1* Rockchip RK3xxx I2C controller 2 3This driver interfaces with the native I2C controller present in Rockchip 4RK3xxx SoCs. 5 6Required properties : 7 8 - reg : Offset and length of the register set for the device 9 - compatible: should be one of the following: 10 - "rockchip,rv1108-i2c": for rv1108 11 - "rockchip,rk3066-i2c": for rk3066 12 - "rockchip,rk3188-i2c": for rk3188 13 - "rockchip,rk3228-i2c": for rk3228 14 - "rockchip,rk3288-i2c": for rk3288 15 - "rockchip,rk3328-i2c", "rockchip,rk3399-i2c": for rk3328 16 - "rockchip,rk3399-i2c": for rk3399 17 - interrupts : interrupt number 18 - clocks: See ../clock/clock-bindings.txt 19 - For older hardware (rk3066, rk3188, rk3228, rk3288): 20 - There is one clock that's used both to derive the functional clock 21 for the device and as the bus clock. 22 - For newer hardware (rk3399): specified by name 23 - "i2c": This is used to derive the functional clock. 24 - "pclk": This is the bus clock. 25 26Required on RK3066, RK3188 : 27 28 - rockchip,grf : the phandle of the syscon node for the general register 29 file (GRF) 30 - on those SoCs an alias with the correct I2C bus ID (bit offset in the GRF) 31 is also required. 32 33Optional properties : 34 35 - clock-frequency : SCL frequency to use (in Hz). If omitted, 100kHz is used. 36 - i2c-scl-rising-time-ns : Number of nanoseconds the SCL signal takes to rise 37 (t(r) in I2C specification). If not specified this is assumed to be 38 the maximum the specification allows(1000 ns for Standard-mode, 39 300 ns for Fast-mode) which might cause slightly slower communication. 40 - i2c-scl-falling-time-ns : Number of nanoseconds the SCL signal takes to fall 41 (t(f) in the I2C specification). If not specified this is assumed to 42 be the maximum the specification allows (300 ns) which might cause 43 slightly slower communication. 44 - i2c-sda-falling-time-ns : Number of nanoseconds the SDA signal takes to fall 45 (t(f) in the I2C specification). If not specified we'll use the SCL 46 value since they are the same in nearly all cases. 47 48Example: 49 50aliases { 51 i2c0 = &i2c0; 52} 53 54i2c0: i2c@2002d000 { 55 compatible = "rockchip,rk3188-i2c"; 56 reg = <0x2002d000 0x1000>; 57 interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>; 58 #address-cells = <1>; 59 #size-cells = <0>; 60 61 rockchip,grf = <&grf>; 62 63 clock-names = "i2c"; 64 clocks = <&cru PCLK_I2C0>; 65 66 i2c-scl-rising-time-ns = <800>; 67 i2c-scl-falling-time-ns = <100>; 68}; 69