Searched refs:Ready (Results 1 – 19 of 19) sorted by relevance
7 Ready Flag to being set prior to committing a new value to the sample11 Writing '1' will remove the polling for the Conversion Ready Flags to
11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
24 - allwinner,rb : shall contain the native Ready/Busy ids.
15 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
41 - rb-gpios: the GPIO(s) used to check the Ready/Busy status of the NAND.44 - atmel,rb: an integer identifying the native Ready/Busy pin. Only meaningful
50 - nand-rb: shall contain the native Ready/Busy ids.
124 int Active, Ready; member317 card->mm_pages[card->Ready].cnt > 0) { in activate()318 card->Active = card->Ready; in activate()319 card->Ready = 1-card->Ready; in activate()361 if (card->mm_pages[card->Ready].cnt >= DESC_PER_PAGE) in add_bio()373 p = &card->mm_pages[card->Ready]; in add_bio()887 card->Ready = 0; /* page 0 is ready */ in mm_pci_probe()
241 u8 Ready:1; member252 u8 Ready:1; member263 u8 Ready:1; member604 if (info->SD_Status.Insert && info->SD_Status.Ready) in sd_scsi_test_unit_ready()1457 if (info->MS_Status.Insert && info->MS_Status.Ready) { in ms_scsi_test_unit_ready()2103 if (info->MS_Status.Insert && info->MS_Status.Ready) { in ene_ms_init()2105 printk(KERN_INFO "Ready = %x\n", info->MS_Status.Ready); in ene_ms_init()2171 if (info->SD_Status.Insert && info->SD_Status.Ready) { in ene_sd_init()2176 usb_stor_dbg(us, "Ready = %x\n", s->Ready); in ene_sd_init()2202 if (!info->SD_Status.Ready) { in ene_init()[all …]
95 - Add support for fbdev drivers.- Ready and part of subsequent patches.
89 5. Data Ready (DRI)
450 printf ("Ready.\n");456 printf ("Drive Not Ready.\n");
106 Ready-made header files for various distros are in the UDP-Lite tarball.
149 - Allow Test Unit Ready commands to take a full 5 seconds
559 vii. Added print : FW now in Ready State during initialization
917 "Re: [Emulex] Ready for next round. This patch cleans up the memory
345 #define Ready 0x00000000 macro
310 field SPIORDY 0x02 /* SCSI PIO Ready */
1924 field SPIORDY 0x02 /* SCSI PIO Ready */
1266 USR3401 "U S Robotics V.34-Ready Fax Modem"
