/Linux-v4.19/arch/s390/boot/ |
D | head_kdump.S | 32 jne .Lrelocate # No : Start data mover 33 lghi %r2,0 # Yes: Start kdump kernel 78 basr %r14,%r14 # Start relocated kernel 89 0: lpswe .Lrestart_psw-0b(%r13) # Start new kernel...
|
/Linux-v4.19/tools/testing/selftests/media_tests/ |
D | regression_test.txt | 21 Start media_device_test to regression test media devnode dynamic alloc 34 Start 6 open_loop_test.sh tests with different /dev/mediaX files. When 35 device file goes away after unbind, device file name changes. Start the 41 and number to run bind and unbind. Start the bind_unbind.sh
|
/Linux-v4.19/Documentation/arm64/ |
D | memory.txt | 26 Start End Size Use 34 Start End Size Use 42 Start End Size Use 50 Start End Size Use
|
/Linux-v4.19/init/ |
D | initramfs.c | 181 Start, enumerator 394 [Start] = do_start, 426 state = Start; in flush_buffer() 455 state = Start; in unpack_to_rootfs() 461 state = Start; in unpack_to_rootfs()
|
/Linux-v4.19/arch/nds32/lib/ |
D | memmove.S | 42 add $r0, $r0, $r2 ! Start with the end of $r0 43 add $r1, $r1, $r2 ! Start with the end of $r1
|
/Linux-v4.19/tools/perf/arch/x86/tests/ |
D | gen-insn-x86-dat.awk | 26 / Start here / {
|
/Linux-v4.19/Documentation/input/devices/ |
D | iforce-protocol.rst | 203 01 Start/Stop 205 Val 01: Start and play once. 206 Val 41: Start and play n times (See byte 02 below) 365 2. Start a soft spying RS232 or USB (depending on where you connected your
|
/Linux-v4.19/Documentation/devicetree/bindings/arm/msm/ |
D | qcom,llcc.txt | 19 Definition: Start address and the the size of the register region.
|
/Linux-v4.19/arch/m68k/kernel/ |
D | vmlinux-sun3.lds | 32 _sdata = .; /* Start of rw data section */
|
D | vmlinux-std.lds | 32 _sdata = .; /* Start of data section */
|
/Linux-v4.19/Documentation/media/uapi/v4l/ |
D | vidioc-overlay.rst | 12 VIDIOC_OVERLAY - Start or stop video overlay
|
/Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
D | fsl-imx25-tsadc.txt | 8 - reg: Start address and size of the memory area of
|
/Linux-v4.19/Documentation/networking/caif/ |
D | README | 6 === Start === 29 The use of Start-of-frame-extension (STX) must also be set as
|
/Linux-v4.19/Documentation/isdn/ |
D | README.audio | 48 AT+VRX Start recording. Emulator responds with 81 AT+VTX Start audio playback. Emulator responds
|
/Linux-v4.19/arch/arm/boot/dts/ |
D | imx53-qsb.dts | 10 model = "Freescale i.MX53 Quick Start Board";
|
D | imx53-qsrb.dts | 11 model = "Freescale i.MX53 Quick Start-R Board";
|
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-block-loop | 23 (RO) Start offset (in bytes).
|
/Linux-v4.19/Documentation/arm/ |
D | Porting | 17 Start address of decompressor. There's no point in talking about 25 Start address of zero-initialised work area for the decompressor.
|
/Linux-v4.19/drivers/staging/rtl8723bs/hal/ |
D | hal_com.c | 1528 char *In, u32 *Start, char *Out, char LeftQualifier, char RightQualifier in ParseQualifiedString() argument 1532 char c = In[(*Start)++]; in ParseQualifiedString() 1537 i = (*Start); in ParseQualifiedString() 1538 while ((c = In[(*Start)++]) != RightQualifier) in ParseQualifiedString() 1540 j = (*Start) - 2; in ParseQualifiedString()
|
/Linux-v4.19/drivers/gpu/drm/i810/ |
D | i810_drv.h | 71 unsigned long Start; member
|
/Linux-v4.19/Documentation/filesystems/ |
D | ntfs.txt | 263 Device Boot Start End Blocks Id System 302 the "Start sector of device" when creating the table. Once again ldminfo would 311 # Offset into Size of this Raid type Device Start sector 326 # Offset Size Raid Number Chunk 1st Start 2nd Start 339 # Ofs Size Raid Log Number Region Should Number Source Start Target Start
|
/Linux-v4.19/Documentation/acpi/ |
D | aml-debugger.txt | 31 2. Start the userspace debugger interface
|
/Linux-v4.19/Documentation/usb/ |
D | wusb-cbaf | 30 Start a WUSB host controller (by setting up a CHID)
|
/Linux-v4.19/arch/alpha/lib/ |
D | ev6-csum_ipv6_magic.S | 131 zapnot $0,15,$1 # U : Start folding output (1 cycle stall on $0)
|
/Linux-v4.19/Documentation/media/uapi/rc/ |
D | rc-tables.rst | 224 - Start/stop recording sroweam 405 - Start channel autoscan
|