Home
last modified time | relevance | path

Searched refs:DSL (Results 1 – 17 of 17) sorted by relevance

/Linux-v4.19/drivers/usb/atm/
DKconfig2 # USB/ATM DSL configuration
6 tristate "USB DSL modem support"
11 Say Y here if you want to connect a USB Digital Subscriber Line (DSL)
45 tristate "ADI 930 and eagle USB DSL modem"
57 tristate "Other USB DSL modem support"
59 Say Y here if you have a DSL USB modem not explicitly supported by
60 another USB DSL drivers. In order to use your modem you will need to
/Linux-v4.19/Documentation/devicetree/bindings/arm/bcm/
Dbrcm,bcm63138.txt1 Broadcom BCM63138 DSL System-on-a-Chip device tree bindings
4 Boards compatible with the BCM63138 DSL System-on-a-Chip should have the
/Linux-v4.19/arch/arm/boot/dts/
Dbcm63138.dtsi3 * Broadcom BCM63138 DSL SoCs Device Tree
13 model = "Broadcom BCM63138 DSL SoC";
/Linux-v4.19/drivers/clk/bcm/
DKconfig7 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
/Linux-v4.19/Documentation/devicetree/bindings/gpio/
Dgpio-stp-xway.txt5 3 groups of 8 bits can be driven. The hardware is able to allow the DSL modem
/Linux-v4.19/arch/arm/mach-bcm/
DKconfig189 bool "Broadcom BCM63xx DSL SoC"
202 This enables support for systems based on Broadcom DSL SoCs.
/Linux-v4.19/drivers/isdn/
DKconfig15 (though still much slower than with DSL) or to make and accept
/Linux-v4.19/net/atm/
DKconfig65 This is sometimes used over DSL lines. If in doubt, say N.
/Linux-v4.19/Documentation/devicetree/bindings/mips/brcm/
Dsoc.txt1 * Broadcom cable/DSL/settop platforms
/Linux-v4.19/drivers/net/ethernet/dec/tulip/
Dde2104x.c89 #define DSL 0 macro
91 #define DSL CONFIG_DE2104X_DSL macro
165 DescSkipLen = (DSL << 2),
280 #if DSL
281 __le32 skip[DSL];
/Linux-v4.19/sound/pci/emu10k1/
Demu10k1_callback.c411 snd_emu10k1_ptr_write(hw, DSL, ch, temp); in start_voice()
Demu10k1_main.c84 snd_emu10k1_ptr_write(emu, DSL, ch, 0x10); in snd_emu10k1_voice_init()
2082 CPF, PTRX, CVCF, VTFT, Z1, Z2, PSST, DSL, CCCA, CCR, CLP,
Demupcm.c362 snd_emu10k1_ptr_write(emu, DSL, voice, end_addr | (send_amount[3] << 24)); in snd_emu10k1_pcm_init_voice()
/Linux-v4.19/include/sound/
Demu10k1.h411 #define DSL 0x07 /* Send D amount and loop start address register */ macro
/Linux-v4.19/drivers/atm/
DKconfig38 have the code to drive the on-board Alcatel DSL chipset (yet).
/Linux-v4.19/drivers/tty/serial/
DKconfig1150 BCM63xx/BCM63xxx (DSL)
/Linux-v4.19/arch/mips/
DKconfig249 BCM33xx cable modem chips, BCM63xx DSL chips, and BCM7xxx set-top