Searched refs:accepts (Results 1 – 25 of 85) sorted by relevance
1234
/Linux-v4.19/drivers/staging/media/davinci_vpfe/ |
D | davinci-vpfe-mc.txt | 68 accepts a pointer to struct vpfe_isif_raw_config as its argument. Similarly 69 VIDIOC_VPFE_IPIPE_S_CONFIG accepts a pointer to struct vpfe_ipipe_config. And 70 VIDIOC_VPFE_RSZ_S_CONFIG accepts a pointer to struct vpfe_rsz_config as its 92 VIDIOC_VPFE_IPIPEIF_G_CONFIG accepts a pointer to struct ipipeif_params
|
/Linux-v4.19/Documentation/devicetree/bindings/clock/ |
D | qcom,rpmh-clk.txt | 5 some Qualcomm Technologies Inc. SoCs. It accepts clock requests from
|
D | qcom,rpmcc.txt | 6 and accepts clock requests, aggregates the requests and turns
|
/Linux-v4.19/include/target/iscsi/ |
D | iscsi_target_stat.h | 49 u32 accepts; member
|
/Linux-v4.19/Documentation/fmc/ |
D | fmc-trivial.txt | 10 accepts are:
|
D | fmc-chardev.txt | 18 The driver assumes all registers are 32-bit in size, and only accepts a
|
/Linux-v4.19/Documentation/arm/SA1100/ |
D | LART | 7 through a number of connectors. The powersupply accepts voltages
|
/Linux-v4.19/Documentation/ |
D | IRQ-domain.txt | 52 by calling irq_create_mapping() which accepts the irq_domain and a 97 accepts an Open Firmware specific 'struct device_node', while the latter 98 accepts a more general abstraction 'struct fwnode_handle'. 121 accepts an Open Firmware specific 'struct device_node', while the latter 122 accepts a more general abstraction 'struct fwnode_handle'.
|
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-driver-toshiba_acpi | 11 Note that from kernel 3.16 onwards this file accepts all listed 12 parameters, kernel 3.15 only accepts the first two (FN-Z and 82 Note that from kernel 4.1 onwards this file accepts all listed
|
D | sysfs-driver-hid-picolcd | 36 Writing: accepts new refresh rate expressed in integer Hz
|
/Linux-v4.19/drivers/clk/qcom/ |
D | Kconfig | 44 memory and accepts clock requests, aggregates the requests and turns 57 memory and accepts clock requests, aggregates the requests and turns 67 SoCs. It accepts requests from other hardware subsystems via RSC.
|
/Linux-v4.19/Documentation/devicetree/bindings/media/ |
D | renesas,drif.txt | 28 two, one of them needs to act as a primary device that accepts common 34 the zeroth channel is selected as primary-bond. This channels accepts
|
/Linux-v4.19/Documentation/leds/ |
D | leds-blinkm.txt | 8 The device accepts RGB and HSB color values through separate commands.
|
/Linux-v4.19/Documentation/media/uapi/v4l/ |
D | vidioc-g-std.rst | 52 :ref:`VIDIOC_S_STD <VIDIOC_G_STD>` accepts one or more flags, being a write-only ioctl it
|
/Linux-v4.19/Documentation/hwmon/ |
D | ads7828 | 23 The ads7828 driver accepts an optional ads7828_platform_data structure (defined
|
D | pcf8591 | 85 "0" for analog output disabled. Writing accepts "0" and "1" accordingly.
|
/Linux-v4.19/net/ax25/ |
D | Kconfig | 56 networking. A DAMA server (called "master") accepts incoming traffic 71 networking. A DAMA server (called "master") accepts incoming traffic
|
/Linux-v4.19/Documentation/devicetree/bindings/interrupt-controller/ |
D | mips-gic.txt | 28 It accepts 2 values, the 1st is the starting interrupt and the 2nd is the size
|
/Linux-v4.19/Documentation/devicetree/bindings/dma/ |
D | st_fdma.txt | 4 supporting 16 independent DMA channels. It accepts up to 32 DMA requests.
|
/Linux-v4.19/Documentation/laptops/ |
D | toshiba_haps.txt | 75 the only parameter it accepts, it is used to trigger
|
/Linux-v4.19/tools/perf/Documentation/ |
D | intel-bts.txt | 83 perf inject also accepts the --itrace option in which case tracing data is
|
/Linux-v4.19/Documentation/virtual/kvm/devices/ |
D | vcpu.txt | 4 The virtual cpu "device" also accepts the ioctls KVM_SET_DEVICE_ATTR,
|
/Linux-v4.19/Documentation/block/ |
D | null_blk.txt | 19 - Directly accepts bio data structure and returns them.
|
/Linux-v4.19/Documentation/devicetree/bindings/pinctrl/ |
D | cnxt,cx92755-pinctrl.txt | 52 The pin group node accepts a subset of the generic pin config properties. For
|
/Linux-v4.19/Documentation/scsi/ |
D | cxgb3i.txt | 28 On transmitting, S3 h/w accepts the complete PDU (header + data)
|
1234