Searched full:toggled (Results 1 – 25 of 129) sorted by relevance
123456
50 * via /sys/class/net/<dev>/flags. Flags which can be toggled through sysfs51 * are annotated below, note that only a few flags can be toggled and some59 * @IFF_UP: interface is up. Can be toggled through sysfs.61 * @IFF_DEBUG: turn on debugging. Can be toggled through sysfs.64 * @IFF_NOTRAILERS: avoid use of trailers. Can be toggled through sysfs.67 * @IFF_NOARP: no ARP protocol. Can be toggled through sysfs. Volatile.68 * @IFF_PROMISC: receive all packets. Can be toggled through sysfs.69 * @IFF_ALLMULTI: receive all multicast packets. Can be toggled through73 * @IFF_MULTICAST: Supports multicast. Can be toggled through sysfs.74 * @IFF_PORTSEL: can set media type. Can be toggled through sysfs.[all …]
80 ar->leds[i].toggled) { in carl9170_led_update()82 if (ar->leds[i].toggled) in carl9170_led_update()83 tmp = 70 + 200 / (ar->leds[i].toggled); in carl9170_led_update()89 ar->leds[i].toggled = 0; in carl9170_led_update()116 arl->toggled++; in carl9170_led_set_brightness()120 if (likely(IS_ACCEPTING_CMD(ar) && arl->toggled)) in carl9170_led_set_brightness()158 ar->leds[i].toggled = 0; in carl9170_led_unregister()
39 if (priv->leds[i].toggled) { in p54_update_leds()42 tmp = 70 + 200 / (priv->leds[i].toggled); in p54_update_leds()49 priv->leds[i].toggled = in p54_update_leds()76 led->toggled++; in p54_led_brightness_set()152 priv->leds[i].toggled = 0; in p54_unregister_leds()
151 unsigned int toggled; member
39 Touchpad state can only be toggled by pressing Fn+F3.62 power. ECO mode can only be toggled by pressing Fn+F10.82 toggled in software.
67 can be toggled to boot with only the dGPU (discrete mode) or in
9 The debugging output can additionally be toggled by setting the45 The debugging output can additionally be toggled by setting the
31 bool test_sockmap = false; /* toggled by user-space */32 bool test_ingress = false; /* toggled by user-space */
96 # buck voltages to not be toggled by HW state. Enable status may still97 # be toggled by state changes depending on HW default settings.
38 When compiling DCCP as a module, this debugging output can be toggled
27 GPIOs, so they can be toggled manually.
37 InsKeyPad-Enter Shut Up (until toggled back on).
26 * switch is toggled. KE_VSW switches ignore this field and
47 * Flag indicating the preloader widget only needs power toggled
91 description: INOK signal is fixed and polarity needs to be toggled
23 * that must be toggled for the corresponding actions on the EEProm
149 * MCS_CPM_TX_SLAVE_SA_MAP_MEM_0X[sc].tx_sa_active bit gets toggled if
444 * turn the lcd off/on. Can be toggled after lcd is initialized without in treo680_gpio_init()455 * If either of these are toggled after the lcd is initialized, the in treo680_gpio_init()
235 * key used to determine initialisation must be toggled prior to in handle_host_hcall()
216 milliseconds will be observed after the phy-reset-gpios has been toggled.
39 * 0x61 - LED related? Always toggled BIT0
134 * as toggled by user, even though it does not honor it. in d7s_ioctl()
300 * toggled by GPIO pins.
9 * in kvm_run.s.regs when kvm_valid_regs and kvm_dirty_regs are toggled.
1743 * orig, has toggled then this method updates the counter and the list1789 * toggled then this method updates the counter and the list accordingly.1834 * toggled then this method updates the counter and the list accordingly.1879 * toggled then this method updates the counter and the list accordingly.1924 * toggled then this method updates the counter and the list accordingly.
