Searched refs:NS2 (Results 1 – 15 of 15) sorted by relevance
| /Linux-v4.19/tools/testing/selftests/net/ |
| D | msg_zerocopy.sh | 15 readonly NS2="${NSPREFIX}2"
74 ip netns del "${NS2}"
86 ip netns add "${NS2}"
89 peer name "${DEV}" mtu "${DEV_MTU}" netns "${NS2}"
93 ip -netns "${NS2}" link set "${DEV}" up
97 ip -netns "${NS2}" link set dev "${DEV}" address 06:06:06:06:06:06
101 ip -netns "${NS2}" addr add 192.168.1.2/24 dev "${DEV}"
103 ip -netns "${NS2}" addr add fd::2/64 dev "${DEV}" nodad
112 …ip netns exec "${NS2}" "${BIN}" "-${IP}" -i "${DEV}" -t 2 -C 2 -S "${SADDR}" -D "${DADDR}" ${ARGS}…
|
| /Linux-v4.19/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,ns2.txt | 1 Broadcom North Star 2 (NS2) device tree bindings
4 Boards with NS2 shall have the following properties:
8 NS2 SVK board
|
| /Linux-v4.19/Documentation/devicetree/bindings/spi/ |
| D | brcm,spi-bcm-qspi.txt | 4 BRCMSTB (BCM7XXX), Cygnus, NSP and NS2. The Broadcom Master SPI hw IP consits
30 "brcm,spi-bcm-qspi", "brcm,spi-ns2-qspi" : NS2 SoCs
43 NSP, NS2, Cygnus SoC
181 NS2 SoC Example:
201 m25p80 node for NSP, NS2
|
| /Linux-v4.19/samples/bpf/ |
| D | test_lwt_bpf.sh | 8 NS2=lwt_ns2
46 ip netns delete $NS2 2> /dev/null
367 setup_one_veth $NS2 $VETH2 $VETH3 $IPVETH2 $IPVETH3
|
| /Linux-v4.19/drivers/pinctrl/bcm/ |
| D | Kconfig | 36 The Broadcom iProc based SoCs- Cygnus, NS2, NSP and Stingray, use
48 The Broadcom NS2 has two GPIO controller including the CRMU GPIO,
101 Say yes here to enable the Broadcom NS2 MUX driver.
|
| /Linux-v4.19/Documentation/devicetree/bindings/phy/ |
| D | brcm,mdio-mux-bus-pci.txt | 1 * Broadcom NS2 PCIe PHY binding document
|
| D | brcm,ns2-drd-phy.txt | 5 - reg: offset and length of the NS2 PHY related registers.
|
| /Linux-v4.19/Documentation/devicetree/bindings/usb/ |
| D | iproc-udc.txt | 10 For Broadcom NS2 platform, add "brcm,ns2-udc","brcm,iproc-udc".
|
| /Linux-v4.19/Documentation/devicetree/bindings/pci/ |
| D | brcm,iproc-pcie.txt | 6 used in SoCs including NSP, Cygnus, NS2, and Pegasus
10 controller, used in NS2
|
| /Linux-v4.19/drivers/block/drbd/ |
| D | drbd_state.h | 40 #define NS2(T1, S1, T2, S2) \ macro
|
| D | drbd_nl.c | 2684 rv = conn_request_state(connection, NS2(conn, C_DISCONNECTING, pdsk, D_OUTDATED), 0); in conn_try_disconnect()
2692 rv = conn_request_state(connection, NS2(conn, C_DISCONNECTING, in conn_try_disconnect()
|
| D | drbd_receiver.c | 4431 conn_request_state(peer_device->connection, NS2(conn, C_PROTOCOL_ERROR, susp, 0), CS_HARD); in receive_state()
|
| /Linux-v4.19/arch/arm64/boot/dts/broadcom/northstar2/ |
| D | ns2-xmc.dts | 38 model = "Broadcom NS2 XMC";
|
| D | ns2-svk.dts | 38 model = "Broadcom NS2 SVK";
|
| /Linux-v4.19/drivers/spi/ |
| D | Kconfig | 144 Select this option for any one of BRCMSTB, iProc NSP and NS2 SoCs
|
