxa/ |
| D | palm27x.h | 16 extern void __init palm27x_mmc_init(int detect, int ro, int power,
19 static inline void palm27x_mmc_init(int detect, int ro, int power, in palm27x_mmc_init() argument
|
| /Linux-v4.19/drivers/phy/allwinner/ |
| D | phy-sun4i-usb.c | 159 struct delayed_work detect; member
334 queue_delayed_work(system_wq, &data->detect, 0); in sun4i_usb_phy_init()
451 mod_delayed_work(system_wq, &data->detect, DEBOUNCE_TIME); in sun4i_usb_phy_power_on()
472 mod_delayed_work(system_wq, &data->detect, POLL_TIME); in sun4i_usb_phy_power_off()
507 queue_delayed_work(system_wq, &data->detect, 0); in sun4i_usb_phy_set_mode()
547 container_of(work, struct sun4i_usb_phy_data, detect.work); in sun4i_usb_phy0_id_vbus_det_scan()
614 queue_delayed_work(system_wq, &data->detect, POLL_TIME); in sun4i_usb_phy0_id_vbus_det_scan()
622 mod_delayed_work(system_wq, &data->detect, DEBOUNCE_TIME); in sun4i_usb_phy0_id_vbus_det_irq()
636 mod_delayed_work(system_wq, &data->detect, DEBOUNCE_TIME); in sun4i_usb_phy0_vbus_notify()
664 cancel_delayed_work_sync(&data->detect); in sun4i_usb_phy_remove()
[all …]
|
| /Linux-v4.19/drivers/gpu/drm/omapdrm/ |
| D | omap_connector.c | 68 if (dssdrv->detect) { in omap_connector_detect()
69 if (dssdrv->detect(dssdev)) in omap_connector_detect()
234 .detect = omap_connector_detect,
284 else if (dssdev->driver->detect) in omap_connector_init()
|
| /Linux-v4.19/Documentation/sound/cards/ |
| D | joystick.rst | 43 als4000 joystick_port 0 = disable (default), 1 = auto-detect,
48 ens1371 joystick_port 0 = disable (default), 1 = auto-detect,
50 cmipci joystick_port 0 = disable (default), 1 = auto-detect,
59 ymfpci joystick_port 0 = disable (default), 1 = auto-detect,
|
| /Linux-v4.19/Documentation/i2c/ |
| D | gpio-fault-injection | 22 because the bus master under test will not be able to clock. It should detect
32 master under test should detect this condition and trigger a bus recovery (see
44 there are I2C client devices which detect a stuck SDA on their side and release
46 device deglitching and monitoring the I2C bus. It could also detect a stuck SDA
59 above, the bus master under test should detect this condition and try a bus
|
| /Linux-v4.19/Documentation/devicetree/bindings/mmc/ |
| D | usdhi6rol0.txt | 7 - interrupts: 3 interrupts, named "card detect", "data" and "SDIO" must be
32 interrupt-names = "card detect", "data", "SDIO";
|
