1# SPDX-License-Identifier: GPL-2.0
2if NLM_XLP_BOARD || NLM_XLR_BOARD
3
4if NLM_XLP_BOARD
5config DT_XLP_EVP
6	bool "Built-in device tree for XLP EVP boards"
7	default y
8	select BUILTIN_DTB
9	help
10	  Add an FDT blob for XLP EVP boards into the kernel.
11	  This DTB will be used if the firmware does not pass in a DTB
12	  pointer to the kernel.  The corresponding DTS file is at
13	  arch/mips/netlogic/dts/xlp_evp.dts
14
15config DT_XLP_SVP
16	bool "Built-in device tree for XLP SVP boards"
17	default y
18	select BUILTIN_DTB
19	help
20	  Add an FDT blob for XLP VP boards into the kernel.
21	  This DTB will be used if the firmware does not pass in a DTB
22	  pointer to the kernel.  The corresponding DTS file is at
23	  arch/mips/netlogic/dts/xlp_svp.dts
24
25config DT_XLP_FVP
26	bool "Built-in device tree for XLP FVP boards"
27	default y
28	select BUILTIN_DTB
29	help
30	  Add an FDT blob for XLP FVP board into the kernel.
31	  This DTB will be used if the firmware does not pass in a DTB
32	  pointer to the kernel.  The corresponding DTS file is at
33	  arch/mips/netlogic/dts/xlp_fvp.dts
34
35config DT_XLP_GVP
36	bool "Built-in device tree for XLP GVP boards"
37	default y
38	select BUILTIN_DTB
39	help
40	  Add an FDT blob for XLP GVP board into the kernel.
41	  This DTB will be used if the firmware does not pass in a DTB
42	  pointer to the kernel.  The corresponding DTS file is at
43	  arch/mips/netlogic/dts/xlp_gvp.dts
44
45config DT_XLP_RVP
46	bool "Built-in device tree for XLP RVP boards"
47	default y
48	help
49	  Add an FDT blob for XLP RVP board into the kernel.
50	  This DTB will be used if the firmware does not pass in a DTB
51	  pointer to the kernel.  The corresponding DTS file is at
52	  arch/mips/netlogic/dts/xlp_rvp.dts
53
54config NLM_MULTINODE
55	bool "Support for multi-chip boards"
56	depends on NLM_XLP_BOARD
57	default n
58	help
59	  Add support for boards with 2 or 4 XLPs connected over ICI.
60
61if NLM_MULTINODE
62choice
63	prompt "Number of XLPs on the board"
64	default NLM_MULTINODE_2
65	help
66	  In the multi-node case, specify the number of SoCs on the board.
67
68config NLM_MULTINODE_2
69	bool "Dual-XLP board"
70	help
71	  Support boards with upto two XLPs connected over ICI.
72
73config NLM_MULTINODE_4
74	bool "Quad-XLP board"
75	help
76	  Support boards with upto four XLPs connected over ICI.
77
78endchoice
79
80endif
81endif
82
83config NLM_COMMON
84	bool
85
86endif
87