Searched refs:RECONNECT (Results 1 – 2 of 2) sorted by relevance
| /Linux-v4.19/Documentation/scsi/ |
| D | aha152x.txt | 22 RECONNECT allow targets to disconnect from the bus (0/1; default 1 [on])
37 -DSETUP0="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }"
40 -DSETUP1="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }"
52 aha152x=<IOPORT>[,<IRQ>[,<SCSI-ID>[,<RECONNECT>[,<PARITY>[,<SYNCHRONOUS>[,<DELAY> [,<EXT_TRANS]]]]]…
67 aha152x=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS
71 aha152x1=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS
|
| /Linux-v4.19/drivers/scsi/ |
| D | aha152x.c | 557 #define RECONNECT (HOSTDATA(shpnt)->reconnect) macro
754 RECONNECT = setup->reconnect; in aha152x_probe_one()
791 RECONNECT ? "enabled" : "disabled", in aha152x_probe_one()
1538 ADDMSGO(IDENTIFY(RECONNECT, CURRENT_SC->device->lun)); in seldo_run()
1703 if (!RECONNECT) in msgi_run()
1843 ADDMSGO(IDENTIFY(RECONNECT, CURRENT_SC->device->lun)); in msgo_init()
2830 RECONNECT ? "enabled" : "disabled"); in aha152x_show_info()
|
