| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | nau8824.txt | 30 …eshold for each button. Array that contains up to 8 buttons configuration. SAR value is calculated…
31 SAR = 255 * MICBIAS / SAR_VOLTAGE * R / (2000 + R)
47 - nuvoton,sar-compare-time: SAR compare time
53 - nuvoton,sar-sampling-time: SAR sampling time
|
| D | nau8825.txt | 34 …eshold for each button. Array that contains up to 8 buttons configuration. SAR value is calculated…
35 SAR = 255 * MICBIAS / SAR_VOLTAGE * R / (2000 + R)
51 - nuvoton,sar-compare-time: SAR compare time
57 - nuvoton,sar-sampling-time: SAR sampling time
|
| /Linux-v4.19/drivers/dma/ |
| D | txx9dmac.h | 75 u64 SAR; /* Source Address Register */ member
85 u32 SAR; member
209 u64 SAR; member
215 u32 SAR; member
|
| D | txx9dmac.c | 293 channel64_readq(dc, SAR), in txx9dmac_dump_regs()
305 channel32_readl(dc, SAR), in txx9dmac_dump_regs()
319 channel_writeq(dc, SAR, 0); in txx9dmac_reset_chan()
323 channel_writel(dc, SAR, 0); in txx9dmac_reset_chan()
478 (u64)desc->CHAR, desc->SAR, desc->DAR, desc->CNTR); in txx9dmac_dump_desc()
483 (u64)desc->CHAR, desc->SAR, desc->DAR, desc->CNTR, in txx9dmac_dump_desc()
491 d->CHAR, d->SAR, d->DAR, d->CNTR); in txx9dmac_dump_desc()
496 d->CHAR, d->SAR, d->DAR, d->CNTR, in txx9dmac_dump_desc()
759 desc->hwdesc.SAR = src + offset; in txx9dmac_prep_dma_memcpy()
765 desc->hwdesc32.SAR = src + offset; in txx9dmac_prep_dma_memcpy()
[all …]
|
| D | idma64.c | 98 channel_writeq(idma64c, SAR, 0); in idma64_chan_start()
|
| D | pl330.c | 340 SAR = 0, enumerator
718 dst == SAR ? "SAR" : (dst == DAR ? "DAR" : "CCR"), val); in _emit_MOV()
1376 off += _emit_MOV(dry_run, &buf[off], SAR, x->src_addr); in _setup_xfer()
|
| /Linux-v4.19/Documentation/devicetree/bindings/iio/adc/ |
| D | amlogic,meson-saradc.txt | 1 * Amlogic Meson SAR (Successive Approximation Register) A/D converter
18 - "core" for the SAR ADC core clock
|
| D | rockchip-saradc.txt | 1 Rockchip Successive Approximation Register (SAR) A/D Converter bindings
|
| /Linux-v4.19/arch/sh/include/asm/ |
| D | dma-register.h | 17 #define SAR 0x00 /* Source Address Register */ macro
|
| /Linux-v4.19/drivers/i2c/busses/ |
| D | i2c-rcar.c | 68 #define SAR (1 << 0) /* slave addr received */ macro
577 if (ssr_filtered & SAR) { in rcar_i2c_slave_irq()
582 rcar_i2c_write(priv, ICSIER, SDE | SSR | SAR); in rcar_i2c_slave_irq()
586 rcar_i2c_write(priv, ICSIER, SDR | SSR | SAR); in rcar_i2c_slave_irq()
589 rcar_i2c_write(priv, ICSSR, ~SAR & 0xff); in rcar_i2c_slave_irq()
595 rcar_i2c_write(priv, ICSIER, SAR | SSR); in rcar_i2c_slave_irq()
849 rcar_i2c_write(priv, ICSIER, SAR | SSR); in rcar_reg_slave()
|
| /Linux-v4.19/drivers/net/wireless/ath/ath9k/ |
| D | Kconfig | 89 TX99 support enables Specific Absorption Rate (SAR) testing.
90 SAR is the unit of measurement for the amount of radio frequency(RF)
92 limits used are expressed in the terms of SAR, which is a measure
97 governmental SAR regulations.
|
| /Linux-v4.19/Documentation/devicetree/bindings/clock/ |
| D | mvebu-core-clock.txt | 4 reading the Sample-At-Reset (SAR) register. The core clock consumer should
66 - reg : shall be the register address of the Sample-At-Reset (SAR) register
|
| /Linux-v4.19/drivers/dma/sh/ |
| D | shdmac.c | 42 #define SAR 0x00 /* Source Address Register */ macro
221 sh_dmae_writel(sh_chan, hw->sar, SAR); in dmae_set_reg()
464 u32 sar_buf = sh_dmae_readl(sh_chan, SAR); in sh_dmae_desc_completed()
|
| /Linux-v4.19/arch/sh/drivers/dma/ |
| D | dma-sh.c | 222 __raw_writel(chan->sar, (dma_base_addr(chan->chan) + SAR)); in sh_dmac_xfer_dma()
|
| /Linux-v4.19/drivers/dma/dw/ |
| D | regs.h | 43 DW_REG(SAR); /* Source Address Register */
|
| D | core.c | 202 channel_readl(dwc, SAR), in dwc_dump_chan_regs()
262 channel_writel(dwc, SAR, lli_read(desc, sar)); in dwc_do_single_block()
|
| /Linux-v4.19/arch/xtensa/kernel/ |
| D | coprocessor.S | 246 ssl a3 # SAR: 32 - coprocessor_number
|
| D | entry.S | 1244 ssr a0 # save in SAR for later.
1506 rsr a3, sar # WB is still in SAR
|
| /Linux-v4.19/arch/arm/mach-omap2/ |
| D | sleep44xx.S | 148 ldreq r0, [r8, #L2X0_SAVE_OFFSET0] @ Retrieve L2 state from SAR
|
| /Linux-v4.19/Documentation/parisc/ |
| D | registers | 14 CR11 as specified by ABI (SAR)
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | armada-xp-synology-ds414.dts | 72 * pin being sampled at reset (bit 0 of SAR).
|
| /Linux-v4.19/drivers/iio/adc/ |
| D | Kconfig | 528 tristate "Amlogic Meson SAR ADC driver"
533 Say yes here to build support for the SAR ADC found in Amlogic Meson
|
| /Linux-v4.19/tools/objtool/arch/x86/lib/ |
| D | x86-opcode-map.txt | 894 7: SAR
|
| /Linux-v4.19/tools/perf/util/intel-pt-decoder/ |
| D | x86-opcode-map.txt | 894 7: SAR
|
| /Linux-v4.19/arch/x86/lib/ |
| D | x86-opcode-map.txt | 894 7: SAR
|
