Home
last modified time | relevance | path

Searched refs:VGA (Results 1 – 25 of 91) sorted by relevance

1234

/Linux-v4.19/Documentation/devicetree/bindings/display/connector/
Dvga-connector.txt1 VGA Connector
11 - ddc-i2c-bus: phandle to the I2C bus that is connected to VGA DDC
15 The VGA connector internal connections are modeled using the OF graph bindings
18 The VGA connector has a single port that must be connected to a video source
/Linux-v4.19/Documentation/gpu/
Dvgaarbiter.rst2 VGA Arbiter
6 modern devices allow relocation of such ranges, some "Legacy" VGA devices
13 the legacy VGA arbitration task (besides other bus management tasks) when more
20 the operation of the VGA arbiter implemented for the Linux kernel.
26 scans all PCI devices and adds the VGA ones inside the arbitration. The
27 arbiter then enables/disables the decoding on different devices of the VGA
36 default VGA device of the system.
126 These functions below acquire VGA resources for the given card and mark those
130 legacy resource lock. The arbiter will first look for all VGA cards that
131 might conflict and disable their IOs and/or Memory access, including VGA
[all …]
/Linux-v4.19/drivers/vfio/pci/
DKconfig13 bool "VFIO PCI support for VGA devices"
16 Support for VGA extension to VFIO PCI. This exposes an additional
17 region on VGA devices for accessing legacy VGA addresses used by
/Linux-v4.19/Documentation/ia64/
Daliasing.txt107 several VGA devices.
109 "X" uses this to access VGA frame buffers. Using legacy_mem
111 different VGA cards.
169 mmap of 0x0-0x9FFFF /dev/mem by "hwinfo" on HP sx1000 with VGA enabled
173 0xA0000-0xBFFFF UC only (VGA frame buffer)
179 The kernel VGA driver may ioremap the VGA frame buffer at 0xA0000,
189 supported, as is the case with HP sx[12]000 machines with VGA
193 machines with VGA enabled), we must fail the mmap because there's no
197 that doesn't report the VGA frame buffer at all), we should fail the
200 mmap of 0xA0000-0xBFFFF legacy_mem by "X" on HP sx1000 with VGA disabled
[all …]
Dserial.txt55 configure EFI with a single device (either a UART or a VGA
62 - Without an HCDP, Linux defaults to a VGA console unless you
91 - The EFI console path contains both a VGA device and a UART.
92 EFI and elilo use both, but Linux defaults to VGA. Remove
93 the VGA device from the EFI console path[3].
/Linux-v4.19/Documentation/devicetree/bindings/display/bridge/
Ddumb-vga-dac.txt1 Dumb RGB to VGA DAC bridge
4 This binding is aimed for dumb RGB to VGA DAC based bridges that do not require
17 - Video port 1 for VGA output
Dadi,adv7123.txt4 The ADV7123 is a digital-to-analog converter that outputs VGA signals from a
21 - Video port 1 for VGA output
Dti,ths813x.txt21 - Video port 1 for VGA output
/Linux-v4.19/Documentation/
Dsvga.txt32 EXTENDED_VGA - Standard 8-pixel font mode: 80x43 on EGA, 80x50 on VGA.
68 -- it's either a generic adapter name (MDA, CGA, HGC, EGA, VGA, VESA VGA [a VGA
86 on the VGA BIOS).
133 0x0f01 standard with 8-point font: 80x43 on EGA, 80x50 on VGA
134 0x0f02 VGA 80x43 (VGA switched to 350 scanlines with a 8-point font)
135 0x0f03 VGA 80x28 (standard VGA scans, but 14-point font)
137 0x0f05 VGA 80x30 (480 scans, 16-point font)
138 0x0f06 VGA 80x34 (480 scans, 14-point font)
139 0x0f07 VGA 80x60 (480 scans, 8-point font)
151 0xfffe equivalent to 0x0f01 (EGA 80x43 or VGA 80x50)
[all …]
/Linux-v4.19/Documentation/devicetree/bindings/display/
Dzte,vou.txt6 for typical output devices, like HDMI, TV Encoder, VGA, and RGB LCD.
61 * VGA output device
65 - reg: Physical base address and length of the VGA device IO region
66 - interrupts : VGA interrupt number to CPU
67 - clocks: Phandle with clock-specifier pointing to VGA I2C clock.
71 to control VGA DAC power, and the second cell is the bit mask.
/Linux-v4.19/drivers/gpu/vga/
DKconfig2 bool "VGA Arbitration" if EXPERT
6 Some "legacy" VGA devices implemented on PCI typically have the same
10 enable VGA arbiter.
/Linux-v4.19/lib/fonts/
DKconfig24 bool "VGA 8x8 font" if FONTS
28 This is the "high resolution" font for the VGA frame buffer (the one
31 Note that this is a poor quality font. The VGA 8x16 font is quite a
38 bool "VGA 8x16 font" if FONTS
41 This is the "high resolution" font for the VGA frame buffer (the one
42 provided by the VGA text console 80x25 mode.
/Linux-v4.19/drivers/iio/amplifiers/
DKconfig9 tristate "Analog Devices AD8366 VGA"
14 SPI Dual-Digital Variable Gain Amplifier (VGA).
/Linux-v4.19/Documentation/fb/
Dfbcon.txt6 any standard text console driver, such as the VGA console, with the added
28 systems, they almost universally have VGA cards, so vga16fb and vesafb will
44 will still get a VGA console.
123 NOTE: For x86 machines, the standard console is the VGA console which
125 are controlled by the VGA console will be garbled.
172 the hardware. Thus, in a VGA console:
174 console ---> VGA driver ---> hardware.
176 Assuming the VGA driver can be unloaded, one must first unbind the VGA driver
177 from the console layer before unloading the driver. The VGA driver cannot be
207 usually VGA text mode) will take over. A few drivers (rivafb and i810fb) will
[all …]
/Linux-v4.19/Documentation/media/v4l-drivers/
Dcpia2.rst28 - Supports cameras with the Vision stv6410 (CIF) and stv6500 (VGA) cmos
30 - Image formats: VGA, QVGA, CIF, QCIF, and a number of sizes in between.
31 VGA and QVGA are the native image sizes for the VGA camera. CIF is done
35 - Sensor framerate is adjustable (up to 30 fps CIF, 15 fps VGA).
161 up to CIF, and 15 fps for VGA frames. The STV0676 is an improved version,
162 which can handle up to 30 fps VGA. Both coprocessors can be attached to two
163 CMOS sensors - the vvl6410 CIF sensor and the vvl6500 VGA sensor. These will
164 be referred to as the 410 and the 500 sensors, or the CIF and VGA sensors.
/Linux-v4.19/Documentation/admin-guide/
Dvga-softcursor.rst1 Software cursor for VGA
37 VGA, the high four bits specify background and the low four the
41 of your VGA).
Dserial-console.rst42 virtual console, and kernel messages will appear on both the VGA
49 first looks for a VGA card and then for a serial port. So if you don't
50 have a VGA card in your system the first serial port will automatically
/Linux-v4.19/drivers/video/console/
DKconfig8 bool "VGA text console" if EXPERT || !X86
15 display that complies with the generic VGA standard. Virtually
29 The scrollback buffer of the standard VGA console is located in
30 the VGA RAM. The size of this RAM is fixed and is quite small.
46 buffers of VGA consoles. Each 64KB will give you approximately
78 normal VGA driver will handle it.
/Linux-v4.19/arch/arm/boot/dts/
Dimx25-eukrea-mbimxsd25-baseboard-dvi-vga.dts17 model = "Eukrea MBIMXSD25 with the DVI-VGA Display";
21 model = "DVI-VGA";
/Linux-v4.19/drivers/usb/misc/sisusbvga/
DKconfig21 Say Y here if you want a VGA text console via the USB dongle or
25 Note that this console supports VGA/EGA text mode only.
/Linux-v4.19/drivers/eisa/
Deisa.ids86 ALR3023 "ALR 16-bit VGA without Parallel port"
226 CPQ3001 "Compaq Advanced VGA"
443 DEC8101 "DEC VGA 1024 Graphics Adapter"
445 DEC8103 "DECpc VGA 1024 NI Graphics Adapter"
481 DELFC01 "Dell VGA Professional 16-bit"
508 ELS8041 "ELSA WINNER 1000 Enhanced VGA"
594 ICU0110 "Paradise VGA Plus 16 Video Adapter "
595 ICU0120 "Paradise VGA 1024 Video Adapter "
599 ICU0160 "ATI VGA Wonder XL24 Video Adapter"
700 ICU0780 "Diamond SpeedStar 24X VGA adapter"
[all …]
/Linux-v4.19/Documentation/arm/
DSetup50 or VGA console character size. They should not be used for any other
53 It's generally a good idea to set these to be either standard VGA, or
60 This describes the character position of cursor on VGA console, and
/Linux-v4.19/Documentation/devicetree/bindings/display/panel/
Dedt,et-series.txt16 | ET057090DHU | edt,et057090dhu | 5.7" VGA TFT LCD panel |
/Linux-v4.19/drivers/gpu/drm/bridge/
DKconfig39 tristate "Dumb VGA DAC Bridge support"
43 Support for non-programmable RGB to VGA DAC bridges, such as ADI
/Linux-v4.19/drivers/gpu/drm/imx/
DKconfig19 tristate "Support for TV and VGA displays"

1234