Searched full:wish (Results 1 – 25 of 396) sorted by relevance
12345678910>>...16
| /Linux-v6.6/drivers/mtd/chips/ |
| D | Kconfig | 12 for probing the capabilities of flash devices. If you wish to
37 chips, or if you wish to reduce the size of the kernel by including
88 If you wish to support CFI devices on a physical bus which is
95 If you wish to support CFI devices on a physical bus which is
102 If you wish to support CFI devices on a physical bus which is
109 If you wish to support CFI devices on a physical bus which is
116 If you wish to support CFI devices on a physical bus which is
124 If you wish to support CFI devices on a physical bus which is
|
| /Linux-v6.6/sound/core/ |
| D | pcm_iec958.c | 25 * Drivers may wish to tweak the contents of the buffer after creation.
128 * Drivers may wish to tweak the contents of the buffer after its been
151 * Drivers may wish to tweak the contents of the buffer after its been
172 * Drivers may wish to tweak the contents of the buffer after creation.
198 * Drivers may wish to tweak the contents of the buffer after creation.
|
| /Linux-v6.6/Documentation/riscv/ |
| D | patch-acceptance.rst | 15 tested code over experimental code. We wish to extend these same
45 that contain code for any draft extensions that they wish.)
59 code for any custom extensions that they wish.)
|
| /Linux-v6.6/drivers/tty/serial/ |
| D | Kconfig | 37 Say Y here if you wish to use an AMBA PrimeCell UART as the system
65 Say Y here if you wish to use an AMBA PrimeCell UART as the system
145 Say Y here if you wish to use an on-chip UART on a Atmel
155 Say Y here if you wish to use the PDC to do DMA transfers to
169 Say Y here if you wish to have the internal AT91 UARTs
215 Say Y here if you wish to use a Amlogic MesonX UART as the
523 Say Y here if you wish to use a Xilinx uartlite as the system
776 Say Y here if you wish to use a SCC or SMC CPM UART as the system
1176 Say Y here if you wish to use the PCH UART as the system console
1419 based on the Armada-3700 SoC and wish to use the on-board serial
[all …]
|
| /Linux-v6.6/include/linux/ |
| D | delayed_call.h | 6 * Poor man's closures; I wish we could've done them sanely polymorphic,
17 /* I really wish we had closures with sane typechecking... */
|
| /Linux-v6.6/drivers/net/appletalk/ |
| D | Kconfig | 11 wish to connect to it, say Y. You will need to use the netatalk package
37 on a network. If your Linux box is connected to such a network, and wish
38 to do IP over it, or you have a LocalTalk card and wish to use it to
|
| /Linux-v6.6/drivers/staging/media/ |
| D | Kconfig | 13 If you wish to work on these drivers, to help improve them, or
50 If you wish to work on these drivers to prevent their removal,
|
| /Linux-v6.6/Documentation/powerpc/ |
| D | mpc52xx.rst | 12 if you wish to ).
24 if you wish to ).
|
| /Linux-v6.6/Documentation/trace/coresight/ |
| D | coresight-perf.rst | 122 If you wish to see how this changes over time, simply run perf test
156 You may wish to set these above environment variables if you wish to
|
| /Linux-v6.6/arch/mips/generic/ |
| D | Kconfig | 17 and you wish to include code which helps translate various
58 enable this if you wish to boot on a MIPS Boston board, as it is
|
| /Linux-v6.6/scripts/kconfig/ |
| D | mconf.c | 50 " wish to change or the submenu you wish to select and press <Enter>.\n"
80 "o Use the cursor keys to select the option you wish to set and press\n"
83 " Shortcut: Press the first letter of the option you wish to set then\n"
190 "press the hotkey of the item you wish to select "
207 "Enter the name of the configuration file you wish to load. "
212 "For various reasons, one may wish to keep several different\n"
226 "For various reasons, one may wish to keep different configurations\n"
967 "Do you wish to save your new configuration?\n" in handle_exit()
|
| /Linux-v6.6/drivers/mtd/ |
| D | Kconfig | 89 permitted to copy, modify and distribute the code as you wish. Just
106 permitted to copy, modify and distribute the code as you wish. Just
131 permitted to copy, modify and distribute the code as you wish. Just
|
| /Linux-v6.6/arch/mips/kernel/ |
| D | cmpxchg.c | 24 * Calculate a shift & mask that correspond to the value we wish to in __xchg_small()
66 * Calculate a shift & mask that correspond to the value we wish to in __cmpxchg_small()
|
| /Linux-v6.6/drivers/net/ethernet/hisilicon/ |
| D | Kconfig | 46 If you wish to compile a kernel for a hardware with hisilicon p04 SoC and
53 If you wish to compile a kernel for a hardware with hisilicon hi13x1_gamc
|
| /Linux-v6.6/drivers/reset/ |
| D | Kconfig | 261 available on some new TI's SoCs. If you wish to use reset resources
271 you wish to use the reset framework for such memory-mapped devices,
279 you wish to use the reset framework for such devices, say Y here.
|
| /Linux-v6.6/security/ |
| D | Kconfig | 171 If you wish for all usermode helper programs are to be
181 program is wish to be run. The "real" application's name will
185 If you wish for all usermode helper programs to be disabled,
|
| /Linux-v6.6/Documentation/ABI/ |
| D | README | 51 Users: All users of this interface who wish to be notified when
82 wish for it to start out in.
|
| /Linux-v6.6/drivers/net/wireless/ath/ath11k/ |
| D | mac.h | 60 /* These macros should be used when we wish to advertise STBC support for
96 /* These macros should be used when we wish to advertise STBC support for
|
| /Linux-v6.6/Documentation/trace/ |
| D | user_events.rst | 17 Typically programs will register a set of events that they wish to expose to
90 subsystem named "user_events". This means tools that wish to attach to the
236 User programs might have well known structs that they wish to use to emit out
|
| /Linux-v6.6/drivers/char/ipmi/ |
| D | Kconfig | 143 Say YES if you wish to expose KCS devices on the BMC for IPMI
157 Say YES if you wish to expose KCS devices on the BMC via SerIO
|
| /Linux-v6.6/Documentation/admin-guide/ |
| D | spkguide.txt | 67 with the keyword for whatever synthesizer you wish to use. The
208 of commands is arranged in alphabetical order. If you wish to jump to
210 the alphabet you wish to jump to.
509 ways. For example, you might wish to know what level your volume is set
533 Depending on your situation, you may wish to echo none to the synth
555 the synthesizer driver you wish to use. The driver modules are all
857 You may, for example, wish to change how Speakup pronounces the z
860 you might wish to use the zee pronunciation instead of zed. You can
881 values for the upper and lower case z, the characters we wish to change.
1097 You will have to repeat these steps for any change of locale, i.e. if you wish
[all …]
|
| /Linux-v6.6/fs/omfs/ |
| D | Kconfig | 12 and wish to mount its disk.
|
| /Linux-v6.6/arch/sh/include/asm/ |
| D | sh7760fb.h | 135 * wish to use. The following members must be initialized:
182 /* set this member to 1 if you wish to use the LCDC's hardware
|
| /Linux-v6.6/Documentation/admin-guide/device-mapper/ |
| D | unstriped.rst | 23 The block device you wish to unstripe.
27 drive you wish to unstripe. This must be 0 indexed.
|
| /Linux-v6.6/drivers/usb/storage/ |
| D | uas-detect.h | 145 "required by the UAS driver. Please try an other USB controller if you wish to use UAS.\n"); in uas_use_uas_driver()
154 "Please try an other USB controller if you wish to use UAS.\n"); in uas_use_uas_driver()
|
12345678910>>...16
