Searched full:turned (Results 1 – 25 of 829) sorted by relevance
12345678910>>...34
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-platform-msi-laptop | 38 Contains either 0 or 1 and indicates if touchpad is turned on.
46 Contains either 0 or 1 and indicates if turbo mode is turned
59 Contains either 0 or 1 and indicates if ECO mode is turned on.
71 * 1 -> Turbo mode is on, cannot be turned off yet
72 * 2 -> Turbo mode is off, cannot be turned on yet
|
| D | sysfs-driver-altera-cvp | 7 error checking in altera-cvp driver is turned on or
|
| D | sysfs-devices-resource_in_use | 10 resource is not in use and therefore it has been turned off).
|
| D | sysfs-devices-power_resources_D0 | 10 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_resources_wakeup | 10 representing ACPI power resources that need to be turned on for
|
| /Linux-v5.10/drivers/infiniband/ulp/ipoib/ |
| D | Kconfig | 33 IPoIB driver. The output can be turned on via the
47 of the IPoIB driver. The output can be turned on via the
49 turned off, this debugging code will have some performance
|
| /Linux-v5.10/fs/xfs/libxfs/ |
| D | xfs_quota_defs.h | 73 * are in the process of getting turned off. These flags are in m_qflags but
76 #define XFS_UQUOTA_ACTIVE 0x1000 /* uquotas are being turned off */
77 #define XFS_GQUOTA_ACTIVE 0x2000 /* gquotas are being turned off */
78 #define XFS_PQUOTA_ACTIVE 0x4000 /* pquotas are being turned off */
|
| /Linux-v5.10/Documentation/devicetree/bindings/mmc/ |
| D | sdhci.txt | 10 turned off, before applying sdhci-caps.
13 bit is on in the property then the bit should be turned on.
|
| /Linux-v5.10/sound/ppc/ |
| D | Kconfig | 31 If this feature is enabled, DRC is turned off when the
32 headphone/line jack is plugged, and turned on when unplugged.
|
| /Linux-v5.10/arch/x86/kernel/cpu/ |
| D | feat_ctl.c | 31 * be turned on. The low bits contain the allowed-0 settings, i.e. in init_vmx_capabilities()
32 * features that can be turned off. Ignore the allowed-0 settings, in init_vmx_capabilities()
33 * if a feature can be turned on then it's supported. in init_vmx_capabilities()
|
| /Linux-v5.10/Documentation/networking/device_drivers/ethernet/dec/ |
| D | de4x5.rst | 84 kernel with the de4x5 configuration turned off and reboot.
136 (runs the service routine with interrupts turned off) vs. this card
137 which really needs to run the service routine with interrupts turned on.
186 examples. By default, full duplex is turned off and AUTO is the default
|
| /Linux-v5.10/arch/hexagon/mm/ |
| D | strnlen_user.S | 21 * The vector mask version of this turned out *really* badly.
22 * The hardware loop version also turned out *really* badly.
|
| /Linux-v5.10/Documentation/ABI/stable/ |
| D | sysfs-class-rfkill | 60 transmitter is turned off by software
93 The transmitter is turned off by software.
|
| /Linux-v5.10/drivers/thermal/ |
| D | gov_bang_bang.c | 94 * gets turned on.
96 * (trip_temp - hyst) so that the fan gets turned off again.
|
| /Linux-v5.10/include/drm/ |
| D | drm_audio_component.h | 21 * Request the power well to be turned on.
30 * Allow the power well to be turned off.
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | sht3x.rst | 83 - 0: turned off
84 - 1: turned on
|
| /Linux-v5.10/Documentation/infiniband/ |
| D | ipoib.rst | 64 Large Receive (LRO) offloading is also implemented and may be turned
84 turned on by setting the module parameters debug_level and
|
| /Linux-v5.10/fs/xfs/ |
| D | xfs_qm_syscalls.c | 147 * do a quotacheck the next time this quota is turned on. in xfs_qm_scall_quotaoff()
186 * quota type is in the process of being turned off. If *ACTIVE, it is in xfs_qm_scall_quotaoff()
199 * that quotas will not be turned off. This is handy because in a in xfs_qm_scall_quotaoff()
215 * according to what was turned off. in xfs_qm_scall_quotaoff()
238 * If all quotas are completely turned off, close shop. in xfs_qm_scall_quotaoff()
666 * gets turned off. No need to confuse the user level code, in xfs_qm_scall_getquota_fill_qc()
|
| /Linux-v5.10/include/linux/mfd/ |
| D | si476x-core.h | 57 * @SI476X_POWER_DOWN: In this state all regulators are turned off
61 * turned on, reset line pulled high, IRQ line is enabled(polling is
62 * active for polling use scenario) and device is turned on with
66 * not turned down and thus use of the device, without power-cycling
|
| /Linux-v5.10/drivers/usb/cdns3/ |
| D | drd.h | 136 /* Host mode is turned on. */
138 /* "Device mode is turned on .*/
|
| /Linux-v5.10/drivers/soc/renesas/ |
| D | rmobile-sysc.c | 237 * only be turned off if the CPU is not in use. in rmobile_setup_pm_domain()
252 * therefore it should only be turned off if the debug module in rmobile_setup_pm_domain()
262 * should only be turned off if memory is not in use. in rmobile_setup_pm_domain()
|
| /Linux-v5.10/drivers/phy/intel/ |
| D | phy-intel-keembay-emmc.c | 147 * We turned on the DLL even though the rate was 0 because we the in keembay_emmc_phy_power()
148 * clock might be turned on later. ...but we can't wait for the DLL in keembay_emmc_phy_power()
153 * is turned on, but for now we won't. in keembay_emmc_phy_power()
|
| /Linux-v5.10/Documentation/sound/cards/ |
| D | cmipci.rst | 32 As default it's turned on.
146 (441100 or 48000) and channels (2) are used. Otherwise it's turned
199 turned off so that non-audio data is heard from the analog line-out.
|
| /Linux-v5.10/drivers/phy/rockchip/ |
| D | phy-rockchip-emmc.c | 192 * We turned on the DLL even though the rate was 0 because we the in rockchip_emmc_phy_power()
193 * clock might be turned on later. ...but we can't wait for the DLL in rockchip_emmc_phy_power()
198 * is turned on, but for now we won't. in rockchip_emmc_phy_power()
|
| /Linux-v5.10/drivers/infiniband/hw/mthca/ |
| D | Kconfig | 16 mthca driver. The output can be turned on via the
|
12345678910>>...34
