Home
last modified time | relevance | path

Searched refs:IDE (Results 1 – 25 of 96) sorted by relevance

1234

/Linux-v4.19/drivers/ide/
DKconfig2 # IDE ATA ATAPI Block device driver configuration
5 # Select HAVE_IDE if IDE is supported
9 menuconfig IDE config
15 If you say Y here, your kernel will be able to manage ATA/(E)IDE and
16 ATAPI units. The most common cases are IDE hard drives and ATAPI
31 if IDE
33 comment "Please see Documentation/ide/ide.txt for help/info on IDE drives"
59 The IDE driver (which you are currently configuring) supports
63 this config option enables the IDE driver's SATA support.
65 supports SATA controllers, and this (IDE) driver supports
[all …]
/Linux-v4.19/Documentation/m68k/
DREADME.buddha2 The Amiga Buddha and Catweasel IDE Driver (part of ide.c) was written by
7 Register map of the Buddha IDE controller and the
44 $800-$8ff IDE-Select 0 (Port 0, Register set 0)
46 $900-$9ff IDE-Select 1 (Port 0, Register set 1)
48 $a00-$aff IDE-Select 2 (Port 1, Register set 0)
50 $b00-$bff IDE-Select 3 (Port 1, Register set 1)
52 $c00-$cff IDE-Select 4 (Port 2, Register set 0,
55 $d00-$dff IDE-Select 5 (Port 3, Register set 1,
63 level of the IRQ-line of IDE port 0.
68 level of the IRQ-line of IDE port 1.
[all …]
D00-INDEX4 - Amiga Buddha and Catweasel IDE Driver
/Linux-v4.19/Documentation/ide/
Dide.txt2 Information regarding the Enhanced IDE drive in Linux 2.6
7 The hdparm utility can be used to control various IDE features on a
13 *** IMPORTANT NOTICES: BUGGY IDE CHIPSETS CAN CORRUPT DATA!!
40 - 40-conductor IDE cables are capable of transferring data in DMA modes up to
54 This is the multiple IDE interface driver, as evolved from hd.c.
56 It supports up to 9 IDE interfaces per default, on one or more IRQs (usually
70 This driver automatically probes for most IDE interfaces (including all PCI
76 The IDE driver automatically detects and handles this. However, this may
106 Note that when only one IDE device is attached to an interface, it should be
125 interface (/dev/hda) and an IDE cdrom drive on the secondary interface
[all …]
Dide-tape.txt1 IDE ATAPI streaming tape driver.
15 ht0 major 37, minor 0 first IDE tape, rewind on close.
16 ht1 major 37, minor 1 second IDE tape, rewind on close.
18 nht0 major 37, minor 128 first IDE tape, no rewind on close.
19 nht1 major 37, minor 129 second IDE tape, no rewind on close.
38 Testing was done with a 2 GB CONNER CTMA 4000 IDE ATAPI Streaming Tape Drive.
59 same purpose - efficient use of the IDE bus, but is interrupt
D00-INDEX10 - info on the IDE ATAPI streaming tape driver
12 - important info for users of ATA devices (IDE/EIDE disks and CD-ROMS).
14 - using sysfs to remove and add IDE devices.
DChangeLog.ide-tape.1995-200219 * 1. An IDE ATAPI TAPE shares the same interface
20 * and irq with an IDE ATAPI CDROM.
21 * 2. An IDE ATAPI TAPE shares the same interface
22 * and irq with a normal IDE disk.
25 * recommended to give the IDE TAPE its own interface
94 * typically results in better IDE bus efficiency and
117 * now sometimes be used with IDE tape drives as well.
Dwarm-plug-howto.txt2 IDE warm-plug HOWTO
/Linux-v4.19/drivers/ata/
Data_piix.c126 IDE = -1, /* IDE */ enumerator
364 { P0, P1, IDE, IDE }, /* 100b */
365 { P1, P0, IDE, IDE }, /* 101b */
366 { IDE, IDE, P0, P1 }, /* 110b */
367 { IDE, IDE, P1, P0 }, /* 111b */
377 { IDE, IDE, P1, P3 }, /* 01b */
378 { P0, P2, IDE, IDE }, /* 10b */
394 { IDE, IDE, P1, P3 }, /* 01b */
395 { P0, P2, IDE, IDE }, /* 10b */
407 { P0, P2, IDE, IDE }, /* 10b (IDE mode) */
[all …]
DKconfig289 bool "ATA SFF support (for legacy IDE and PATA)"
295 SFF is the legacy IDE interface that has been around since
554 This option enables support for the integrated IDE controller on
618 IDE controller found on some older machines.
726 Enable support for the JMicron IDE controller, via the new
732 tristate "Apple PowerMac/PowerBook internal 'MacIO' IDE"
735 Most IDE capable PowerMacs have IDE busses driven by a variant
752 tristate "Freescale MPC52xx SoC internal IDE"
756 This option enables support for integrated IDE controller
784 NS87415 PCI-IDE controller.
[all …]
/Linux-v4.19/Documentation/devicetree/bindings/ata/
Dcortina,gemini-sata-bridge.txt20 ata0 slave interface brought out on IDE pads
23 ata1 slave interface brought out on IDE pads
27 on IDE pads
31 on IDE pads
34 - cortina,gemini-enable-ide-pins: enables the PATA to IDE connection.
/Linux-v4.19/drivers/zorro/
Dzorro.ids135 0800 Impact 3001 [IDE Interface]
152 0d00 Impact 3001 [IDE Interface]
190 0600 Tandem AT-2008/508 [IDE Interface]
217 0300 Advantage [IDE Interface]
238 0600 Tandem AT-2008/508 [IDE Interface]
311 0400 MasterCard MC702 [SCSI Host Adapter and IDE Interface]
314 0100 [IDE Interface]
342 0100 AT500 [IDE Interface]
348 2400 Viper Mk V/E-Matrix 530 [SCSI Host Adapter and IDE Interface]
365 0800 FastATA 1200 [IDE Interface]
[all …]
/Linux-v4.19/Documentation/mips/
DAU1xxx_IDE.README1 README for MIPS AU1XXX IDE driver - Released 2005-07-15
38 Note: for more information, please refer "AMD Alchemy Au1200/Au1550 IDE
53 contains the functionality of the AU1XXX IDE driver
61 SUPPORTED IDE MODES
64 The AU1XXX IDE driver supported all PIO modes - PIO mode 0/1/2/3/4 - and all
91 high IDE to USB throughput.
109 IDE driver from AMD.
D00-INDEX4 - README for MIPS AU1XXX IDE driver.
/Linux-v4.19/drivers/block/paride/
DKconfig9 comment "Parallel IDE high-level drivers"
13 tristate "Parallel port IDE disks"
16 This option enables the high-level driver for IDE-type disk devices
19 parallel port IDE driver, otherwise you should answer M to build
95 comment "Parallel IDE protocol modules"
102 This option enables support for the ATEN EH-100 parallel port IDE
116 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
134 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
152 This option enables support for the Commuter parallel port IDE
163 This option enables support for the EP-2000 parallel port IDE
[all …]
/Linux-v4.19/Documentation/arm/SA1100/
DPangolin5 PCMCIA/IDE card and TFT-LCD card.
23 - IDE driver (experimental)
/Linux-v4.19/Documentation/cdrom/
Dide-cd1 IDE-CD driver documentation
10 CDROM drives which attach to an IDE interface. Note that some CDROM vendors
17 (CyCDROM CR520ie) which attaches to the IDE port but is not ATAPI;
53 entitled "Floppy, IDE, and other block devices", say either `Y'
59 Include IDE/ATAPI CDROM support
61 Depending on what type of IDE interface you have, you may need to
70 3. The CDROM drive should be connected to the host on an IDE
80 on the primary IDE interface are called `hda' and `hdb',
86 driver, you should make sure your IDE interface uses either the
88 the CDROM drive is the only device on the IDE interface, it should
[all …]
D00-INDEX8 - info on setting up and using ATAPI (aka IDE) CD-ROMs.
/Linux-v4.19/arch/sh/boards/mach-microdev/
Dirq.c60 # error Inconsistancy in defining the IRQ# for secondary IDE!
64 # error Inconsistancy in defining the IRQ# for primary IDE!
/Linux-v4.19/Documentation/arm/Samsung-S3C24XX/
DEB2410ITX.txt45 IDE
48 Both onboard IDE ports are supported, however there is no support for
/Linux-v4.19/Documentation/blockdev/
Dparide.txt2 Linux and parallel port IDE devices
18 The adapter chip reproduces a small ISA or IDE bus in the external device
26 IDE type devices, which require no intermediate controller. If one
30 IDE cable. It is usually possible to exchange the CD-ROM device with
31 any other device using the IDE interface.
33 The document describes the support in Linux for parallel port IDE
36 parallel port IDE subsystem, including:
52 To support such a wide range of devices, PARIDE, the parallel port IDE
58 pd IDE disk
68 for each of the parallel port IDE adapter chips. Thanks to the interest
[all …]
/Linux-v4.19/Documentation/admin-guide/
Ddevices.txt115 3 block First MFM, RLL and IDE hard disk/CD-ROM interface
207 Partitions are handled in the same way as for IDE
518 Partitions are handled the same way as for IDE disks
525 22 block Second IDE hard disk/CD-ROM interface
637 Partitions are handled in the same way as for IDE
721 33 block Third IDE hard disk/CD-ROM interface
739 34 block Fourth IDE hard disk/CD-ROM interface
773 37 char IDE tape
774 0 = /dev/ht0 First IDE tape
775 1 = /dev/ht1 Second IDE tape
[all …]
/Linux-v4.19/Documentation/ioctl/
Dhdio.txt9 the HD/IDE layer. These are by-and-large implemented (as of Linux 2.6)
19 HDIO_GET_MULTCOUNT get current IDE blockmode setting
28 HDIO_GET_IDENTITY get IDE identification info
42 HDIO_SET_MULTCOUNT change IDE blockmode
166 HDIO_GET_MULTCOUNT get current IDE blockmode setting
176 The value of the current IDE block mode setting. This
182 HDIO_SET_MULTCOUNT change IDE blockmode
190 New value for IDE block mode setting. This controls how many
234 HDIO_GET_IDENTITY get IDE identification info
365 bandwidth to other devices sharing the same IDE bus.
[all …]
/Linux-v4.19/Documentation/
Dsgi-ioc4.txt9 IDE controller, a serial controller, a PS/2 keyboard/mouse controller,
39 This is the IDE driver for IOC4. Its name isn't very descriptive
/Linux-v4.19/Documentation/arm/
DIXP4xx112 Finally, there is an IDE port hanging off the expansion bus.
118 replaced with mini-PCI slots and a CF IDE interface hanging off
154 - Add support for Coyote IDE
156 - Add support for CF IDE on expansion bus

1234