| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-platform-ideapad-laptop | 27 * 1 -> Switched On
28 * 0 -> Switched Off
37 * 1 -> Switched On
38 * 0 -> Switched Off
|
| D | sysfs-driver-hid-logitech-lg4ff | 23 If a wheel cannot be switched into the desired mode, -EINVAL
64 alternate mode the wheel might be switched to.
|
| /Linux-v5.10/drivers/staging/olpc_dcon/ |
| D | olpc_dcon.c | 282 dcon->switched = false; in dcon_source_switch()
293 wait_event_timeout(dcon->waitq, dcon->switched, HZ); in dcon_source_switch()
295 if (!dcon->switched) in dcon_source_switch()
332 wait_event_timeout(dcon->waitq, dcon->switched, HZ / 2); in dcon_source_switch()
334 if (!dcon->switched) { in dcon_source_switch()
349 if (dcon->switched && ktime_to_ns(delta_t) in dcon_source_switch()
741 dcon->switched = true; in dcon_interrupt()
754 if (dcon->curr_src != dcon->pending_src && !dcon->switched) { in dcon_interrupt()
755 dcon->switched = true; in dcon_interrupt()
|
| /Linux-v5.10/Documentation/devicetree/bindings/clock/ |
| D | clock-bindings.txt | 110 clock-output-names = "pll", "pll-switched";
114 * and the high frequency switched PLL output for register
131 ("pll" and "pll-switched").
133 register clock connected to the PLL clock (the "pll-switched" signal)
|
| /Linux-v5.10/Documentation/ABI/obsolete/ |
| D | sysfs-driver-hid-roccat-kovaplus | 65 Description: The mouse can store 5 profiles which can be switched by the
80 Description: The mouse can store 5 profiles which can be switched by the
92 Description: The mouse can store 5 profiles which can be switched by the
108 Description: The mouse can store 5 profiles which can be switched by the
|
| D | sysfs-driver-hid-roccat-pyra | 54 Description: The mouse can store 5 profiles which can be switched by the
69 Description: The mouse can store 5 profiles which can be switched by the
81 Description: The mouse can store 5 profiles which can be switched by the
97 Description: The mouse can store 5 profiles which can be switched by the
|
| D | sysfs-driver-hid-roccat-savu | 4 Description: The mouse can store 5 profiles which can be switched by the
28 Description: The mouse can store 5 profiles which can be switched by the
62 Description: The mouse can store 5 profiles which can be switched by the
|
| D | sysfs-driver-hid-roccat-koneplus | 58 Description: The mouse can store 5 profiles which can be switched by the
73 Description: The mouse can store 5 profiles which can be switched by the
85 Description: The mouse can store 5 profiles which can be switched by the
101 Description: The mouse can store 5 profiles which can be switched by the
|
| D | sysfs-driver-hid-roccat-konepure | 4 Description: The mouse can store 5 profiles which can be switched by the
43 Description: The mouse can store 5 profiles which can be switched by the
58 Description: The mouse can store 5 profiles which can be switched by the
|
| /Linux-v5.10/Documentation/driver-api/media/ |
| D | rc-core.rst | 32 carrier. The carrier can be switched on or off by the IR transmitter
33 hardware. When the carrier is switched on, it is called *PULSE*.
34 When the carrier is switched off, it is called *SPACE*.
|
| /Linux-v5.10/drivers/gpu/drm/i915/ |
| D | i915_switcheroo.c | 23 drm_info(&i915->drm, "switched on\n"); in i915_switcheroo_set_state()
30 drm_info(&i915->drm, "switched off\n"); in i915_switcheroo_set_state()
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/proximity/ |
| D | parallax-ping.yaml | 15 - direction of ping-gpio is then switched into input with an interrupt
32 should initiate the measurement cycle. Afterwards the GPIO is switched
|
| D | devantech-srf04.yaml | 59 When the device gets suspended it's switched off and when it resumes
60 it's switched on again. After some period of inactivity the driver
|
| /Linux-v5.10/drivers/platform/x86/ |
| D | mxm-wmi.c | 49 printk("mux switched %d\n", status); in mxm_wmi_call_mxds()
74 printk("mux mutex set switched %d\n", status); in mxm_wmi_call_mxmx()
|
| /Linux-v5.10/Documentation/admin-guide/ |
| D | rapidio.rst | 10 RapidIO is a high speed switched fabric interconnect with features aimed
12 as well as message-based transactions over the switched fabric network.
|
| /Linux-v5.10/arch/arm64/kvm/hyp/vhe/ |
| D | sysreg-sr.c | 21 * tpidr_el0 and tpidrro_el0 only need to be switched when going
23 * switched when potentially going to run a different VCPU. The latter two
|
| /Linux-v5.10/drivers/gpu/drm/nouveau/ |
| D | nouveau_vga.c | 45 pr_err("VGA switcheroo: switched nouveau on\n"); in nouveau_switcheroo_set_state()
50 pr_err("VGA switcheroo: switched nouveau off\n"); in nouveau_switcheroo_set_state()
|
| /Linux-v5.10/drivers/usb/misc/ |
| D | usb4604.c | 53 dev_dbg(dev, "switched to HUB mode\n"); in usb4604_connect()
70 dev_dbg(dev, "switched to STANDBY mode\n"); in usb4604_switch_mode()
|
| /Linux-v5.10/drivers/gpio/ |
| D | gpio-vx855.c | 137 /* True GPI cannot be switched to output mode */ in vx855gpio_set()
161 /* True GPI cannot be switched to output mode */ in vx855gpio_direction_output()
165 /* True GPO don't need to be switched to output mode, in vx855gpio_direction_output()
|
| /Linux-v5.10/arch/arc/include/asm/ |
| D | entry-compact.h | 8 * if we are NOT in user mode, stack is switched to kernel mode.
58 * 2. L1 IRQ taken, ISR starts (CPU auto-switched to KERNEL mode)
62 * not switched.
156 /* U/K mode at time of exception (stack not switched if already K) */
|
| /Linux-v5.10/kernel/livepatch/ |
| D | transition.c | 291 /* check if this task has already switched over */ in klp_try_switch_task()
384 * switched yet.
401 * is deemed unreliable, the task can't be switched yet. in klp_try_complete_transition()
422 /* offline idle tasks can be switched immediately */ in klp_try_complete_transition()
435 * Some tasks weren't able to be switched over. Try again in klp_try_complete_transition()
|
| /Linux-v5.10/arch/x86/kvm/svm/ |
| D | vmenter.S | 10 /* Intentionally omit RAX as it's context switched by hardware */
14 /* Intentionally omit RSP as it's context switched by hardware */
|
| /Linux-v5.10/Documentation/x86/ |
| D | entry_64.rst | 62 not switched/swapped yet.
91 base has already been switched. If it says that we interrupted
|
| /Linux-v5.10/drivers/gpu/vga/ |
| D | vga_switcheroo.c | 80 * The GPU to which the outputs are currently switched is called the
87 * switched to it, provided that the handler supports this. Switching
102 * @active: whether the outputs are currently switched to this client
143 * (in particular while DDC lines are temporarily switched)
144 * @old_ddc_owner: client to which DDC lines will be switched back on unlock
545 * (but leave the outputs otherwise switched to where they are).
547 * afterwards be switched back by calling vga_switcheroo_unlock_ddc(),
989 * On muxed machines, if the mux is initially switched to the discrete GPU,
|
| /Linux-v5.10/Documentation/sound/hd-audio/ |
| D | controls.rst | 68 mic-in) are switched as the surround and the CLFE output jacks.
74 side or a CLFE-channel DAC, the DAC is switched to the headphone
|
