Searched refs:AC (Results 1 – 25 of 72) sorted by relevance
123
/Linux-v4.19/Documentation/ABI/testing/ |
D | sysfs-devices-platform-ACPI-TAD | 10 BIT(0): AC wakeup implemented if set 15 BIT(5): The AC timer wakes up from S4 if set 16 BIT(6): The AC timer wakes up from S5 if set 26 (RW) The AC alarm timer value. 28 Reads return the current AC alarm timer value in seconds or 29 "disabled", if the AC alarm is not set to wake up the system. 31 Write a new AC alarm timer value in seconds or "disabled" to it 32 to set the AC alarm timer or to disable it, respectively. 34 If the AC alarm timer is set through this attribute and it 43 (RW) The AC alarm expired timer wake policy (see ACPI 6.2, [all …]
|
D | sysfs-platform-dptf | 14 Must be 0 if no AC Adaptor is plugged in. 31 0x01 = AC
|
/Linux-v4.19/Documentation/devicetree/bindings/power/supply/ |
D | tps65217_charger.txt | 5 -interrupts: TPS65217 interrupt numbers for the AC and USB charger input change. 6 Should be <0> for the USB charger and <1> for the AC adapter. 7 -interrupt-names: Should be "USB" and "AC" 16 interrupt-names = "USB", "AC";
|
D | axp20x_ac_power.txt | 1 AXP20X and AXP22X PMICs' AC power supply 10 The AXP20X can read the current current and voltage supplied by AC by 13 The AXP22X is only able to tell if an AC power supply is present and
|
D | ti,bq24735.txt | 8 - interrupts : Specify the interrupt to be used to trigger when the AC 10 - ti,ac-detect-gpios : This GPIO is optionally used to read the AC adapter 13 the GPIO must be active on AC adapter absence despite ACOK being active 14 (high) on AC adapter presence. 30 - poll-interval : In case 'interrupts' is not specified, poll AC adapter
|
D | lp8727_charger.txt | 11 AC and USB charging parameters 30 /* AC charger: 5% EOC and 500mA charging current */
|
/Linux-v4.19/Documentation/devicetree/bindings/sound/ |
D | cs43130.txt | 32 Boolean, define to enable headphone AC impedance measurement. 33 DC impedance must also be enabled for AC impedance measurement. 40 Define the frequencies at which to measure HP AC impedance.
|
D | fsl-asoc-card.txt | 16 Note: The card is initially designed for those sound cards who use AC'97, I2S 18 AC'97/I2S/PCM type sound cards, such as S/PDIF audio and HDMI audio, as
|
/Linux-v4.19/Documentation/devicetree/bindings/lpddr2/ |
D | lpddr2-timings.txt | 1 * AC timing parameters of LPDDR2(JESD209-2) memories for a given speed-bin 10 The following properties represent AC timing parameters from the memory
|
D | lpddr2.txt | 19 The following optional properties represent the minimum value of some AC 36 "lpddr2-timings" provides AC timing parameters of the device for
|
/Linux-v4.19/Documentation/devicetree/bindings/display/ |
D | cirrus,clps711x-fb.txt | 12 - ac-prescale : LCD AC bias frequency. This frequency is the required 13 AC bias frequency for a given manufacturer's LCD plate.
|
/Linux-v4.19/Documentation/networking/ |
D | proc_net_tcp.txt | 12 46: 010310AC:9C4C 030310AC:1770 01
|
/Linux-v4.19/Documentation/memory-devices/ |
D | ti-emif.txt | 28 functions of the driver includes re-configuring AC timing 37 - Device AC timings: 'struct lpddr2_timings' and 'struct lpddr2_min_tck'
|
/Linux-v4.19/Documentation/devicetree/bindings/display/tilcdc/ |
D | panel.txt | 6 - ac-bias: AC Bias Pin Frequency 7 - ac-bias-intrpt: AC Bias Pin Transitions per Interrupt
|
/Linux-v4.19/drivers/staging/nvec/ |
D | nvec_power.c | 64 AC, enumerator 388 case AC: in nvec_power_probe() 426 case AC: in nvec_power_remove()
|
/Linux-v4.19/arch/powerpc/math-emu/ |
D | math.c | 152 #define AC 3 macro 273 case FMULS: func = fmuls; type = AC; break; in do_mathemu() 293 case FMUL: func = fmul; type = AC; break; in do_mathemu() 337 case AC: in do_mathemu()
|
/Linux-v4.19/sound/ac97/ |
D | Kconfig | 13 devices around an AC-Link.
|
/Linux-v4.19/sound/soc/txx9/ |
D | Kconfig | 8 This option enables support for the AC Link Controllers in TXx9 SoC.
|
/Linux-v4.19/sound/arm/ |
D | Kconfig | 15 tristate "ARM PrimeCell PL041 AC Link support"
|
/Linux-v4.19/drivers/staging/iio/Documentation/ |
D | sysfs-bus-iio-ad7192 | 5 This attribute, if available, is used to enable the AC
|
/Linux-v4.19/arch/arm/boot/dts/ |
D | tps65217.dtsi | 22 interrupt-names = "USB", "AC";
|
/Linux-v4.19/Documentation/acpi/ |
D | method-customizing.txt | 36 Method (\_SB_.AC._PSR, 0, NotSerialized) 38 Store ("In AC _PSR", Debug)
|
/Linux-v4.19/Documentation/cpuidle/ |
D | driver.txt | 21 It can also support the dynamic changes (like battery <-> AC), by using
|
/Linux-v4.19/Documentation/power/ |
D | 00-INDEX | 24 - Tells userspace about battery, UPS, AC or DC power supply properties
|
D | power_supply_class.txt | 6 Power supply class used to represent battery, UPS, AC or DC power supply 25 AC/USB power supply online status. (Note that specific details of the 176 External power supply (AC) lists supplicants (batteries) names in
|
123