| /Linux-v4.19/arch/arm64/boot/dts/hisilicon/ |
| D | hi3660-hikey960.dts | 203 * NC = not connected (pin out but not routed from the chip to
246 "NC", "NC",
249 "NC";
255 "NC", "NC", "NC",
269 "NC",
274 "NC";
280 "NC", "NC",
284 "NC", "NC", "NC";
294 "NC", "NC",
302 "NC", "NC", "NC",
[all …]
|
| D | hi6220-hikey.dts | 160 * NC = not connected (not routed from the SoC)
190 "WL_HOST_WAKE", "NC", "NC", "NC", "BT_REG_ON";
205 gpio-line-names = "GPIO3_0", "NC", "NC", "", "NC", "",
206 "WLAN_ACTIVE", "NC", "NC";
211 "USER_LED4", "SD_SEL", "NC", "NC", "BT_ACTIVE";
215 gpio-line-names = "NC", "NC",
218 "[AUX_SSI1]", "NC",
229 "NC", "NC", "NC",
234 gpio-line-names = "NC", "NC", "NC", "NC",
237 "NC", "NC";
[all …]
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | bcm2835-rpi-b-rev2.dts | 25 * "NC" = not connected (no rail from the SoC)
41 "NC", /* GPIO12 */
42 "NC", /* GPIO13 */
49 "NC", /* GPIO19 */
50 "NC", /* GPIO20 */
56 "NC", /* GPIO26 */
62 "NC", /* GPIO32 */
63 "NC", /* GPIO33 */
64 "NC", /* GPIO34 */
65 "NC", /* GPIO35 */
[all …]
|
| D | bcm2835-rpi-a.dts | 24 * "NC" = not connected (no rail from the SoC)
40 "NC", /* GPIO12 */
41 "NC", /* GPIO13 */
48 "NC", /* GPIO19 */
49 "NC", /* GPIO20 */
55 "NC", /* GPIO26 */
62 "NC", /* GPIO32 */
63 "NC", /* GPIO33 */
64 "NC", /* GPIO34 */
65 "NC", /* GPIO35 */
[all …]
|
| D | bcm2835-rpi-b.dts | 25 * "NC" = not connected (no rail from the SoC)
41 "NC", /* GPIO12 */
42 "NC", /* GPIO13 */
49 "NC", /* GPIO19 */
50 "NC", /* GPIO20 */
56 "NC", /* GPIO26 */
63 "NC", /* GPIO32 */
64 "NC", /* GPIO33 */
65 "NC", /* GPIO34 */
66 "NC", /* GPIO35 */
[all …]
|
| D | bcm2835-rpi-zero.dts | 33 * "NC" = not connected (no rail from the SoC)
68 "NC", /* GPIO30 */
69 "NC", /* GPIO31 */
71 "NC", /* GPIO33 */
72 "NC", /* GPIO34 */
73 "NC", /* GPIO35 */
74 "NC", /* GPIO36 */
75 "NC", /* GPIO37 */
76 "NC", /* GPIO38 */
77 "NC", /* GPIO39 */
[all …]
|
| D | bcm2835-rpi-a-plus.dts | 30 * "NC" = not connected (no rail from the SoC)
65 "NC", /* GPIO30 */
66 "NC", /* GPIO31 */
68 "NC", /* GPIO33 */
69 "NC", /* GPIO34 */
71 "NC", /* GPIO36 */
72 "NC", /* GPIO37 */
74 "NC", /* GPIO39 */
77 "NC", /* GPIO42 */
78 "NC", /* GPIO43 */
[all …]
|
| D | bcm2835-rpi-zero-w.dts | 45 * "NC" = not connected (no rail from the SoC)
80 "NC", /* GPIO30 */
81 "NC", /* GPIO31 */
82 "NC", /* GPIO32 */
83 "NC", /* GPIO33 */
84 "NC", /* GPIO34 */
85 "NC", /* GPIO35 */
86 "NC", /* GPIO36 */
87 "NC", /* GPIO37 */
88 "NC", /* GPIO38 */
[all …]
|
| D | bcm2835-rpi-b-plus.dts | 32 * "NC" = not connected (no rail from the SoC)
67 "NC", /* GPIO30 */
70 "NC", /* GPIO33 */
71 "NC", /* GPIO34 */
73 "NC", /* GPIO36 */
74 "NC", /* GPIO37 */
76 "NC", /* GPIO39 */
79 "NC", /* GPIO42 */
80 "NC", /* GPIO43 */
|
| D | tegra124-apalis-v1.2.dtsi | 1123 pc7 { /* NC */
1130 pg0 { /* NC */
1137 pg1 { /* NC */
1144 pg2 { /* NC */
1151 pg3 { /* NC */
1158 pg4 { /* NC */
1165 ph4 { /* NC */
1172 ph5 { /* NC */
1179 ph6 { /* NC */
1186 ph7 { /* NC */
[all …]
|
| D | tegra124-apalis.dtsi | 1156 pc7 { /* NC */
1163 pg0 { /* NC */
1170 pg1 { /* NC */
1177 pg2 { /* NC */
1184 pg3 { /* NC */
1191 pg4 { /* NC */
1198 ph4 { /* NC */
1205 ph5 { /* NC */
1212 ph6 { /* NC */
1219 ph7 { /* NC */
[all …]
|
| D | armada-385-linksys.dtsi | 246 /* J10: VCC, NC, RX, NC, TX, GND */
|
| D | bcm2835-rpi-cm1-io1.dts | 16 * "NC" = not connected (no rail from the SoC)
|
| D | armada-xp-linksys-mamba.dts | 53 /* J10: VCC, NC, RX, NC, TX, GND */
|
| /Linux-v4.19/arch/arm64/boot/dts/qcom/ |
| D | apq8016-sbc.dtsi | 24 * NC = not connected (pin out but not routed from the chip to
125 "NC",
126 "NC", /* GPIO 50 */
127 "NC",
128 "NC",
129 "NC",
130 "NC",
131 "NC",
132 "NC",
133 "NC",
[all …]
|
| D | apq8096-db820c.dtsi | 24 * NC = not connected (pin out but not routed from the chip to
174 "NC", /* GPIO_12 */
235 "NC", /* GPIO_73 */
236 "NC", /* GPIO_74 */
237 "NC", /* GPIO_75 */
238 "NC", /* GPIO_76 */
240 "NC", /* GPIO_78 */
254 "NC", /* GPIO_92 */
259 "NC", /* GPIO_97 */
261 "NC", /* GPIO_99 */
[all …]
|
| /Linux-v4.19/tools/testing/selftests/bpf/ |
| D | test_tunnel.sh | 52 NC='\033[0m' # No Color
291 echo -e ${RED}"FAIL: $TYPE"${NC}
294 echo -e ${GREEN}"PASS: $TYPE"${NC}
321 echo -e ${RED}"FAIL: $TYPE"${NC}
324 echo -e ${GREEN}"PASS: $TYPE"${NC}
350 echo -e ${RED}"FAIL: $TYPE"${NC}
353 echo -e ${GREEN}"PASS: $TYPE"${NC}
374 echo -e ${RED}"FAIL: $TYPE"${NC}
377 echo -e ${GREEN}"PASS: $TYPE"${NC}
397 echo -e ${RED}"FAIL: $TYPE"${NC}
[all …]
|
| D | test_lirc_mode2.sh | 15 NC='\033[0m' # No Color
33 echo -e ${RED}"FAIL: $TYPE"${NC}
35 echo -e ${GREEN}"PASS: $TYPE"${NC}
|
| /Linux-v4.19/Documentation/devicetree/bindings/net/ |
| D | ftgmac100.txt | 20 - use-ncsi: Use the NC-SI stack instead of an MDIO PHY. Currently assumes
21 rmii (100bT) but kept as a separate property in case NC-SI grows support
|
| /Linux-v4.19/Documentation/media/v4l-drivers/ |
| D | gspca-cardlist.rst | 123 zc3xx 0471:0325 Philips SPC 200 NC
124 zc3xx 0471:0326 Philips SPC 300 NC
125 sonixj 0471:0327 Philips SPC 600 NC
126 sonixj 0471:0328 Philips SPC 700 NC
127 zc3xx 0471:032d Philips SPC 210 NC
128 zc3xx 0471:032e Philips SPC 315 NC
129 sonixj 0471:0330 Philips SPC 710 NC
283 pac207 093a:2463 Philips SPC 220 NC
292 pac7311 093a:2601 Philips SPC 610 NC
293 pac7311 093a:2603 Philips SPC 500 NC
[all …]
|
| /Linux-v4.19/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp-zcu111-revA.dts | 229 /* NC */
352 /* 7 NC */
371 /* NC */
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | qcom,msm8916-wcd-analog.txt | 43 its assumed that hphl pin on jack is NC
47 its assumed that gnd pin on jack is NC
|
| /Linux-v4.19/Documentation/hwmon/ |
| D | smsc47b397 | 5 * SMSC LPC47B397-NC
17 The following specification describes the SMSC LPC47B397-NC[1] sensor chip
|
| /Linux-v4.19/drivers/net/ethernet/dec/tulip/ |
| D | de4x5.c | 2410 lp->media = NC; in dc21040_autoconf()
2438 NC, EXT_SIA_SUSPECT, ping_media); in dc21040_autoconf()
2445 case NC: in dc21040_autoconf()
2566 lp->media = NC; in dc21041_autoconf()
2707 lp->media = NC; in dc21041_autoconf()
2724 case NC: in dc21041_autoconf()
2792 lp->media = NC; in dc21140m_autoconf()
2862 lp->media = NC; in dc21140m_autoconf()
2902 case NC: in dc21140m_autoconf()
4446 lp->media = NC; in dc21140_infoleaf()
[all …]
|
| /Linux-v4.19/Documentation/sound/soc/ |
| D | dapm.rst | 307 and pins that are NC respectively.
322 order to save power. e.g. NC codecs pins will be switched OFF, unconnected
|
