| /Linux-v5.4/arch/sparc/kernel/ |
| D | adi_64.c | 18 * pages. When ADI enabled pages are being swapped out, it would be
106 * swapped out in mdesc_adi_init()
229 * being swapped out, there is high probability subsequent pages in alloc_tag_store()
230 * in the VMA will be swapped out as well. Allocate pages to in alloc_tag_store()
324 /* Retrieve any saved ADI tags for the page being swapped back in and
334 /* Check if the swapped out page has an ADI version in adi_restore_tags()
361 * the swapped in page was the last user of tag space in adi_restore_tags()
366 /* A page is about to be swapped out. Save any ADI tags associated with
367 * this physical page so they can be restored later when the page is swapped
|
| /Linux-v5.4/Documentation/devicetree/bindings/input/touchscreen/ |
| D | chipone_icn8318.txt | 21 - touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
40 touchscreen-swapped-x-y;
|
| D | exc3000.txt | 13 - touchscreen-swapped-x-y: See touchscreen.txt
25 touchscreen-swapped-x-y;
|
| D | silead_gsl1680.txt | 22 - touchscreen-swapped-x-y : See touchscreen.txt
41 touchscreen-swapped-x-y;
|
| D | touchscreen.txt | 27 - touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
|
| D | ad7879.txt | 13 - touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
|
| /Linux-v5.4/drivers/platform/x86/ |
| D | touchscreen_dmi.c | 29 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
43 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
59 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
76 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
111 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
161 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
177 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
255 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
273 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
318 PROPERTY_ENTRY_BOOL("touchscreen-swapped-x-y"),
[all …]
|
| /Linux-v5.4/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-zii-ultra-rmb3.dts | 57 touchscreen-swapped-x-y;
64 touchscreen-swapped-x-y;
77 touchscreen-swapped-x-y;
|
| /Linux-v5.4/Documentation/vm/ |
| D | swap_numa.rst | 19 to be swapped on. Simply swapping them on by doing::
26 that the order of them being swapped on doesn't matter.
29 be swapped on: swapA and swapB are attached to node 0, swapC is attached to
|
| D | zswap.rst | 11 in the process of being swapped out and attempts to compress them into a
47 being swapped out. However, it will _not_ immediately write out or fault
52 fault back into memory all swapped out pages, including those in the
|
| /Linux-v5.4/arch/sh/include/asm/ |
| D | pgtable_64.h | 96 swapped out. Only the _PAGE_PRESENT flag is significant when the page is
97 swapped out, and it must be placed so that it doesn't overlap either the
216 is present. bit[2]==1 => present, bit[2]==0 => swapped out. If swapped
218 left for us to select. If we force bit[7]==0 when swapped out, we could use
220 we force bit[7]==1 when swapped out, we can use all zeroes to indicate
|
| /Linux-v5.4/sound/firewire/dice/ |
| D | dice-interface.h | 17 * (e.g. strings) get scrambled and must be byte-swapped again by the driver.
78 * bytes. Quadlets are byte-swapped. The encoding is whatever the host driver
216 * Names of all clock sources; read-only. Quadlets are byte-swapped. Names
265 * Names of all audio channels; read-only. Quadlets are byte-swapped. Names
328 * Names of all audio channels; read-only. Quadlets are byte-swapped. Names
|
| /Linux-v5.4/drivers/media/platform/ |
| D | renesas-ceu.c | 123 * @fmt_order_swap: swapped CEU_CAMCR.DTARY ordering of input components
125 * @swapped: does Cr appear before Cb?
133 bool swapped; member
382 * If the memory output planar format is 'swapped' (Cr before Cb) and in ceu_hw_config()
383 * input format is not, use the swapped version of CAMCR.DTARY. in ceu_hw_config()
385 * If the memory output planar format is not 'swapped' (Cb before Cr) in ceu_hw_config()
386 * and input format is, use the swapped version of CAMCR.DTARY. in ceu_hw_config()
405 /* Non-swapped planar image capture mode. */ in ceu_hw_config()
410 if (mbus_fmt->swapped) in ceu_hw_config()
419 /* Swapped planar image capture mode. */ in ceu_hw_config()
[all …]
|
| /Linux-v5.4/arch/mips/alchemy/devboards/ |
| D | platform.c | 170 int swapped) in db1x_register_norflash() argument
207 if (!swapped) { in db1x_register_norflash()
237 if (swapped) { in db1x_register_norflash()
|
| D | platform.h | 20 int swapped);
|
| /Linux-v5.4/Documentation/devicetree/bindings/net/dsa/ |
| D | mt7530.txt | 56 Only works on platform where external phy TX<->RX lines are swapped.
63 2. swapped: RGMII TX, RX are swapped; external phy interface with the switch as
|
| /Linux-v5.4/Documentation/admin-guide/mm/ |
| D | pagemap.rst | 19 * Bits 0-4 swap type if swapped
20 * Bits 5-54 swap offset if swapped
26 * Bit 62 page swapped
|
| /Linux-v5.4/include/uapi/linux/ |
| D | virtio_balloon.h | 56 #define VIRTIO_BALLOON_S_SWAP_IN 0 /* Amount of memory swapped in */
57 #define VIRTIO_BALLOON_S_SWAP_OUT 1 /* Amount of memory swapped out */
|
| /Linux-v5.4/arch/mips/cavium-octeon/ |
| D | octeon-platform.c | 302 ehci_ctl.s.l2c_buff_emod = 1; /* Byte swapped. */ in octeon_ehci_hw_start()
303 ehci_ctl.s.l2c_desc_emod = 1; /* Byte swapped. */ in octeon_ehci_hw_start()
305 ehci_ctl.s.l2c_buff_emod = 0; /* not swapped. */ in octeon_ehci_hw_start()
306 ehci_ctl.s.l2c_desc_emod = 0; /* not swapped. */ in octeon_ehci_hw_start()
365 ohci_ctl.s.l2c_buff_emod = 1; /* Byte swapped. */ in octeon_ohci_hw_start()
366 ohci_ctl.s.l2c_desc_emod = 1; /* Byte swapped. */ in octeon_ohci_hw_start()
368 ohci_ctl.s.l2c_buff_emod = 0; /* not swapped. */ in octeon_ohci_hw_start()
369 ohci_ctl.s.l2c_desc_emod = 0; /* not swapped. */ in octeon_ohci_hw_start()
|
| /Linux-v5.4/arch/arm/kvm/ |
| D | coproc.c | 384 /* CSSELR: swapped by interrupt.S. */
392 /* CPACR: swapped by interrupt.S. */
396 /* TTBR0/TTBR1/TTBCR: swapped by interrupt.S. */
407 /* DACR: swapped by interrupt.S. */
411 /* DFSR/IFSR/ADFSR/AIFSR: swapped by interrupt.S. */
421 /* DFAR/IFAR: swapped by interrupt.S. */
427 /* PAR swapped by interrupt.S */
460 /* PRRR/NMRR (aka MAIR0/MAIR1): swapped by interrupt.S. */
466 /* AMAIR0/AMAIR1: swapped by interrupt.S. */
475 /* VBAR: swapped by interrupt.S. */
[all …]
|
| /Linux-v5.4/arch/s390/appldata/ |
| D | appldata_mem.c | 47 u64 pswpin; /* pages swapped in */
48 u64 pswpout; /* pages swapped out */
|
| /Linux-v5.4/drivers/media/platform/vsp1/ |
| D | vsp1_pipe.h | 30 * @swap_yc: the Y and C components are swapped (Y comes before C)
31 * @swap_uv: the U and V components are swapped (V comes before U)
|
| /Linux-v5.4/drivers/mtd/parsers/ |
| D | redboot.c | 132 * a byte swapped FIS directory - swap all the entries! in parse_redboot_partitions()
139 we assume wrong-endian if either the swapped in parse_redboot_partitions()
141 or if the swapped size actually fits in an in parse_redboot_partitions()
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | exynos4412-i9305.dts | 18 /* SCL and SDA pins are swapped */
|
| /Linux-v5.4/mm/ |
| D | shmem.c | 296 * But normally info->alloced == inode->i_mapping->nrpages + info->swapped
297 * So mm freed is info->alloced - (inode->i_mapping->nrpages + info->swapped)
306 freed = info->alloced - info->swapped - inode->i_mapping->nrpages; in shmem_recalc_inode()
697 * given offsets are swapped out.
707 unsigned long swapped = 0; in shmem_partial_swap_usage() local
714 swapped++; in shmem_partial_swap_usage()
724 return swapped << PAGE_SHIFT; in shmem_partial_swap_usage()
729 * given vma is swapped out.
739 unsigned long swapped; in shmem_swap_usage() local
742 swapped = READ_ONCE(info->swapped); in shmem_swap_usage()
[all …]
|
