1The cafe_ccic driver
2====================
3
4Author: Jonathan Corbet <corbet@lwn.net>
5
6Introduction
7------------
8
9"cafe_ccic" is a driver for the Marvell 88ALP01 "cafe" CMOS camera
10controller.  This is the controller found in first-generation OLPC systems,
11and this driver was written with support from the OLPC project.
12
13Current status: the core driver works.  It can generate data in YUV422,
14RGB565, and RGB444 formats.  (Anybody looking at the code will see RGB32 as
15well, but that is a debugging aid which will be removed shortly).  VGA and
16QVGA modes work; CIF is there but the colors remain funky.  Only the OV7670
17sensor is known to work with this controller at this time.
18
19To try it out: either of these commands will work:
20
21.. code-block:: none
22
23     $ mplayer tv:// -tv driver=v4l2:width=640:height=480 -nosound
24     $ mplayer tv:// -tv driver=v4l2:width=640:height=480:outfmt=bgr16 -nosound
25
26The "xawtv" utility also works; gqcam does not, for unknown reasons.
27
28Load time options
29-----------------
30
31There are a few load-time options, most of which can be changed after
32loading via sysfs as well:
33
34 - alloc_bufs_at_load:  Normally, the driver will not allocate any DMA
35   buffers until the time comes to transfer data.  If this option is set,
36   then worst-case-sized buffers will be allocated at module load time.
37   This option nails down the memory for the life of the module, but
38   perhaps decreases the chances of an allocation failure later on.
39
40 - dma_buf_size: The size of DMA buffers to allocate.  Note that this
41   option is only consulted for load-time allocation; when buffers are
42   allocated at run time, they will be sized appropriately for the current
43   camera settings.
44
45 - n_dma_bufs: The controller can cycle through either two or three DMA
46   buffers.  Normally, the driver tries to use three buffers; on faster
47   systems, however, it will work well with only two.
48
49 - min_buffers: The minimum number of streaming I/O buffers that the driver
50   will consent to work with.  Default is one, but, on slower systems,
51   better behavior with mplayer can be achieved by setting to a higher
52   value (like six).
53
54 - max_buffers: The maximum number of streaming I/O buffers; default is
55   ten.  That number was carefully picked out of a hat and should not be
56   assumed to actually mean much of anything.
57
58 - flip: If this boolean parameter is set, the sensor will be instructed to
59   invert the video image.  Whether it makes sense is determined by how
60   your particular camera is mounted.
61