Searched refs:HS (Results 1 – 25 of 84) sorted by relevance
1234
| /Linux-v4.19/drivers/net/can/usb/ |
| D | Kconfig | 39 - Kvaser Leaf Professional HS
40 - Kvaser Leaf SemiPro HS
46 - Kvaser Memorator II HS/HS
47 - Kvaser USBcan Professional HS/HS
49 - Kvaser Leaf Professional HS (OBD-II connector)
50 - Kvaser Memorator Professional HS/LS
55 - Kvaser Mini PCI Express HS
58 - Kvaser USBcan II HS/HS
59 - Kvaser USBcan II HS/LS
61 - Kvaser Memorator HS/HS
[all …]
|
| /Linux-v4.19/arch/sparc/kernel/ |
| D | viohs.c | 60 viodbg(HS, "SEND VERSION INFO maj[%u] min[%u] devclass[%u]\n", in send_version()
70 viodbg(HS, "START HANDSHAKE\n"); in start_handshake()
144 viodbg(HS, "HANDSHAKE FAILURE\n"); in handshake_failure()
165 viodbg(HS, "UNKNOWN CONTROL [%02x:%02x:%04x:%08x]\n", in process_unknown()
201 viodbg(HS, "SEND DRING_REG INFO ndesc[%u] dsz[%u] opt[0x%x] " in send_dreg()
209 viodbg(HS, "DRING COOKIE(%d) [%016llx:%016llx]\n", in send_dreg()
226 viodbg(HS, "SEND RDX INFO\n"); in send_rdx()
261 viodbg(HS, "GOT VERSION INFO maj[%u] min[%u] devclass[%u]\n", in process_ver_info()
278 viodbg(HS, "SEND VERSION NACK maj[0] min[0]\n"); in process_ver_info()
284 viodbg(HS, "SEND VERSION NACK maj[%u] min[%u]\n", in process_ver_info()
[all …]
|
| /Linux-v4.19/Documentation/devicetree/bindings/i2c/ |
| D | i2c-imx.txt | 1 * Freescale Inter IC (I2C) and High Speed Inter IC (HS-I2C) for i.MX
8 - reg : Should contain I2C/HS-I2C registers location and length
9 - interrupts : Should contain I2C/HS-I2C interrupt
10 - clocks : Should contain the I2C/HS-I2C clock specifier
13 - clock-frequency : Constains desired I2C/HS-I2C bus clock frequency in Hz.
30 i2c@70038000 { /* HS-I2C on i.MX51 */
|
| D | i2c-sirf.txt | 10 - clock-frequency : Constains desired I2C/HS-I2C bus clock frequency in Hz.
|
| /Linux-v4.19/Documentation/devicetree/bindings/usb/ |
| D | dwc2.txt | 1 Platform DesignWare HS OTG USB 2.0 controller
18 - "st,stm32f4x9-fsotg": The DWC2 USB FS/HS controller instance in STM32F4x9 SoCs
20 - "st,stm32f4x9-hsotg": The DWC2 USB HS controller instance in STM32F4x9 SoCs
21 configured in HS mode;
22 - "st,stm32f7-hsotg": The DWC2 USB HS controller instance in STM32F7 SoCs
23 configured in HS mode;
|
| D | qcom,dwc3.txt | 14 operation and >= 60MHz for HS operation
31 >=60Mhz (60000000) for MASTER_CLK in HS mode
47 HS/FS/LS modes are supported.
|
| D | ohci-omap3.txt | 1 OMAP HS USB OHCI controller (OMAP3 and later)
|
| /Linux-v4.19/drivers/phy/st/ |
| D | Kconfig | 36 tristate "STMicroelectronics STM32 USB HS PHY Controller driver"
45 used by an HS USB Host controller, and the second one is shared
46 between an HS USB OTG controller and an HS USB Host controller,
|
| /Linux-v4.19/Documentation/devicetree/bindings/arc/ |
| D | archs-pct.txt | 1 * ARC HS Performance Counters
3 The ARC HS can be configured with a pipeline performance monitor for counting
|
| D | hsdk.txt | 1 Synopsys DesignWare ARC HS Development Kit Device Tree Bindings
|
| /Linux-v4.19/Documentation/devicetree/bindings/phy/ |
| D | nvidia,tegra20-usb-phy.txt | 45 - Either one of the following for HS driver output control:
54 - nvidia,xcvr-hsslew : HS slew rate control.
55 - nvidia,hssquelch-level : HS squelch detector level.
56 - nvidia,hsdiscon-level : HS disconnect detector level.
|
| /Linux-v4.19/Documentation/devicetree/bindings/connector/ |
| D | samsung,usb-connector-11pin.txt | 19 0: High Speed (HS),
27 Micro-USB connector with HS lines routed via controller (MUIC) and MHL lines
|
| D | usb-connector.txt | 50 0: High Speed (HS), present in all connectors,
57 1. Micro-USB connector with HS lines routed via controller (MUIC):
68 2. USB-C connector attached to CC controller (s2mm005), HS lines routed
|
| /Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
| D | twl4030-audio.txt | 16 -ti,ramp_delay_value: HS ramp delay configuration to reduce pop noise
17 -ti,hs_extmute: Use external mute for HS pop reduction
|
| /Linux-v4.19/arch/arm/mach-omap2/ |
| D | sleep44xx.S | 72 cmp r9, #0x1 @ Check for HS device
106 cmp r9, #0x1 @ Check for HS device
209 cmp r9, #0x1 @ Check for HS device
292 cmp r1, #0x1 @ Check for HS device
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | omap3-cm-t3x.dtsi | 24 /* HS USB Port 1 Power */
33 /* HS USB Port 2 Power */
42 /* HS USB Host PHY on PORT 1 */
49 /* HS USB Host PHY on PORT 2 */
|
| D | omap3-beagle-xm-ab.dts | 12 /* HS USB Port 2 Power enable was inverted with the xM C */
|
| D | omap3-evm-common.dtsi | 16 /* HS USB Port 2 Power */
27 /* HS USB Host PHY on PORT 2 */
|
| D | stih410-b2260.dts | 118 label = "HS-I2C2";
125 label = "HS-I2C3";
|
| /Linux-v4.19/Documentation/devicetree/bindings/timer/ |
| D | snps,archs-gfrc.txt | 1 Synopsys ARC Free Running 64-bit Global Timer for ARC HS CPUs
|
| D | snps,archs-rtc.txt | 1 Synopsys ARC Free Running 64-bit Local Timer for ARC HS CPUs
|
| /Linux-v4.19/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp-zcu100-revC.dts | 166 label = "HS-I2C2";
172 label = "HS-I2C3";
257 label = "HS-SPI1";
|
| /Linux-v4.19/arch/arm/plat-omap/ |
| D | Kconfig | 93 bool "OMAP3 HS/EMU save and restore for L2 AUX control register"
98 lost during off-mode entry on HS/EMU devices. This feature
99 requires support from PPA / boot-loader in HS/EMU devices, which
|
| /Linux-v4.19/arch/arc/plat-hsdk/ |
| D | Kconfig | 9 bool "ARC HS Development Kit SOC"
|
| /Linux-v4.19/Documentation/devicetree/bindings/interrupt-controller/ |
| D | snps,archs-intc.txt | 1 * ARC-HS incore Interrupt Controller (Provided by cores implementing ARCv2 ISA)
|
1234
