Home
last modified time | relevance | path

Searched +full:tx +full:- +full:level +full:- +full:trig (Results 1 – 18 of 18) sorted by relevance

/Linux-v6.6/Documentation/devicetree/bindings/spi/
Dspi-pl022.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/spi/spi-pl022.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
13 - $ref: spi-controller.yaml#
14 - $ref: /schemas/arm/primecell.yaml#
23 - compatible
28 - const: arm,pl022
29 - const: arm,primecell
[all …]
/Linux-v6.6/arch/arm64/boot/dts/broadcom/northstar2/
Dns2-svk.dts33 /dts-v1/;
39 compatible = "brcm,ns2-svk", "brcm,ns2";
49 stdout-path = "serial0:115200n8";
113 spi-max-frequency = <5000000>;
114 spi-cpha;
115 spi-cpol;
118 pl022,slave-tx-disable = <0>;
119 pl022,com-mode = <0>;
120 pl022,rx-level-trig = <1>;
121 pl022,tx-level-trig = <1>;
[all …]
/Linux-v6.6/arch/arm/boot/dts/st/
Dspear1310-evb.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1310-evb", "st,spear1310";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
63 smi-pmx {
127 label = "u-boot";
149 compatible = "gpio-keys";
[all …]
Dspear1340-evb.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1340-evb", "st,spear1340";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
47 spdif-in {
51 spdif-out {
59 smi-pmx {
[all …]
/Linux-v6.6/drivers/iio/adc/
Dti-tsc2046.c1 // SPDX-License-Identifier: GPL-2.0
23 * The PENIRQ of TSC2046 controller is implemented as level shifter attached to
24 * the X+ line. If voltage of the X+ line reaches a specific level the IRQ will
28 * - rate limiting:
30 * - hrtimer:
60 * conversion has 12-bit resolution, whereas with this bit high, the next
61 * conversion has 8-bit resolution. This driver is optimized for 12-bit mode.
67 * SER/DFR - The SER/DFR bit controls the reference mode, either single-ended
74 * auto-wake/suspend mode. In most case this bits should stay zero.
101 * Data received from the controller. This field is empty for the TX
[all …]
/Linux-v6.6/arch/arm64/boot/dts/amd/
Damd-overdrive-rev-b0.dts1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-path = &serial0;
23 compatible = "arm,psci-0.2";
30 amd,zlib-support = <1>;
63 compatible = "mmc-spi-slot";
65 spi-max-frequency = <20000000>;
[all …]
Damd-overdrive-rev-b1.dts1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-path = &serial0;
23 compatible = "arm,psci-0.2";
30 amd,zlib-support = <1>;
75 compatible = "mmc-spi-slot";
77 spi-max-frequency = <20000000>;
[all …]
/Linux-v6.6/arch/arm/boot/dts/nxp/lpc/
Dlpc3250-phy3250.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * PHYTEC phyCORE-LPC3250 board
5 * Copyright (C) 2015-2019 Vladimir Zapolskiy <vz@mleia.com>
9 /dts-v1/;
13 model = "PHYTEC phyCORE-LPC3250 board based on NXP LPC3250";
22 compatible = "gpio-leds";
26 default-state = "off";
31 linux,default-trigger = "heartbeat";
37 power-supply = <&reg_lcd>;
41 remote-endpoint = <&cldc_output>;
[all …]
/Linux-v6.6/drivers/ps3/
Dps3-vuart.c1 // SPDX-License-Identifier: GPL-2.0-only
27 * vuart - An inter-partition data link service.
31 * The vuart provides a bi-directional byte stream data link between logical
63 * struct ps3_vuart_port_priv - private vuart device data.
86 BUG_ON(!dev->driver_priv); in to_port_priv()
87 return (struct ps3_vuart_port_priv *)dev->driver_priv; in to_port_priv()
91 * struct ports_bmp - bitmap indicating ports needing service.
106 pr_debug("%s:%d: ports_bmp: %016llxh\n", func, line, bmp->status); in _dump_ports_bmp()
143 struct vuart_triggers *trig) in ps3_vuart_get_triggers() argument
148 u64 tx; in ps3_vuart_get_triggers() local
[all …]
/Linux-v6.6/drivers/net/wireless/intel/iwlwifi/fw/api/
Dmac.h1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
3 * Copyright (C) 2012-2014, 2018-2022 Intel Corporation
11 * AUX indices follows - 1 for non-CDB, 2 for CDB.
31 * enum iwl_mac_protection_flags - MAC context flags
50 * enum iwl_mac_types - Supported MAC types
54 * @FW_MAC_TYPE_PIBSS: Pseudo-IBSS
78 * enum iwl_tsf_id - TSF hw timer ID
94 * struct iwl_mac_data_ap - configuration data for AP MAC context
117 * struct iwl_mac_data_ibss - configuration data for IBSS MAC context
133 * enum iwl_mac_data_policy - policy of the data path for this MAC
[all …]
/Linux-v6.6/net/mac80211/
Ddebugfs_sta.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright 2003-2005 Devicescape Software, Inc.
6 * Copyright 2013-2014 Intel Mobile Communications GmbH
8 * Copyright (C) 2018 - 2022 Intel Corporation
17 #include "driver-ops.h"
26 struct sta_info *sta = file->private_data; \
28 format_string, sta->field); \
90 char *end = buf + sizeof(buf) - 1; in sta_flags_read()
91 struct sta_info *sta = file->private_data; in sta_flags_read()
98 pos += scnprintf(pos, end - pos, "%s\n", in sta_flags_read()
[all …]
/Linux-v6.6/drivers/spi/
Dspi-pl022.c1 // SPDX-License-Identifier: GPL-2.0-or-later
5 * Copyright (C) 2008-2012 ST-Ericsson AB
11 * linux-2.6.17-rc3-mm1/drivers/spi/pxa2xx_spi.c
31 #include <linux/dma-mapping.h>
92 * SSP Control Register 0 - SSP_CR0
110 * SSP Control Register 0 - SSP_CR1
130 * SSP Status Register - SSP_SR
139 * SSP Clock Prescale Register - SSP_CPSR
144 * SSP Interrupt Mask Set/Clear Register - SSP_IMSC
152 * SSP Raw Interrupt Status Register - SSP_RIS
[all …]
/Linux-v6.6/drivers/net/ethernet/intel/igc/
Digc_ptp.c1 // SPDX-License-Identifier: GPL-2.0
26 struct igc_hw *hw = &adapter->hw; in igc_ptp_read()
33 ts->tv_sec = sec; in igc_ptp_read()
34 ts->tv_nsec = nsec; in igc_ptp_read()
40 struct igc_hw *hw = &adapter->hw; in igc_ptp_write_i225()
42 wr32(IGC_SYSTIML, ts->tv_nsec); in igc_ptp_write_i225()
43 wr32(IGC_SYSTIMH, ts->tv_sec); in igc_ptp_write_i225()
50 struct igc_hw *hw = &igc->hw; in igc_ptp_adjfine_i225()
57 scaled_ppm = -scaled_ppm; in igc_ptp_adjfine_i225()
79 spin_lock_irqsave(&igc->tmreg_lock, flags); in igc_ptp_adjtime_i225()
[all …]
/Linux-v6.6/arch/arm/boot/dts/qcom/
Dqcom-apq8060-dragonboard.dts1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 #include <dt-bindings/input/input.h>
3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/leds/common.h>
5 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
6 #include <dt-bindings/pinctrl/qcom,pmic-mpp.h>
7 #include "qcom-msm8660.dtsi"
11 compatible = "qcom,apq8060-dragonboard", "qcom,msm8660";
18 stdout-path = "serial0:115200n8";
22 vph: regulator-fixed {
[all …]
/Linux-v6.6/drivers/comedi/drivers/
Drtd520.c1 // SPDX-License-Identifier: GPL-2.0+
6 * COMEDI - Linux Control and Measurement Device Interface
13 * Devices: [Real Time Devices] DM7520HR-1 (DM7520), DM7520HR-8,
14 * PCI4520 (PCI4520), PCI4520-8
16 * Status: Works. Only tested on DM7520-8. Not SMP safe.
24 * The PCI4520 is a PCI card. The DM7520 is a PC/104-plus card.
40 * These boards can support external multiplexors and multi-board
46 * Call them and ask for the register level manual.
71 * Analog-In supports instruction and command mode.
73 * With DMA, you can sample at 1.15Mhz with 70% idle on a 400Mhz K6-2
[all …]
/Linux-v6.6/drivers/net/ethernet/broadcom/bnx2x/
Dbnx2x_reg.h3 * Copyright (c) 2007-2013 Broadcom Corporation
13 * R - Read only
14 * RC - Clear on read
15 * RW - Read/Write
16 * ST - Statistics register (clear on read)
17 * W - Write only
18 * WB - Wide bus register - the size is over 32 bits and it should be
20 * WR - Write Clear (write 1 to clear the bit)
32 /* [RW 1] Initiate the ATC array - reset all the valid bits */
56 * BRB1_IND_FREE_LIST_PRS_CRDT+2 initialize parser initial credit. Warning -
[all …]
/Linux-v6.6/drivers/media/platform/st/stm32/
Dstm32-dcmi.c1 // SPDX-License-Identifier: GPL-2.0
31 #include <media/v4l2-ctrls.h>
32 #include <media/v4l2-dev.h>
33 #include <media/v4l2-device.h>
34 #include <media/v4l2-event.h>
35 #include <media/v4l2-fwnode.h>
36 #include <media/v4l2-image-sizes.h>
37 #include <media/v4l2-ioctl.h>
38 #include <media/v4l2-rect.h>
39 #include <media/videobuf2-dma-contig.h>
[all …]
/Linux-v6.6/net/wireless/
Dnl80211.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * This is the new netlink-based wireless configuration interface.
5 * Copyright 2006-2010 Johannes Berg <johannes@sipsolutions.net>
6 * Copyright 2013-2014 Intel Mobile Communications GmbH
7 * Copyright 2015-2017 Intel Deutschland GmbH
8 * Copyright (C) 2018-2023 Intel Corporation
32 #include "rdev-ops.h"
50 NL80211_MCGRP_TESTMODE /* keep last - ifdef! */
74 int wiphy_idx = -1; in __cfg80211_wdev_from_attrs()
75 int ifidx = -1; in __cfg80211_wdev_from_attrs()
[all …]