Searched full:thermistors (Results 1 – 19 of 19) sorted by relevance
| /Linux-v6.6/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 4 Supported thermistors from Murata:
6 * Murata NTC Thermistors NCP15WB473, NCP18WB473, NCP21WB473, NCP03WB473,
14 Supported thermistors from EPCOS:
16 * EPCOS NTC Thermistors B57330V2103
22 Other NTC thermistors can be supported simply by adding compensation
|
| D | pc87360.rst | 134 thermistors (as opposed to thermal diodes for the first three temperature
146 thermal diode, and thermistors).
|
| D | max6697.rst | 77 thermal transistors plus three thermistors in addition to the local temperature
|
| D | w83793.rst | 61 Temp5-6 can be connected to external thermistors (value of
|
| D | it87.rst | 383 If a temperature sensor is configured for thermistors, the attribute values
|
| D | vt1211.rst | 152 Temp3-temp7 support NTC thermistors. For these channels, the driver returns
|
| D | sysfs-interface.rst | 303 Some chips measure temperature using external thermistors and an ADC, and
|
| /Linux-v6.6/arch/arm/boot/dts/ |
| D | cros-adc-thermistors.dtsi | 3 * Thermistor dts fragment for devices that use Thermistors as
|
| /Linux-v6.6/Documentation/devicetree/bindings/thermal/ |
| D | generic-adc-thermal.yaml | 13 On some of platforms, thermal sensor like thermistors are connected to
|
| /Linux-v6.6/Documentation/devicetree/bindings/hwmon/ |
| D | ntc-thermistor.yaml | 12 Thermistors with negative temperature coefficient (NTC) are resistors that
|
| /Linux-v6.6/Documentation/devicetree/bindings/iio/temperature/ |
| D | adi,ltc2983.yaml | 342 Used for digitizing custom thermistors.
355 custom thermistors.
|
| /Linux-v6.6/drivers/hwmon/ |
| D | ntc_thermistor.c | 3 * ntc_thermistor.c - NTC Thermistors
70 * Thermistors Datasheet
221 * Thermistors Datasheets
|
| D | pc87360.c | 675 * used in the chip to measure voltage across the thermistors
1335 dev_dbg(&pdev->dev, "bios thermistors:%d\n", use_thermistors); in pc87360_init_device()
1340 /* thermistors are temp[4-6], measured on vin[11-14] */ in pc87360_init_device()
1343 dev_dbg(&pdev->dev, "using thermistors:%d\n", use_thermistors); in pc87360_init_device()
1676 /* Are we using thermistors? */ in pc87360_find()
1687 pr_info("Using thermistors for temperature monitoring\n"); in pc87360_find()
|
| D | Kconfig | 1521 This driver supports NTC thermistors sensor reading and its
|
| /Linux-v6.6/arch/arm/boot/dts/st/ |
| D | ste-hrefv60plus.dtsi | 50 * Thermistors on the board, formally to monitor battery temperatures
|
| /Linux-v6.6/drivers/iio/adc/ |
| D | Kconfig | 955 power, on board system thermistors connected to the PMIC ADC,
958 hardware supports internal pull-up for thermistors and can choose between
|
| D | qcom-pm8xxx-xoadc.c | 169 * thermistors are connected or other hardware characteristics are
|
| /Linux-v6.6/arch/arm/boot/dts/samsung/ |
| D | exynos5420-peach-pit.dts | 1126 #include "../cros-adc-thermistors.dtsi"
|
| D | exynos5800-peach-pi.dts | 1108 #include "../cros-adc-thermistors.dtsi"
|
