Searched full:transceivers (Results 1 – 25 of 49) sorted by relevance
12
13 Lan966x has 7 interfaces, consisting of 2 copper transceivers(CU),22 CU(1) means use interface copper transceivers 1. SERDES6G(2) means use
69 This option enables support for CAN transceivers as a PHY. This70 driver provides function for putting the transceivers in various
3 * phy-can-transceiver.c - phy driver for CAN transceivers
107 Enable this to support some transceivers on OMAP1 platforms. OTG179 Enable this to support ULPI connected USB OTG transceivers which
25 * with internal transceivers. It can control a D+ pullup GPIO and
8 /* sometimes transceivers are accessed only through e.g. ULPI */
42 Enable this to support the High-Speed USB transceivers that are part
8 UART status lines for wakeup of UART transceivers to improve power management
50 primitives and transceivers
5 standard codecs, Sony/Phillips Digital Interface (S/PDIF) transceivers, and
254 /transceivers made by ITE Tech Inc. These are found in350 Transceivers.
3 * mdio.c: Generic support for MDIO-compatible transceivers14 MODULE_DESCRIPTION("Generic support for MDIO-compatible transceivers");
477 AT91_PIOD 21 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */487 AT91_PIOD 21 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */
6 /* Broadcom Cygnus SoC internal transceivers support. */
120 /* Enable energy detect mode for this SMSC Transceivers */ in smsc_phy_config_init()
71 2) 'SoftMAC' or just radio. These types of devices are just radio transceivers
3 * linux/mii.h: definitions for MII-compatible transceivers
27 of available transceivers. */
3 * linux/mdio.h: definitions for MDIO (clause 45) transceivers
110 /* boards can use OTG transceivers in non-OTG modes */ in ohci_omap_reset()
352 * transceivers that don't need any software attention to set up
411 * or optical transceivers, varying somewhat between in qt202x_phy_reconfigure()
71 * line cards), high system ambient temperature, unreliable transceivers temperature sensing or
409 pr_notice(" No MII transceivers found!\n"); in tc574_config()529 a few older transceivers. */
