Home
last modified time | relevance | path

Searched refs:autoprobe (Results 1 – 14 of 14) sorted by relevance

/Linux-v4.19/drivers/net/
DSpace.c46 static int __init probe_list2(int unit, struct devprobe2 *p, int autoprobe) in probe_list2() argument
51 if (autoprobe && p->status) in probe_list2()
56 if (autoprobe) in probe_list2()
/Linux-v4.19/Documentation/sound/
Dalsa-configuration.rst135 This module supports multiple cards. It does not support autoprobe, so
169 This module supports multiple cards, autoprobe and PnP.
183 This module supports multiple cards. It does not support autoprobe
210 This module supports one chip and autoprobe.
219 This module supports multiple cards, autoprobe and PnP.
241 This module supports multiple cards, autoprobe and PnP.
274 This module supports one card and autoprobe.
288 This module supports one card and autoprobe.
345 This module supports multiple cards. It does not support autoprobe:
387 This module supports multiple cards. It does not support autoprobe:
[all …]
/Linux-v4.19/kernel/irq/
DMakefile6 obj-$(CONFIG_GENERIC_IRQ_PROBE) += autoprobe.o
DKconfig12 # Enable the generic irq autoprobe mechanism
/Linux-v4.19/drivers/block/paride/
Dparide.c350 int pi_init(PIA * pi, int autoprobe, int port, int mode, in pi_init() argument
363 if (autoprobe) { in pi_init()
421 if (autoprobe) in pi_init()
Dparide.h62 int autoprobe, /* 1 to autoprobe */
/Linux-v4.19/Documentation/admin-guide/
Dparport.rst105 | |-- autoprobe
120 |-- autoprobe
184 ``autoprobe`` Any IEEE-1284 device ID information that has been
187 ``autoprobe[0-3]`` IEEE 1284 device ID information retrieved from
/Linux-v4.19/drivers/block/
Dataflop.c211 int autoprobe; /* !=0 : do autoprobe */ member
1089 if (SUD.autoprobe) { in fd_rwsec_done1()
1457 UD.autoprobe = 1; in redo_fd_request()
1475 UD.autoprobe = 0; in redo_fd_request()
/Linux-v4.19/Documentation/networking/
Dltpc.txt11 While the driver will attempt to autoprobe the I/O port address, IRQ
Darcnet.txt127 chipset driver which will autoprobe if not told where the card is.
134 To disable the autoprobe, just specify "com90xx=" on the kernel command line.
135 To specify the name alone, but allow autoprobe, just put "com90xx=<name>"
517 Starting with v2.40 ALPHA, the autoprobe routines have changed
Dde4x5.txt50 achieved by letting the driver autoprobe as if it were compiled into the
/Linux-v4.19/drivers/parport/
DKconfig160 appear in /proc/sys/dev/parport/*/autoprobe*. It is safe to say N.
/Linux-v4.19/Documentation/blockdev/
Dparide.txt208 you have connected. By default, each driver will autoprobe for a single
/Linux-v4.19/Documentation/filesystems/
Dproc.txt1257 autoprobe Any IEEE-1284 device ID information that has been acquired.